TRENDnet TVP-221H Manual de usuario
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
Version 07.25.05
4-Port VoIP Gateway
Quick Installation Guide
TVP-221H
Table of Contents
English ...................................................................................................... 1
1
9
2
10
3
12
4
14
5
16
1. Prepare for Installation ......................................................................
2. Install Hardware ................................................................................
3. Configure the computer's TCP/IP Settings ........................................
4. Configuration .....................................................................................
5. Internet Access Directly Under Cable/ ADSL Modem ........................
6. Connection through Telnet .................................................................
7. Connection through Console .............................................................
8. Dynamic DNS (Domain Name Server) ..............................................
9. Configured under (NAT) router ..........................................................
10. Web Browser Dial Plan Sample ......................................................
Thank you for purchasing the TVP-221H. This VoIP Gateway will allow you to
integrate your existing analog / PBX phone system for Internet telephony.
This guide will help you setup and configure your VoIP Gateway. Following the
installation instructions should be quick and easy. If you run into problems,
please refer to the detailed installation procedures on the CD User's Guide. If
you need further technical support, please visit www.TRENDNET.com or call by
phone.
Verify Equipment
Before installing the TVP-221H VoIP Gateway you should have:
1. A working DSL Internet connection with Static IP or Dynamic IP with DDNS
2. Cable / DSL Modem
3. Bandwidth Router (Optional Cable/ ADSL Router)
4. A computer with wired network card installed.
5. TCP/IP protocol installed on each wired computer.
6. A Web Browser such as Internet Explorer (5.0 or higher) or Netscape
Navigator (4.7 or higher).
Verify Package Contents
Please make sure you have everything in the box:
1
TVP-221H
CD-ROM Quick Installation Guide
AC Power Adapter RJ45 Ethernet (LAN) Cable RS-232 Console Cable
English
1. Prepare for Installation
English QIG
Copyright ©2005. All Rights Reserved. TRENDware International, Inc.
TRENDnet
TRENDware, USA
What's Next in Networking
Version 07.25.05
4-Port VoIP Gateway
Quick Installation Guide
TVP-221H
2English
2. Install Hardware
4
3
12
TVP-221H
1. For configuration, connect a RJ-45 network cable from the TVP-221H's LAN
port to a PC. Once configuration is complete, disconnect PC and reconnect
directly to Cable / DSL modem. (Please see User Manual for more
information on configuration under a router including Port Forwarding)
2. Connect Analog Phones/ Fax machine using RJ11 to FXS port(s).
3. Connect FXO port(s) using RJ 11 Cable to PBX system or PSTN line.
4. Power on your TVP-221H.
Verify Hardware Installation
Make sure the following Gateway LEDs are on: Power, System (blinking), LAN
(100Mb/s or 10Mb/s), LINK
WARNING: Never connect a Trunk Line / PSTN line to a FXS Port. This
will result In permanent damage to the FXS port.
LINE
POWER
SYSTEM LAN
3English
3. Configure the computer's TCP/IP Settings
To verify that your computer can communicate with your VoIP Gateway, you
need to configure the TCP/IP settings in your PC Operating System (OS). Set
up the PC with an IP address in the “192.168.0.x” IP domain, for example,
“192.168.0.2” with subnet mask address “255.255.255.0”. Detailed setup
procedures for Windows OS computers can be found in the User Manual on
the CD provided. If you are running any other OS please see your system
documentation for configuration information.
4English
The TVP-221H comes with a default IP address, LAN side IP is “192.168.0.1”.
You may use any PC to connect to the LAN port of TVP-221H, and then follow
the steps below:
1. Start your WEB browser. In the address field, Type in the following address
http://192.168.0.1.
2. The pop-up screen should appear and prompt for user name and password.
If you forget your user password, please see section 7 Connection through
Console. The default values are:
User name: admin (all lower case)
Password: 123
3. The following TVP-221H VoIP Gateway Graphical User Interface main page
should appear. If connection fails, check cable connections between the PC
and TVP-221H.
4. Configuration
5English
5. Internet Access Directly Under
Cable/ ADSL Modem
The following set-up information is designed to help you set-up your gateway to
connect to the Internet. The set-up is different depending upon the type of
Internet Connection you have with your ISP (Fixed IP, PPPoE, DHCP). If you're
not sure what type of connection you have, please contact your Internet
Service Provider and collect the required information. Below is a table that
outlines the basic data you will require from your ISP.
