Triminator Shredmaster Manual de usuario
®
SHREDMaster
OWNER'S MANUAL v1
Congratulations on your selection of a Triminator ShredMaster. We want to help
you to get the best results from your new shredder and to operate it safely. This
manual contains the information on how to do that; please read it carefully before
you set up and use your machine. This manual is intended for all ShredMaster
component please disregard information relating to the omitted component.
530-265-4277
THIS OWNER’S MANUAL IS CONSIDERED A PERMANENT PART OF
THE MACHINE AND SHOULD REMAIN WITH THE SHREDDER IF RE-
SOLD. THE INFORMATION AND SPECIFICATIONS INCLUDED IN THIS
PUBLICATION ARE THOSE THAT WERE IN EFFECT AT THE TIME OF
APPROVAL FOR PRINTING. MOSMAN MACHINERY COMPANY, INC.
RESERVES THE RIGHT, HOWEVER, TO DISCONTINUE OR CHANGE
!
NOTICE
1
CONTENTS
........................................... 2
........................................ 2
...................................................... 3
................................................ 4
........................................................... 5
.......................................... 5
................................ 6
..................................... 8
................................................... 9
.......................................................12
..................................................12
..........................................12
.........................................13
2
UNLOADING/UNPACKING
ELECTRICAL INSTALLATION
•
1. All internal wiring has been factory installed and tested prior to shipping. Electrical
2.
the machine. Record the nameplate information in the space below.
3.
4.
5.
6.
7.
complete.
8. Replace all guards.
ATTENTION
!
WARNING
LOCK OUT POWER IN OFF POSITION
3
SAFETY WARNINGS
!
• Read and understand instruction manual and be aware of all warning stickers.
•
EXCEPT
• ALWAYS know where emergency stop buttons are located.
• ALWAYS
• ALWAYS ensure that all maintenance and operating personnel read and understand this
• ALWAYS
suggested.
• ALWAYS wear safety glasses when operating shredder.
• ALWAYS
• NEVER
medications.
• NEVER
• NEVER
• NEVER place any part of your body in or on any part of this machine while in operation.
• NEVER
top of the machine.
• NEVER
stop.
• NEVER allow other personnel within ten feet of this machine while in operation.
• NEVER
out power disconnect or unplugging the machine.
• NEVER allow horseplay around machine.
• NEVER
• NEVER
toward cutter head.
• NEVER hold forward button in the depressed position.
4
START-UP PROCEDURE
PRE-START-UP PROCEDURE
•
• Ensure the area is clean.
•
START-UP
forward.
experience the operator may wish to increase the amount of material being fed. The
5
CLEARING A JAM
SHUT-DOWN PROCEDURE
1. Ensure that all personnel are clear of both the input chute and the cutter head.
2.
3.
4. Lock Out Power,
5.
1.
2.
3. Clean any remaining debris from the machine and from the immediate area.
NEVER
to the machine and the electrical system could occur.
!
WARNING
6
MAINTENANCE & LUBRICATION
WEEKLY - EVERY 40 HOURS OF OPERATION
•
applicable.
•
MONTHLY - EVERY 160 HOURS OF OPERATION
•
bearing.
•
•
•
needed.
•
•
ANNUAL LUBRICATION
(Minimum of 200 hours of use, Maximum of 500hrs)
• Repeat steps from monthly lubrication.
•
ALWAYS lock o
!
WARNING
7
LUBE SCHEDULE
ITEM LUBE FREQUENCY TYPE LUBE
Cycloidal Reducer
Oil Less than1 gallon total
Chain Monthly Monthly
Spur Gears Monthly
Main Roller Bearings
8
8
CUTTER STACK ADJUSTMENT
Cutter Stack tightness is factory set and should be checked if any of the following
conditions exist:
• Shred capacity drops noticeably.
• Cutter Head becomes abnormally hot.
• Unusual noise being generated from cutter head.
• Noticeably large gap between two cutters.
1.
2.
3.
shafts. Securely tighten any that are loose.
4.
!
NOTICE
Locked out and Tagged out before starting
any work on the machine.
CUTTERS MUST BE AT ROOM TEMPERATURE WHEN MAKING
ADJUSTMENTS.
!
WARNING
Tabla de contenidos
Manuales populares de Trituradora de papel de otras marcas
Swingline
Swingline STACK-AND-SHRED200X&200XL 60X Manual de instrucciones
GBC
GBC ShredMaster CC055 Manual de usuario
UNITED OFFICE
UNITED OFFICE UAV 190 A1 Manual de usuario
UNITED OFFICE
UNITED OFFICE UAV 190 A1 Manual de usuario
Rexel
Rexel Optimum AutoFeed+ 45X Manual de usuario
Martin Yale
Martin Yale 227284S1 Manual de usuario
