TRENDnet TU2-ET100 Manual de usuario
Quick Installation Guide
TU2-ET100
H/W: 3.0R
Table of Contents
Table of Contents
Version 03.14.2008
English ..................................................................................................... 1
1
2
4
1. Before You Start
2. .....................................................................................
................................................................................
How to Install
Troubleshooting ........................................................................................
System Requirements
Application
?TU2-ET100
?Driver CD-ROM
?Quick Installation Guide
Package Contents
1. Before You Start
English
1
?CD-ROM Drive
?CPU: 300MHz or above/ 800MHz or above (Windows Vista)
?Memory: 256 MB RAM or above/ 512 MB RAM or above (Windows Vista)
?Computer With An Available USB 1.1 or 2.0 Port
?Windows Vista (32-bit/64-bit)/XP (32-bit/64-bit)/2000/ME/98SE, Mac OS X
(10.1~10.4)
Cable/DSL Modem
Cable/DSL 4-Port
Broadband Router
(TW100-S4W1CA)
USB 2.0 to 10/100Mbps
Fast Ethernet Adapter
(TU2-ET100)
Internet
Workstation
Notebook
2. How to Install
English
2
1. Insert the CD-ROM into your
computer's CD-ROM Drive.
2. Click Run Install.exe (Windows
Vista Only)
Windows Vista/XP/2000
3. The drivers for your operating
system will be automatically
detected. Your operating system
will be highlighted in bold. Click
Install to install the driver.
4. Click OK.
Note: For Windows 98SE and Me driver installation, refer to the user guide on
the Driver CD-ROM.
English
3
6. Connect the Adapter to an
available USB port of your
computer.
7. Drivers will install automatically.
8. Connect a RJ-45 cable from the
Adapter to a Switch, Router or
Cable/DSL Modem.
Your installation is now complete.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet
5. Remove the driver CD-ROM from
your computer's CD-ROM drive.
4
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
Can I connect or disconnect TU2-ET100 while the computer is on?
Yes, you can connect or disconnect TU2-ET100 while the computer is on
because the USB interface is Plug-and-Play compliant and hot-pluggable.
Windows is unable to recognize my hardware. What should I do?
First, make sure your computer meets the minimum requirements as specified
in Section 1 of this Quick Installation Guide. Second, try plugging the adapter into
a different USB port.
Windows recognizes my new hardware, but I'm unable to connect to my
network. What should I do?
First, verify that the network cable is securely connected from your switch or
router to your adapter. Second, verify that the LEDs on your adapter are lit. Third,
verify that the TCP/IP settings are set to Obtain an IP address automatically.
Refer to the User Guide included on the Driver CD-ROM for installation
instructions.
If you still encounter problems or have any questions regarding the TU2-ET100, please
refer to the User's Guide included on the Driver CD-ROM or contact TRENDnet's
Technical Support Department.
How do I install this device on Windows 98SE, ME and Mac OS X?
Troubleshooting
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.
Copyright ©2008. All Rights Reserved. TRENDnet.
20675 Manhattan Place
Torrance, CA 90501
USA
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
TRENDnet Technical Support
US Canada
24/7 Tech Support
Toll Free Telephone: 1(866) 845-3673
Europe (Germany France Italy Spain Switzerland UK)
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Worldwide
Telephone: +(31) (0) 20 504 05 35
Toll Free Telephone: +00800 60 76 76 67
.
. . . . .
Otros manuales para TU2-ET100
11
Tabla de contenidos
Otros manuales de Adaptador de TRENDnet
TRENDnet
TRENDnet TEG-PCISXplus Manual de usuario
TRENDnet
TRENDnet TU3-SA - Manual de usuario
TRENDnet
TRENDnet TE-PCI Manual de usuario
TRENDnet
TRENDnet TBW-104UB Manual de usuario
TRENDnet
TRENDnet TEW-604UB Manual de usuario
TRENDnet
TRENDnet TBW-107UB Manual de usuario
TRENDnet
TRENDnet TU-ET100plus Manual de usuario
TRENDnet
TRENDnet TEW-805UB Manual de usuario
TRENDnet
TRENDnet TEW-647GA Manual de usuario
TRENDnet
TRENDnet TEW-664UB Manual de usuario
TRENDnet
TRENDnet TBW-108UB Manual de usuario
TRENDnet
TRENDnet TU2-ET100 Manual de usuario
TRENDnet
TRENDnet TEW-800MB Manual de usuario
TRENDnet
TRENDnet TU2-ETG Manual de usuario
TRENDnet
TRENDnet TPL-406E Manual de usuario
TRENDnet
TRENDnet TEW-687GA 1.0R Manual de usuario
TRENDnet
TRENDnet TU-ET100C - Manual de usuario
TRENDnet
TRENDnet TEW-229UB Manual de usuario
TRENDnet
TRENDnet TBW-105UB Manual de usuario
TRENDnet
TRENDnet TPL-405E Manual de usuario