Connection Type Data required
Fixed IP (Static)
Fixed IP Address, Subnet Mask, Default
Gateway and Primary DNS (Secondary
DNS is optional).
PPPoE Login name and password (Service Name
is optional)
DHCP
Usually, none. If your ISP requires Hostname,
Domain name, or MAC (physical) address,
please contact Trendware.
After setting up Internet Access you will be able to Remotely Manage
the Gateway using the WAN IP. By default the Web Access and Telnet
Access management are enabled. Both of these methods provide
access over the Internet so they do pose a potential security risk. It is
recommended that once configuration is complete, Telnet access is
disabled for security reasons. It is also recommended that the
administration password is updated. In the event that you should forget
the password see section 7 Connection through Console.
6English
1. From the Navigation Bar on the left side of the screen, Click on the Internet
Access Option. From the Internet Access sub-menu, Select Fixed IP.
The Fixed IP Configuration page will appear.
2. Enter all field information as provided by your ISP and Click Save.
3. Reboot the TVP-221H system in order for the changes to take effect. From a
PC using a different WAN IP for Internet Access, Launch your web browser,
(Internet Explorer or Netscape Navigator) Type the Gateways WAN IP,
http://xxx.xxx.xxx into the address bar, and hit the Enter key. If the web
interface dialogue box appears prompting you for a username and
password, the Gateway is properly configured for Internet Access.
Static or Fixed IP Cable Connection
NOTE: If the website does not appear, please verify that the information
is entered correctly. Also call your ISP and verify your connection type. If
you still can not establish Internet Access, please reference the trouble
shooting section of your user manual.
7English
1. Click on the Internet Access option on the left-hand side of the screen and
Select PPPoE. The WAN PPPoE configuration page will appear.
2. Enter PPPoE User Name and Password as provided by your ISP, and Click
Save.
PPPoE DSL Connection
3. Reboot the TVP-221H system in order for the changes to take effect.
From a PC using a different WAN IP for Internet Access, Launch your web
browser, (Internet Explorer or Netscape Navigator) Type the Gateways
WAN IP, http://xxx.xxx.xxx into the address bar, and hit the Enter key. If the
web interface dialogue box appears prompting you for a username and
password, the Gateway is properly configured for Internet Access.
4. Setup DDNS Client (See section 8 on DDNS Client).
NOTE: If the website does not appear, please verify that the information
is entered correctly. Also call your ISP and verify your connection type. If
you still can not establish Internet Access, please reference the trouble
shooting section of your user manual.
8English
1. Click on the Internet Access option on the left-hand side of the screen and
Select DHCP. The WAN PPPoE configuration page will appear.
2. Enable DHCP (If your ISP requires more information including Hostname,
Domain Name and / or WAN MAC Address, please notify your System
Integrator or Trendware Customer Service)
3. Click Save.
DHCP Connection
4. Reboot the TVP-221H system in order for the changes to take effect.
5. From a PC using a different WAN IP for Internet Access, Launch your web
browser, (Internet Explorer or Netscape Navigator) Type the Gateways WAN
IP, http://xxx.xxx.xxx into the address bar, and hit the Enter key. If the web
interface dialogue box appears prompting you for a username and
password, the Gateway is properly configured for Internet Access.
6. Setup DDNS Client (See section 8 on DDNS Client).
NOTE: If the website does not appear, please verify that the information
is entered correctly. Also call your ISP and verify your connection type. If
you still can not establish Internet Access, please reference the trouble
shooting section of your user manual.
NOTE: This quick guide covers only the most common situations.
Please refer to the User Guide (CD) for more information on
configuration under a router including Port forwarding and DMZ
configuration. For console / telnet configuration, please reference the
Advanced User Guide (CD) for more detailed information.
Otros manuales para TVP-221H
2
Otros manuales de Puerta de TRENDnet
Manuales populares de Puerta de otras marcas
LST
LST M500RFE-AS Manual de usuario
Kinnex
Kinnex Media Gateway Manual de usuario
2N Telekomunikace
2N Telekomunikace 2N StarGate Manual de usuario
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario
Telsey
Telsey CPVA 500 - SIP Manual de usuario
