1. Mounting and connection
1.1 Mount the RA410v2 on a 35 mm DIN-rail.
1.2 Connect cables to audio output (check polarity) and power supply.
💡
Trigger voltage: 5-24V
⚠
Warning: wrong polarity may damage the device! Double check power cable polarity before connecting!
Further documentation and troubleshooting
Please visit also our website for the latest documentation, videos and information:
https://www.trivum.com
https://service.trivum.com
If support is needed
Please contact your local trivum dealer or write to:
trivum Apps (iOS, Android, Web)
https://trivum.de/apps
trivum technologies GmbH
Eierstraße 48
70199 Stuttgart
www.trivum.com
Trigger input
So that the amplier is not always switched on, it is possible to use the trigger input to control on/o. A DIP switch is used to
set whether the trigger input should be used.
0-10V input
The volume can be adjusted with a 0-10V signal. If variable volume is not desired, the RA410v2 will operate at 100% in standard
mode. The RA410v2 supplies 10V at one connection in order to use a simple potentiometer to control the volume.
0-10V signals from e.g. SmartHome control systems can also be used, or the output of a 0-10V KNX dimming actuator.
Balance and Volume control via built-in potentiometer
Two built-in small potentiometers allow you to adjust the level of the 2 amplier channels. This enables a balance setting - and
also the limitation of the maximum volume.
2 DIP switches for conguration
You can congure the amplier with the 2 DIP switches.
Amplier
The digital stereo amplier delivers 2x40 watt at 8 ohms. It can drive a minimum of 4 ohm loads. This also allows you to oper-
ate a several 8 ohm loudspeakers in parallel on one output.
Thanks to the digital power amplier, the amplier develops little heat and is therefore suitable for DIN rail mounting. Never-
theless, it is advisable to ventilate the control cabinet suciently.
Vol.Bal. ModeLine-InControl
Mode 2
Mode 3+4
#Mode Description
• Always on - device is permanently active.
2• trigger works as on/o
• 0-10V will be ignored
3• 0-10V is active
• the trigger is active
4• trigger will be ignored.
• volume can be controlled with dimmer or other device.
• 0-10V input is used for trigger and volume
• 0-1V is o / 1-10V is on
2. Operating modes
There are four dierent modes to operate the RA410:
Analog audio input
The music source is connected via a 3.5mm jack plug. By www.trivum.com we also oer adapters to connect other plugs or
free cable ends to the 3.5mm jack socket.
