TRENDnet TW100-S4W1CA Manual de usuario
2
FCC Warning
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a commercial environment.
This equipment generates, uses and radiates radio frequency energy. If not
installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference. In
this case the user will be required to correct the interference at their own
expense.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
VCCI Warning
P/N: Rev.A1-01
TABLE OF CONTENTS
About This Guide...............................................................................................................1
Purpose..........................................................................................................................1
Overview of this User’s Guide......................................................................................1
Introduction ........................................................................................................................3
Applications: .................................................................................................................3
Features: ........................................................................................................................4
Unpacking and Setup .........................................................................................................5
Unpacking .....................................................................................................................5
Setup..............................................................................................................................5
Hardware Installation.........................................................................................................7
Front Panel ....................................................................................................................7
Rear Panel......................................................................................................................8
Hardware connections...................................................................................................9
Connect the Internet Broadband Router ..................................................................9
Check the installation.............................................................................................10
PC Network TCP/IP Setting.............................................................................................11
Windows 95/98/ME ....................................................................................................11
Windows XP/2000 ......................................................................................................13
Windows NT4.0 ..........................................................................................................14
Internet Broadband Router Configuration .......................................................................15
Login to the Internet Broadband Router.....................................................................15
Quick Setup.................................................................................................................16
Advanced Setup...........................................................................................................19
Technical Specifications ..................................................................................................34
LIMITED WARRANTY .................................................................................................35
1
ABOUT THIS GUIDE
Congratulations on your purchase of this Cable/DSL 4-port Broadband
Router. This device integrates 100Mbps Fast Ethernet and 10Mbps
Ethernet network capabilities. This router is a complete solution for
sharing the Internet and other office resources.
Purpose
This manual discusses how to install the 4-port Broadband Router.
Overview of this User’s Guide
Introduction. Describes the Broadband Router and its features.
Unpacking and Setup. Helps you get started with the basic installation of
the Router.
Identifying External Components. Describes the front panel, rear panel,
and LED indicators of the Router.
Connecting the Router. Explains how you connect the Router to your
xDSL/Cable Modem.
Technical Specifications. Lists the technical (general, physical and
environmental, performance and Routers settings) specifications of the
Broadband Router.
3
INTRODUCTION
With the explosive growth of the Internet, accessing information and
services at any time, day or night, has become standard fare for most
people. The era of the standalone PC is waning. Networking technology is
moving out of the exclusive domain of corporations and into homes with
at least two computers.
Broadband network access is also gaining ground. Allowing more than
two computers to access the Internet at the same time, however, has
typically entailed significantly higher costs. Thus, there is a great demand
for technology that enables users to share a single Internet connection.
Employing a router to share an Internet connection solves the problem of
high network access costs. Using such a device, each networked computer
is able to make full use of broadband capabilities.
This device not only comes equipped with a wide range of features but
also can be installed and configured right out of the box. This device
supports a simple local area network and Internet access sharing.
A local area network connects home computers and enables users to
access the Internet, share resources, and play online games – the essentials
of the family computing lifestyle.
Applications:
Broadband Internet access sharing:
Enable several computers to share a single high-speed broadband Internet
connection (LAN and WAN-Internet).
Resource sharing:
Share printers, scanners, and other peripherals.
File sharing:
Exchange data, messages, and files -- thus making good use of hard disk
space.
4
Online gaming:
Your local area network allows you to play online games and use e-
commerce services.
Firewall:
A built-in firewall function protects against hackers.
Features:
¾High speed data transfer rate, FTP up to 40Mbps
¾Supports NAT (sharing one IP address with all LAN users)
¾Supports PPPoE and PPTP protocol for Dial-Up ADSL
¾Supports DHCP Server / Client
¾Supports UPnP (Universal Plug and Play)
¾Supports virtual server mapping
¾Supports packet filtering
¾Simple Firewall protection
¾Upgradeable firmware for future functions
¾Easy configuration via Web Browser.
