Triax TEOC 211 Manual de usuario
User manual
TRIAX TEOC 211
Article Article no.
TRIAX TEOC 211 - Ethernet over coaxial cable adapter
Ethernet over coaxial cable adapterEthernet over coaxial cable adapter
Ethernet over coaxial cable adapter 310401
Version B Date 04/2017 EN
User manual
EN 2
Attention! / Achtung! / Consignes de sécurité!
EN
Failure to comply
Failure to complyFailure to comply
Failure to comply
with the pecified precautionary mea ure may cau e eriou injury to per on or damage to property. The in tallation and
commi ioning may only be performed by uitably qualified per on , technician or in taller in compliance with afety regulation .
Damage due to improper in tallation and commi ioning, defective connector on cable or any other incorrect handling will void the warranty.
CAUTION: The afety requirement are according to EN 60728-11 and mu t be ob erved.
• Di connect main power before working on electrical y tem .
• Any additional electrical wiring requirement hould alway be in talled by a uitably qualified per on( ).
In tallation or ervice work hould NEVER be undertaken during electrical / thunder torm .
Subject to change without prior notice !
DE
Gewährlei tung
Gewährlei tung Gewährlei tung
Gewährlei tung
Die ge etzliche Gewährlei tung nach Paragraph 437 BGB beträgt 24 Monate.
Bei un achgemäßer In tallation und Handhabung erli cht jeglicher Garantiean pruch.
Be timmung gemäße
Und achwidrige Verwendung
Die Montage und Inbetriebnahme darf nur von eingewie enen Per onen, Technikern
oder In tallateuren unter Beachtung der Sicherheit be timmungen durchgeführt werden.
Schaden durch fal che Montage und Inbetriebnahme owie durch un achgemaβe Handhabung fuhren zum Erlö chen de Garantiean pruch .
FR
Veillez à bien re pecter
Veillez à bien re pecterVeillez à bien re pecter
Veillez à bien re pecter
le con igne de écurité ci
-
de ou . Leur non
-
re pect peut provoquer de dommage matériel ou corporel .
L’in tallation et la mi e en route ne peuvent être effectué que par de technicien ou de in tallateur qualifié en re pectant le con igne de
écurité.
La garantie ne era pa appliquée lor de dégât cau é par une erreur de montage, de mi e en route ou par un mauvai raccordement ou
toute autre manipulation incorrecte.
PRUDENCE : avant toute intervention, votre in tallation doit être conforme aux exigence définie par le di po ition Européenne EN 50083
(conformité de in tallation collective ) et EN 60065 (norme en vigueur pour la protection électrique).
• Débranchez l’appareil avant toute intervention, car certain compo ant ou ten ion ont dangereux (ri que d’électrocution).
Toute intervention ur l’in tallation ou travaux de maintenance ont à pro crire en ca d’orage.
Table of contents / Inhaltsver eichnis / Sommaire
Attention! / Achtung! / Consignes de sécurité! ................................................................................ 2
1. ntroduction ...................................................................................................................... 3
1.1 Packing List ...................................................................................................................... 4
1.2 Connectors and LED’s ....................................................................................................... 5
2. First time configuration..................................................................................................... 6
3.1 Status / Device status ....................................................................................................... 8
3.2 Status / PHY rates ............................................................................................................. 9
3.3 Device settings .................................................................................................................. 9
3.4 TEOC settings ................................................................................................................. 10
3.5 Network security ............................................................................................................. 10
3.7 Admin / reset .................................................................................................................. 11
3.8 Admin / upgrade firmware .............................................................................................. 12
4. Specifications ................................................................................................................. 13
Notes-Notizen-Notes-Notas-Notater............................................................................................. 14
User manual
3 EN
1. ntroduction
TEOC 211 in tallation example (2 device to create a network)
The TEOC 211 i a multi
-
purpo e Ethernet over coaxial cable bridge device. It can be u ed in a
number of different way to deliver Gigabit Ethernet connection via an exi ting coaxial (TV aerial or
cable TV) connection.
