Tranzeo EX2 Manual de usuario

TRANZEO EX2

Tranzeo EX2

User Guide

Covers the following models:

EX2-8

Document No.: TR2029

Revision: 3.0

Firmware: 3.0.4(TZ)1

Date: 2011-05-20

iiiiii

This document is intended for Public Distribution 19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Document Revisions:

Version 2.0 September 3, 2010

Version 3.0 May 20, 2011

Tranzeo Wireless Technologies Inc.

19473 Fraser Way

Pitt Meadows, BC

Canada V3Y 2V4

Toll Free Number: 1.866.872.6936

Technical Support: 1.888.460.6366 General Inquiries: [email protected]

Local Number: 1.604.460.6002 Sales: [email protected]

Fax Number: 1.604.460.6005 Technical Support: [email protected]

iiiiiiiii

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Safety Information

iii

EX2 Series

Tranzeo Wireless Technologies

This device has been tested and found to comply with the limits for a Class B digital device

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the device is operated in a residential

environment. This device generates, uses, and can radiate radio frequency energy. If not

installed and used in accordance with the user guide, may cause harmful interference to radio

communication. In case of harmful interference, the users will be required to correct the

interference at their own expense.

The users should not modify or change this device without written approval from Tranzeo

Wireless. Modification will void warranty and authority to use the device.

For safety reasons, people should not work in a situation where RF exposure limits could be

exceeded. To prevent this situation, the users should consider the following rules:

• Install the antenna so that there is a minimum of 100 cm (39.37 in) of distance between

the antenna and people.

• Do not turn on power to the device while installing the antenna.

• Do not connect the antenna while the device is in operation.

• Do not collocate or operate the antenna used with the device in conjunction with any

other antenna or transmitter.

FCC Compliance

Safety Information

Operation of this device is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Industry Canada Compliance

iviviv

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Safety Information

EX2 Series

Tranzeo Wireless Technologies

You must read and understand the following safety instructions before installing the device:

• This antenna’s grounding system must be installed according to Articles 810-15, 810

-20, 810-21 of the National Electric Code, ANSI/NFPA No. 70-1993. If you have any

questions or doubts about your antenna’s grounding system, contact a local licensed

electrician.

• Never attach the grounding wire while the device is powered.

• If the ground is to be attached to an existing electrical circuit, turn off the circuit before

attaching the wire.

• Use only Tranzeo Power over Ethernet (POE) adapter approved for this model.

• Never install radio equipment, surge suppressors or lightning protection during a storm.

! Safety Instructions

Lightning Protection

The key to lightning protection is to provide a harmless route for lightning to reach ground.

The system should not be designed to attract lightning, nor can it repel lightning. National,

state and local codes are designed to protect life, limb, and property, and must always be

obeyed. When in doubt, consult local and national electrical codes or contact an electrician or

professional trained in the design of grounding systems.

The product requires professional installation. Professional installers ensure that the

equipment is installed following local regulations and safety codes.

Professional Installation Required

vvv

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Table of Contents

EX2 Series

Tranzeo Wireless Technologies

Chapter 1: Overview ........................................................................1-1

Introduction ......................................................................................................1-1

Product Kit .......................................................................................................1-1

Product Description..........................................................................................1-1

LED Panel Indicators...................................................................................1-2

Chapter 2: Hardware Installation......................................................2-1

Getting Ready...................................................................................................2-1

Tools Required.............................................................................................2-1

Site Selection ...............................................................................................2-1

Polarity.........................................................................................................2-2

Power Supply...............................................................................................2-2

Restore Factory Defaults .............................................................................2-2

Installing the Ethernet Cable ............................................................................2-3

Mounting the Radio..........................................................................................2-4

Connecting an External Antenna......................................................................2-5

Grounding the Radio ........................................................................................2-5

Connecting the Radio .......................................................................................2-6

Best Practices ...................................................................................................2-7

Chapter 3: Configuration...................................................................3-1

Connecting to the Radio ...................................................................................3-1

