TriMark e-ASK Manual de usuario
e-ASK
electronic Access Security Keyless-entry
CAN Multiplex System
CAN Multiplex System
Consumer Manual
(UM25 ~ 24324-01)
Table of Contents
Introduction ................................................................................... 1
e-FOB Operation and Features - Standard Mode ...................... 2
e-FOB Operation and Features - Cargo Mode ........................... 3
Standard e-PAD Operation and Features ................................... 4
Locking Doors With Keypad ....................................................... 4
Secure Operations ..................................................................... 4
Doorbell e-PAD Operation and Features .................................... 5
Locking Doors With Keypad ....................................................... 5
Doorbell Operation ..................................................................... 5
Secure Operations ..................................................................... 5
e-PAD Configuration ................................................................ 6
Keypad Setting Configurations ................................................... 6
Optional Keyless Entry System Features .................................. 7
Dome/Porch Light Activation ...................................................... 7
e-GRAB Handle Lighting ........................................................... 7
Door Ajar Warning ...................................................................... 7
Lock and Unlock Confirmation ................................................... 7
e-PAD Protective Deactivation Feature ..................................... 7
Deactivate Lock Confirmation .................................................... 8
Alarm .......................................................................................... 8
Compartment Light Activation .................................................... 9
Auxiliary 1 Output Activation ...................................................... 9
Teaching Additional Transmitter FOBs ...................................... 9
Teaching Keypad New Authority/Access Codes ...................... 11
Assign New Access Codes ........................................................ 12
Troubleshooting ...........................................................................
14
About the “Yellow Programming Wire” ....................................... 14
CAN Error Diagnostic Codes ..................................................... 15
More eASK Hints ....................................................................... 16
Warrenty Information ................................................................. 17
Appendix A: Installation and Application Notes ..................... I
General Mounting Guidelines .................................................... I
Appendix B: Available e-PAD Configurations .......................... II
Non-doorbell .............................................................................. II
Doorbell ..................................................................................... III
TriMark CAN RF Controller
Introduction
This manual provides the necessary information for the proper use of
TriMark’s CAN e-ASK system.
The RF controller and FOB transmitters are shipped programmed.
After following installation instructions as shown in this manual, the
system will function as described.
Note: Some features discussed in this manual may not be available on
your vehicle’s installation. Consult with your dealer for more
information about features specific to your vehicle.
1
CAN-enabled
e-GRAB Handle
CAN-enabled Keypad —
available vertical or horizontal
e-FOB Operation and Features - Standard Mode
Button Function
Lock Locks doors and arms security system.
Unlock Unlocks doors and disarms security system. Also
activates the dome light.
Panic Activates panic mode when pressed and held for 2
seconds.
* Auxiliary
Button
Auxiliary output. Possible assignment includes: interior/
exterior lighting, awning extension/retraction, gas cap
release, hood release, etc.
Panic button
Unlock button
* Auxiliary button
Lock button
Note:
Only the unlocking function of the e-FOB remains while the
system detects that the engine is running—other functions are
deactivated.
2
e-FOB Operation and Features - Cargo Mode
Button Function
Entry Lock Locks entry door and arms security system.
Entry Unlock Unlocks entry door and disarms security system.
Also activates the dome light.
Cargo Lock Locks cargo doors and arms security system.
Cargo Unlock Unlocks cargo doors and disarms security system.
Also activates compartment lights.
Note:
Only the unlocking function of the e-FOB remains while the
system detects that the engine is running—other functions are
deactivated.
Cargo Lock
Entry Unlock
Cargo Unlock
Entry Lock
3
Standard e-PAD Operation and Features
The e-PAD is shipped with default Authority and Access Codes. If the
OEM or dealer has not changed the default codes, the Authority and
Access Codes are:
Access code:
Authority code:
Locking Doors With Keypad
Press and hold down the (1 / 2) button for 1-2 seconds.
An Access Code is not needed to lock the doors.
Secure Operations
Entering a valid 5-digit Access Code provides a double-beep and
enables a secure operation. After entering an Access Code, the
keypad is enabled for 5 seconds and the next button pressed initiates
a secure operation, such as unlocking the doors.
Notes:
The Authority Code does not allow for secure operations. It is
only used to assign access codes (see page 12 for information
on setting access codes).
If an unassigned button is pressed, or no button is pressed,
within 5 seconds of a correctly entered Access Code, the
keypad reverts back to disabled state.
If the keypad does not Double-beep after the 5th digit of your
entered Access Code, then you have not entered the correct
Access Code.