5
UNPACKING AND SETUP
This chapter provides unpacking and setup information for the Broadband
Router.
Unpacking
The box should contain the following items:
One 4-port High Speed Broadband Router
One external power adapter (5V DC, 800mA)
One CD-ROM with User’s Guide
Quick Installation Guide
If any item is found missing or damaged, please contact your local reseller
for replacement.
Setup
The setup of the Broadband Router can be performed using the following
steps:
The power outlet should be within 1.82 meters (6 feet) of the
Broadband Router.
Visually inspect the DC power jack and make sure that it is
connected securely to the power adapter.
Make sure that there is proper heat dissipation from and adequate
ventilation around the Broadband Router. Do not place heavy
objects on the Broadband Router.
7
HARDWARE INSTALLATION
Front Panel
The figure below shows the front panel of the Broadband Router.
4-Port 10/100Mbps Ethernet Broadband Router Front Panel
POWER
This indicator lights green when the hub is receiving power. Otherwise, it
is off.
STATUS
This indicator blinks red when the Internet Broadband Router is
successfully working. If the indicator is either always on or off, the
Internet Broadband Router is not working properly.
WAN
This indicator lights green when the WAN port is connected to an
xDSL/Cable modem successfully.
This indicator blinks green while the WAN port is transmitting data to or
receiving data from the xDSL/Cable modem.
LAN (Link/ACT)
8
The port 1 - 4 indicators light green when they’re connected to a 100Mbps
Fast Ethernet station. If the indicator blinks green, the corresponding LAN
port is transmitting or receiving data.
Rear Panel
The figure below shows the rear panel of the Broadband Router.
4 Port 10/100Mbps Ethernet Broadband Router Rear Panel
WAN
On the 4 port broadband router, there is an RJ-45 10/100Mbps Auto-
MDIX WAN port. This port connects to your xDSL/Cable modem.
LAN (1-4)
Four RJ-45 10/100Mbps Auto-MDIX ports for connecting to either
10Mbps or 100Mbps Ethernet connections.
RESET
Use a pin-shaped object to reset this device to factory default settings.
Resetting the device will also reset the login password to the default.
9
Hardware connections
Connect the Internet Broadband Router
1. Connect one end of the network cable to the WAN port of the 4-port
Internet Broadband Router.
2. Connect the other end of the network cable to the Ethernet port of the
xDSL or Cable modem.
3. Connect one end of another network cable to the computer’s Ethernet
card and the other end of the cable to one of the Router’s LAN ports.
Since the Internet Broadband Router has four ports, you can connect
up to four computers directly to the unit. You do not have to buy a
switch to connect these computers since the Internet Broadband
Router functions as both an Internet connection-sharing unit and as a
switch.
10
Check the installation
The LEDs of the Internet Broadband Router are clearly visible and the
status of the network link can be seen immediately:
1. Once the device is connected to the broadband modem and the Power
is connected, the Power, System, LAN and WAN port link LEDs of
the Internet Broadband Router will light up.
2. If the WAN port is linked to the ADSL/Cable modem, the WAN
port’s Link/ACT LED will light up.
3. If the LAN port is linked to the computer system, the LAN port’s
Link/ACT LED will light up.
11
PC NETWORK TCP/IP SETTING
The network TCP/IP settings differ based on the computer’s operating
system (Win95/98/ME/NT/2000/XP) and are as follows.
Windows 95/98/ME
1. Right click on the “Network neighborhood” icon and select
properties.
2. Select the TCP/IP for your Ethernet adapter and then click properties.
3. Select “Obtain an IP address automatically” in the “IP Address”
tab.
12
4. Click on the DNS configuration tab and select “Disable DNS”.
5. Click on the Gateway tab. If there are any Installed gateways,
select the gateway and click Remove.
6. Click OK.
13
Windows XP/2000
1. Right click My Network Places and select Properties
2. Double-click on the Local Area Connection icon and click
Properties.