Changing the IP Address - Windows XP ....................................................3-1

Web Interface ...................................................................................................3-3

System Menu....................................................................................................3-4

Basic Settings...............................................................................................3-4

Bridge IP Settings ........................................................................................3-5

Router IP Settings ........................................................................................3-6

Time Settings ...............................................................................................3-8

RADIUS Settings.........................................................................................3-9

Firewall Settings ..........................................................................................3-10

Source IP Filtering ..................................................................................3.10

Destination IP Filtering ...........................................................................3-11

Source Port Filtering ...............................................................................3.12

Destination Port Filtering........................................................................3-13

Port Forwarding ......................................................................................3-14

Table of Contents

vivivi

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Table of Contents

EX2 Series

Tranzeo Wireless Technologies

UDP Pass-through...................................................................................3-15

DMZ........................................................................................................3-16

Wireless menu ..................................................................................................3-17

Wireless Basic Settings................................................................................3-17

Site Survey.................................................................................................3-19

Profile Settings...........................................................................................3-20

Security Settings ................................................................................... 3-21

VAP Profile Settings ............................................................................. 3-22

Wireless Advanced Settings ......................................................................3-23

Wireless Access Control............................................................................3-25

WDS Settings.............................................................................................3-26

Management Menu.........................................................................................3-27

Remote Settings .........................................................................................3-27

SNMP Settings ...................................................................................... 3-27

Configure SNMPv3 User Profile ..........................................................3-28

CoovaChilli Settings..................................................................................3-29

Upgrade Firmware ..................................................................................... 3-30

Configuration File......................................................................................3-31

Password Settings ......................................................................................3-32

Certificate Settings.....................................................................................3-33

Tools Menu.....................................................................................................3-34

System Log ................................................................................................3-34

Ping Watchdog...........................................................................................3-35

Data Rate Test............................................................................................3-36

Antenna Alignment....................................................................................3-37

Speed Test..................................................................................................3-38

Status Menu....................................................................................................3-39

Information ................................................................................................3-39

Connections ...............................................................................................3-40

Statistics..................................................................................................... 3-41

ARP Table .................................................................................................3-42

Bridge Table ..............................................................................................3-43

DHCP Clients ............................................................................................3-44

Network Activities.....................................................................................3-45

Appendix A: Grounding and Lightning Protection Information....A-1

Appendix B: WMM Quality of Service (QoS)...................................B-1

Appendix C: Protocol List.................................................................C-1

Appendix D: Common TCP Ports.....................................................D-1

viiviivii

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Table of Contents

vii

EX2 Series

Tranzeo Wireless Technologies

Appendix E: Channel Allocations ....................................................E-1

Appendix F: Wiring Standard ...........................................................F-1

Appendix G: Routing Quick Start Guide..........................................G-1

Appendix H: PxP Install Checklist....................................................H-1

Appendix I: Using Victor to Change IP Address.............................I-1

Appendix J: Glossary of Terms........................................................J-1

Appendix K: Tranzeo Electrical Plugs.............................................K-1

Appendix L: Warranty Terms............................................................L-1

Appendix M: How Can We Improve? ...............................................M-1

Appendix N: Notes.............................................................................N-1

111

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Chapter 1: Overview

1-1

EX2 Series

Tranzeo Wireless Technologies

Introduction

Tranzeo’s EX2 product series of wireless LAN devices is based on the IEEE

802.11n standard and is also fully compliant with the IEEE 802.11b/g standard.

Operating in the license-free 2.4GHz frequency band, the EX2 family of products

feature high performance radio and support data rates of up to 150 Mbps. The EX

products also feature advanced networking and management capabilities including

WEP/WPA/WPA2 security, and WMM QoS. The versatile multi-mode design

supports both AP and CPE modes, as well as WDS AP Repeater and WDS Bridge.

Product Kit

The EX2-8 product kit contains the items shown below. If any item is missing or

damaged, contact your local dealer for support.