The secure keypad operations are set depending on the system
configuration. See page 6 for more information.
Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
1 / 2 3 / 4 5 / 6 7 / 8 9 / 0
Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
7 / 8 7 / 8 7 / 8 7 / 8 7 / 8
4
Doorbell e-PAD Operation and Features
Access code:
Authority code:
Locking Doors With Keypad
Press and hold down the (1) button for 1-2 seconds. An
Access Code is not needed to lock the doors.
Door Bell Operation
The doorbell button sends a CAN message to the RF Controller
instantly when pressed. An Access Code is not necessary for the
doorbell.
Secure Operations
Entering a valid 5-digit Access Code provides a double-beep and
enables a secure operation. After entering an Access Code, the keypad
is enabled for 5 seconds and the next button pressed initiates a secure
operation, such as unlocking the doors.
Note:
The Authority Code does not allow for secure operations. It is
only used to assign access codes (see page 12 for information on
setting access codes).
If an unassigned button is pressed, or no button is pressed, within
5 seconds of a correctly entered Access Code, the keypad
reverts back to disabled state.
If the keypad does not Double-beep after the 5th digit of your
entered Access Code, then you have not entered the correct
Access Code.
The secure keypad operations are set depending on the system
configuration. See the next page for more information.
Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
1 2 3 4 4
Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
4 4 4 4 4
5
6
e-PAD Configuration
Keypad Setting Configurations:
Entering a 5-digit access code enables the keypad. After entering the
Access Code, the next button pressed initiates a secure operation, such
as unlocking specific doors or some other operation. The following
table should be filled out by your dealer to explain the function of each
button. Not all buttons have a function in some installations. Common
configurations are listed in Appendix B on page II
Secure Function
Button Pressed Secure Operation
Button (1 / 2) or (1)
Button (3 / 4) or (2)
Button (5 / 6) or (3)
Button (7 / 8) or (4)
Button (9 / 0)
7
Optional Keyless Entry System Features
Not all of these features may be installed on your vehicle. Consult with your Dealer.
Dome/Porch Light Activation
The dome/porch light is activated for a timed duration (5-60 seconds)
whenever a keypad button is pressed or when system is unlocked from
FOB transmitter or vehicle switch. The time duration is dependent on a
mechanical setting inside the control module. The dome/porch light is
deactivated an engine-start is detected, or entry doors are locked using
a keyless device. Your Dealer should be able to adjust the timing of
your porch light if desired.
e-Grab Handle Lighting
The grab handle is lit continuously with a circuit installed separately
from the rest of the keyless entry system The timing and control of that
light is determined by an outside circuit, but is typically tied to the
parking lights circuit or porch light circuit. The e-PAD back lighting is lit
with a button press and while training new access and authority codes.
Lock and Unlock Confirmation
Standard mode e-FOB: The headlights flash once and the horn
honks once with a lock command. On unlock, the headlights
flash twice.
Cargo mode e-FOB: There is no unlock confirmation. The
headlights flash once and the horn honks once when either the
entry or compartment doors are locked. When both entry and
compartment doors are locked within 10 seconds, headlights
flash twice and the horn honks twice.
Keypad: The headlights flash once with a lock command. On
unlock, the headlights flash twice.
Locking and unlocking confirmation is deactivated if the keyless
entry system detects that the engine is running.
Door Ajar Warning
A triple siren chirp sounds if any compartment or entry door is open
when the entry and compartment doors are locked (security input
grounded). If a door is open, the alarm is not armed.
e-PAD Protective Deactivation Security Feature
If a correct code is not entered after 20 button presses, the keypad
enters an inactive mode that disables button recognition for 1 minute.
This helps prevent unauthorized access by entering random codes.
There is no button feedback while the system is disabled.
Otros manuales para e-ASK
6
Tabla de contenidos
Otros manuales de Arranque remoto de TriMark
TriMark
TriMark 500-1300 e-ASK Manual de usuario
TriMark
TriMark e-ASK UM15 Manual de usuario
TriMark
TriMark e-ASK Manual de usuario
TriMark
TriMark e-ASK Manual de usuario
TriMark
TriMark e-PAD Manual de usuario
TriMark
TriMark e-ASK UM27 Manual de usuario
TriMark
TriMark e-ASK UM06 Manual de usuario
TriMark
TriMark e-ASK UM 36 Manual de usuario
TriMark
TriMark 500-1300 e-ASK Manual de usuario
TriMark
TriMark e-FOB Manual de usuario
