Power Output Function with Multi-level Voltage Regulating
13. PERSONAL PRECAUTIONS
14. WARNING - FOLLOW THESE STEPS WHEN BOOSTING A BATTERY.
A SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO
REDUCE RISK OF A SPARK NEAR BATTERY OR INJURY, FOLLOW
PRECAUTIONS BELOW.
a) Someone should be within range of your voice or close enough to
come to your aid when you work on your product
b) Have plenty of fresh water and soap nearby in case you need to clean
your skin, clothing, or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching
eyes while working near battery.
d) If battery acid contacts skin or clothing, wash immediately with soap
and water. If acid enters eye, immediately flood eye with running cold
water for at least 10 minutes and get medical attention immediately.
e) NEVER smoke or allow a spark or flame in vicinity of battery or
engine.
f)Be extra cautious to reduce risk of dropping a metal tool onto battery.
It might spark or short-circuit battery or other electrical part that may
cause explosion.
g) Remove personal metal items such as rings, bracelets, necklaces,
and watches when working with a lead-acid battery. A lead-acid battery
can produce a short-circuit current high enough to weld a ring or the like
to metal, causing a severe burn.
h) Use your product on a 24 volt battery only. Do not connect to any
other volt battery system.
i) NEVER boost a frozen battery
j) This system is not designed to be used as a replacement for a
vehicular battery. Do not attempt to operate a vehicle or boat that does
not have a battery installed.
marking on these products and on engine.
c) DO NOT EXPOSE YOUR PRODUCT TO FIRE OR INTENSE HEAT
AS IT MAY EXPLODE.
a) Boosting procedures should only be performed in a safe, dry,
well-ventilated area.
b) When using this unit in proximity to the vehicle's battery and engine,
Figure 7 Multi-level Voltage Regulation Mobile Power Output
ON/OFF and Mode Switching: Press “ /DC SELECT” to start mobile
power function. After the equipment is started, press /DC SELECT key,
and DC output voltage can be switched between 12 V and 19V. After
pressing “DIM/ENTER” key to confirm, the voltage character stops flashing,
and DC outlet outputs corresponding voltage. Press /DC SELECT key for
at least 3 seconds to turn off the equipment.
DC Output Selection: Check external charging input parameters and
regulate the voltage output of the product. By using the cables and adapters,
it can achieve power supplying for the external equipments with different
voltage requirements such as laptop and other devices. If your equipment
does not work, please check whether the charging parameters of your
equipment are compliance with the output requirements of the product.
USB Output: USB output is standard 5V/2.1A current. USB output can
charge standard USB equipments. Please use the sold USB data wire to
charge your equipment.
Notes:
Connection sequences of adapter:
●Switch on the machine Switching voltage to external equipment
required level
●Insert DC adapter into the DC socket of the product
●Connect the adapter of corresponding product at the end of DC wire
●Insert the adapter into external equipment
●Check whether the charging is started on the external equipment
92