It can be u ed a either a ender or receiver but it will need to be u ed with at lea t one other
TRIAX Ethernet over Coax compatible device. Thi can be either
• TEOC 211: Ethernet over Coax device (compatible with cable or terre trial TV ignal )
• TECW 211: Ethernet over Coax + Wi-Fi dual band device (compatible with cable or
terre trial TV ignal )
A Maximum of 16 TEOC 211 or TECW 211 device can be u ed in any in home network
Each being able to end and receive Gigabit Ethernet via the exi ting TV aerial or cable TV cabling
tructure that i already in talled in the home
The following page how the mo t common configuration . For more detailed in tallation
example plea e vi it our web ite www.triax.com
User manual
EN 4
1.1
Packing List
Before tarting the in tallation of the device, plea e make ure the package contain the following
item :
1 x TEOC 211
1 x TEOC 2111 x TEOC 211
1 x TEOC 211
1 x Power Adapter
1 x Power Adapter 1 x Power Adapter
1 x Power Adapter
100
100100
100-
--
-240 VAC / 50
240 VAC / 50240 VAC / 50
240 VAC / 50-
--
-
60Hz to 5V DC with
60Hz to 5V DC with 60Hz to 5V DC with
60Hz to 5V DC with
EU and UK plug
EU and UK plugEU and UK plug
EU and UK plug
1 x RJ 45 cable, Cat
1 x RJ 45 cable, Cat 1 x RJ 45 cable, Cat
1 x RJ 45 cable, Cat
5e, 1.0m.
5e, 1.0m.5e, 1.0m.
5e, 1.0m.
1 x white coaxial
1 x white coaxial 1 x white coaxial
1 x white coaxial
cable, 1.0m, cla B
cable, 1.0m, cla B cable, 1.0m, cla B
cable, 1.0m, cla B
75 ohm with 1x F
75 ohm with 1x F 75 ohm with 1x F
75 ohm with 1x F
male Connector
male Connector male Connector
male Connector
and 1 x IEC
and 1 x IEC and 1 x IEC
and 1 x IEC male
male male
male
connector
connector connector
connector
1 x IEC male to F male
1 x IEC male to F male 1 x IEC male to F male
1 x IEC male to F male
adapter
adapteradapter
adapter
1 x IEC female to F
1 x IEC female to F 1 x IEC female to F
1 x IEC female to F
male adapter
male adaptermale adapter
male adapter
User manual
5 EN
1.2
Connectors and LED’s
Power Solid Green
Off
Device i ON
Device i OFF
Link between
device
Solid Green
Off
Device i connected to
another imilar device
and a network i created
Device i NOT connected to another imilar
device and a network i created
LAN 1 / LAN
2
Solid Green
Blinking Green
Off
The Ethernet i plugged in and connected to
the network device
Receiving Ethernet traffic
The Ethernet i not plugged in
DC 5V/2A Plug in the upplied power upply 5V
Switch Turn on/off the lamp in the front panel
RESET Re et button
LAN 2 10/100/1000 Mbp , RJ45
LAN 1 10/100/1000 Mbp , RJ45
TV+WWW
Offer TV + Ethernet ignal to create the local network. See
connection example .
TV+WWW connector from everal TEOC 211/TECW 211 need to
be connected together to create the private network.
TV Offer TV ignal to be connected to TV et (output) or to the
terre trial / cable arrival ignal (input). See connection example .
Rear panel
Front panel
User manual
EN 6
2. First time configuration
•
Quick connection
In all ca e (terre trial or cable network), the fir t TEOC 211 adapter need to be connected to your
hou e Internet acce (Cable modem, ISP modem,…) via the upplied Ethernet patch cord, to get
an Ethernet ignal into the y tem.
• Connexion to a terrestrial television distribution system
Make a connection from a free OUTPUT on the TV aerial di tribution amplifier to the “TV+WWW” F
connector on the TEOC 211 adapter. It i e ential that the fir t TEOC 211 adapter i only
connected to an OUTPUT port of the amplifier, a the Ethernet over coax ignal cannot pa
through any amplifier.
At the econd end where the Ethernet ignal i wanted, you need to u e a econd TEOC 211
(without Wi-Fi extender) or to a TECW 211 (with build-in Wi-Fi extender). On thi econd device,
connect the “TV+WWW” F connector to the wall outlet (TV port).
To remake the connection to the TV or a DVB-T et top box, o that the ignal i pa ing through
the TEOC 211 (or TECW 211), u e the upplied coaxial fly lead between the TEOC 211 “TV” port
and your TV or STB.
Connect any Ethernet device – Smart TV, Game con ole, Blu-ray player, IP Set top Box etc. u ing
the upplied Ethernet patch cord.