Product Description

The LEDs are located on the side of the device, while the Ethernet port is located

under the cover along with the RESET button. The external antenna connector is

at the top of the EX2 radio, while the product information is located at the back.

Chapter 1: Overview

DC power adapter

EX2-8 device)

Pole mounting ring

PoE adapter)

LED Panel indicators

MAC address (back)

Ethernet port (inside)

Serial number (back)

RESET button (inside)

External N-male connector

222

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Chapter 1: Overview

1-2

EX2 Series

Tranzeo Wireless Technologies

LED Panel Indicators

Operational Info Color Indicators

PWR

●Green On: Power on

Off: No power

●Amber Blinking: Initializing

LAN ●Green

On: Ethernet connection established

Flashing: Ethernet traffic (Tx/Rx)

Off: No Ethernet connection

SIGNAL INDICATORS

(CPE Mode)

●Red On: Poor wireless connection

●Amber On: Acceptable wireless connection

●Green On: Good wireless connection

ALL LED’s Off: Wireless interface disabled

SIGNAL INDICATORS

(AP Mode)

●Red Off

●Amber Off

●Green Blinking: AP mode enabled

111

This document is intended for Public Distribution

19473 Fraser Way,

Pitt Meadows, B.C. Canada V3Y 2V4

Chapter 2: Hardware Installation

2-1

EX2 Series

Tranzeo Wireless Technologies

The EX2 Series radios are easy to install, as you’ll see in this chapter. Before

starting, you will need to get the tools listed below and decide about the site and

orientation of the device. Once ready, follow the instructions about how to install

the Ethernet cable, mount the device, ground the antenna, and make the

connections in order to get a proper installation.

Getting Ready

Tools Required

To install your EX2 Series radio you will need the following tools:

• Slotted screw driver

• Cat 5 cable stripper x 1

• Cat 5 cable (to connect the radio to the POE adapter)

• RJ-45 patch cable (to connect POE to local LAN network)

• RJ-45 crimper x 1

• RJ-45 connectors x 4

• #6 green grounding wire

Site Selection

Determine the location of the radio before installation. Proper placement of the

device is critical to ensure optimum radio range and performance. You should

perform a site survey to determine the optimal location.

Ensure the CPE is within line-of-sight of the access point. The line-of-sight is an

ellipse, called Fresnel zone. This zone should be clear of obstacles since

obstructions will impede performance of the device.

Chapter 2: Hardware Installation

Tabla de contenidos

Otros manuales de Punto de acceso inalámbrico de Tranzeo

Tranzeo

Tranzeo ER-1000 Manual de usuario

Tranzeo

Tranzeo TR-MX50-15 Manual de usuario

Tranzeo

Tranzeo TR-6000 Manual de usuario

Tranzeo

Tranzeo TR-Series Manual de usuario

Manuales populares de Punto de acceso inalámbrico de otras marcas

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manual de usuario

Ubiquiti

Ubiquiti NanoStation NSM2 Manual de usuario

Cisco

Cisco Aironet 1550 Series Manual de usuario

Aruba

Aruba IAP-335 Manual de usuario

Advantek Networks

Advantek Networks AWN-AP-54MR Manual de usuario

IP-COM

IP-COM AP355 Manual de usuario

Buffalo

Buffalo AirStation WLA-L11G Manual de usuario

EnGenius

EnGenius EnStationACv2 Manual de usuario

D-Link

D-Link DAP-3662 Manual de usuario

xG Technology

xG Technology xMax CN1300 Manual de usuario

Widelink

Widelink ezWave WAP-1100 Series Manual de usuario

Edimax

Edimax CAP1200 Manual de usuario

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manual de usuario

Aruba

Aruba AP-203R Manual de usuario

LuXout Shades

LuXout Shades LUXSHADE MOTION Manual de usuario

CreatComm

CreatComm TB5F Manual de usuario

SineDigital

SineDigital MW-1500AP(H) Manual de usuario

TP-Link

TP-Link AP9650 V1 Manual de usuario