SystemCheck
This function has to be used to check the operation and range of all the devices
once the installation has been carried out. Press the receiver’s CHECK button for
at least 1 second to enter check mode. The indicator light will come on and four
beeps will be heard. Perform a complete door opening and closing maneuver.
During the system check a beep will be heard every 1,5 seconds.
CORRECT OPERATION OF THE SYSTEM
If no other acoustic signal is heard on completing the maneuver, the system is
operating correctly. Either press the CHECK button again or wait 5 minutes and the
receiver will exit checking automatically, indicating with two beeps that the check
has been correct. The check indicator light will go out.
DETECTION OF TRANSMISSION FAILURE
If the communication with a transmitter fails during checking, or the
communication is deficient (for instance, too many communication retries or
poor coverage), the receiver emits three consecutive beeps, indicating that an error
has occurred. Stop the door maneuver and press the safety edges installed to detect
what has failed.
-
If a single beep is heard when pressing a safety edge, this means that the
safety edge is correct.
-
If three consecutive beeps are heard on pressing the safety edge, this means
that the safety edge has failed. In this event, it is recommended changing
the orientation of the transmitting-receiving antennas or installing an AED-
868 or FLAT-868 outdooraerial to ensure the desired range.
On exiting check mode, seven consecutive beeps will be heard and the indicator
light will flash continuously. Perform another system check until the result is correct.
Signal coverage
After pressing one of the installed safety edges, continuous flashes, ranging from
1 to 5, indicate the signal coverage for this safety edge at the time it was pressed.
Number of check LED
flashes Coverage Result of check
1 Very weak Safety edge failure
KOkaeW2
KOdooG4
Total reset of the receiver memory
In the programming mode, keep the programming PROG button pressed down and
make a bridge with the “MR” reset jumper for 3 seconds. The receiver will emit 10
warning beeps and then more at a faster frequency, indicating that the operation
has been carried out. The receiver will stay in programming mode. If 10 seconds
pass without programming a transmitter, the receiver will exit the programming mode,
emitting two 1 second beeps.
8