Power up the 2 TEOC 211 device , the link between the device i e tabli hed automatically, thi i
confirmed when the LED i ON. (It may take a few minute to link.). The cable or terre trial
TV ignal can be pa ed through the device.
User manual
7 EN
•
Connexion to a cable television distribution system
Make a connection from a free OUTPUT on the CATV di tribution amplifier to the
“TV+WWW” F
connector on the TEOC 211 adapter. It i e ential that the fir t TEOC 211 adapter i only
connected to an OUTPUT port of the amplifier, a the Ethernet over coax ignal cannot pa
through any amplifier.
At the econd end where the Ethernet ignal i wanted, you need to u e a econd TEOC 211
(without Wi-Fi extender) or to a TECW 211 (with build-in Wi-Fi extender). On thi econd device,
connect the “TV+WWW” F connector to the wall outlet (TV port).
To remake the connection to the TV or a DVB-T et top box, o that the ignal i pa ing through
the TEOC 211 (or TECW 211), u e the upplied coaxial fly lead between the TEOC 211 “TV” port
and your TV or STB.
Connect any Ethernet device – Smart TV, Game con ole, Blu-ray player, IP Set top Box etc. u ing
the upplied Ethernet patch cord.
Power up the 2 TEOC 211 device , the link between the device i e tabli hed automatically, thi i
confirmed when the LED i ON. (It may take a few minute to link.). The cable or terre trial
TV ignal can be pa ed through the device.
If you have more device to connect onto your network, repeat the econd device operation.
The chematic below illu trate how to create your fi t network. More chematic example are
available on www.triax.com
Once your network i et, the device connected ( ee LED tatu ), you houldn’t need to get
acce to the TEOC 211 internal parameter . For experimented u er or to do ome pecial
etting (change of the frequency, have higher ecurity, oftware upgrade), a tool called PC Tool to
configure the TEOC 211 i available on www.triax.com
Plea e download thi tool to do additional etting .
User manual
EN 8
3. Detailed settings
In order to etup the device operating channel and ecurity, you can run PC Tool to configure it.
Plea e download the PC tool from the TRIAX web ite and in tall it on your PC:
• Thi tool i for Window 7/8/10. Plea e update to .NET framework 4.0 if needed.
• Make ure that the TEOC 211 device i directly connected to your computer via an
Ethernet cable, and the device i powered on.
• Double-click the file “PC_Tool.exe” to execute PC tool.
• In ca e of the device not connecting or not powered on, the program won’t be able to
detect the device and the alert window will pop up. In thi ca e, connect the device
properly and make ure it’ in power on tatu , and then click “OK”.
The
“Connect ucce !” prompt window hould
pop up. Click “OK” to enter the tool.
3.1
Status / Device status
The device tatu i di played on thi page. The left frame how the menu tree to navigate
through all the configuration page , and click the drop-down box “Engli h” to elect the language
for web GUI.
User manual
9 EN
3.2
Status / PHY rates
The table how the PHY rate of the device connected together.
The normal PHY data rate hould be ≥ 600Mbp . If not achieved, plea e try to reduce the ignal
attenuation (number of coaxial plitter or reduce the length of coaxial cable) between the device .
3.3
Device settings
You can ju t u e the default etting on thi page
User manual
EN 10
3.4
TEOC settings
Item
ItemItem
Item
De cription
De criptionDe cription
De cription
Network earch
Thi device can can the exi ting MoCA network within the MoCA predefined
channel . By default the channel D1 (1150MHz) will be u ed. Plea e change all
device operating frequency to enable the communication between them.
La t operating
frequency
Thi i the la t operating band of the device.
Beacon power
level
Select the beacon power value. By default do not change it.
Preferred NC
If checked, thi device will try to be MoCA Network Coordinator.
If not checked, the NC will be determined by the MoCA network.
3.5
Network security
Otros manuales para TEOC 211
1
Tabla de contenidos
Idiomas:
Manuales populares de Enrutador de red de otras marcas
NETGEAR
NETGEAR FS526T - Switch Manual de usuario
Korenix
Korenix JetNet 5710G Series Manual de usuario
Automated Logic
Automated Logic ZN551 Manual del propietario
Cisco
Cisco ASR 1000 Series Manual del operador
EnGenius
EnGenius ESR-9710 Manual de usuario
Cisco
Cisco 805 Series Instrucciones de funcionamiento y seguridad