29/07/2020 6
6.3 Switch bracket seng..................................................................................................29
6.4 Bracket force seng ....................................................................................................29
6.5 Funnel ap locking.......................................................................................................29
6.6 Material entry and operaon .......................................................................................30
6.7 Operaon....................................................................................................................31
6.8 Noise emissions........................................................................................................... 31
6.9 Blockages ....................................................................................................................32
6.10 Transport posion .......................................................................................................32
6.11 Cleaning the machine................................................................................................... 32
6.12 ABS-System .................................................................................................................33
7MAINTENANCE AND REPAIR................................................................................................34
7.1 Maintenance for wood shredders.................................................................................35
7.2 Checking the screws.....................................................................................................37
7.3 Ball bearings................................................................................................................ 37
7.4 V-belts.........................................................................................................................37
7.5 Hacking blades and counterblades ............................................................................... 38
7.6 Grinding instrucons....................................................................................................41
8LUBRICATION PLAN............................................................................................................. 42
8.1 GM 10 M Pull & Push or WS 10-14 SP ...........................................................................42
8.2 GM 10 M 80km/h or WS 10-14 P ..................................................................................43
8.3 150 M or WS 15-27 P....................................................................................................44
8.4 170/190 M or WS 18-35 D ............................................................................................45
8.5 250M or WS 18-35 DT ..................................................................................................46
8.6 350/450 M................................................................................................................... 47
8.7 550 M.......................................................................................................................... 48
8.8 Z-machines ..................................................................................................................49