3. Click on Internet Protocol (TCP/IP) and select Properties.
4. Select Obtain an IP Address Automatically.
5. Select Obtain DNS Server Address Automatically.
6. Click OK.
14
Windows NT4.0
Click on the “Start” button located on the lower left corner of the menu
bar.
Select “Settings” and then “Control panel.”
In the “Control panel” window, select “Network” to enter the TCP/IP
settings window.
1. Set “IP address” to “Obtain an IP address automatically.”
2. Set “DNS” to “Disable DNS.”
15
INTERNET BROADBAND ROUTER CONFIGURATION
First, make sure that the network connections are functioning normally.
This Internet Broadband Router can be configured using Internet Explorer
5.0 or later.
Login to the Internet Broadband Router
1. Open Internet Explorer 5.0 or higher.
2. Enter http://192.168.0.1 (the factory-default IP address setting) in
the address bar.
3. When the following dialog box appears, type in admin for the user
name. Leave the password field blank, (by default, there is no
password) and click LOGIN.
Note: If you need to set a password, refer to the Administrator Settings
in Advanced Setup.
4. Two setup options appear: Quick Setup or Advanced Setup. It is
recommended that you use Quick Setup if you are a beginner. It will
lead you through the configuration step-by-step.
16
Quick Setup
On the main webpage, select “Quick Setup” to specify the Time Zone and
the WAN connection type.
1-1 Time Zone
Select the appropriate time zone so your system clock can synchronize
itself through the SNTP Server.
1-2 WAN Connection Type
To select the WAN connection-type, click Dynamic IP (Cable Modem),
Static IP (Fixed-IP), PPPoE (Dial-up xDSL) or PPTP
Otros manuales para TW100-S4W1CA
6
Tabla de contenidos
Otros manuales de Enrutador de red de TRENDnet
TRENDnet
TRENDnet TEW-829DRU Manual de usuario
TRENDnet
TRENDnet TEW-231BRP Manual de usuario
TRENDnet
TRENDnet TW100-BRV204 SHEETS Manual de usuario
TRENDnet
TRENDnet TE100-S16R Manual de usuario
TRENDnet
TRENDnet TW100-BRV304 SHEETS Manual de usuario
TRENDnet
TRENDnet TW100 S4W1CA Manual de usuario
TRENDnet
TRENDnet TW100-BRF114U Manual de usuario
TRENDnet
TRENDnet TE100-S32 Manual
TRENDnet
TRENDnet TW100 TW100-BRV304 Manual de instalación y operación
TRENDnet
TRENDnet TW100-BRF114 Manual de usuario
TRENDnet
TRENDnet TE100S8P - Fast Ethernet Switch Manual de usuario
TRENDnet
TRENDnet TEW-751DR Manual de usuario
TRENDnet
TRENDnet TEG-160WS Manual de usuario
TRENDnet
TRENDnet GREENnet TEW-639GR Manual de usuario
TRENDnet
TRENDnet TEW-721BRM Manual de usuario
TRENDnet
TRENDnet TW100-BRF114 Manual de usuario
TRENDnet
TRENDnet TEW-637AP - 300Mbps Wireless Easy-N-Upgrader Manual de usuario
TRENDnet
TRENDnet TW-H6W1IR Manual de usuario
TRENDnet
TRENDnet TEW-652BRP Manual de usuario
TRENDnet
TRENDnet TE100-S16Eg Manual de usuario
Manuales populares de Enrutador de red de otras marcas
NETGEAR
NETGEAR FS526T - Switch Manual de usuario
Korenix
Korenix JetNet 5710G Series Manual de usuario
Automated Logic
Automated Logic ZN551 Manual del propietario
Cisco
Cisco ASR 1000 Series Manual del operador
EnGenius
EnGenius ESR-9710 Manual de usuario
Cisco
Cisco 805 Series Instrucciones de funcionamiento y seguridad