Transition Networks J/E-CF-01 Manual de usuario

COMPLIANCE INFORMATION

UL Listed

C-UL Listed (Canada)

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant

to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in which case the user will be

required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on

the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique

édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which

case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes

Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen

werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des

interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques

appropriées

graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

Printed in the U.S.A. 33118.D

The TRANSITION Networks J/E-CF-01 10BASE-T/10BASE-FL media

converters connect either unshielded or shielded 10BASE-T twisted-pair

copper to 10BASE-FL multimode fiber.

For network installation, the J/E-CF-01 media converter provides an RJ-45

twisted pair connector and a set of RX (receive) and TX (transmit) ST

connectors to 850 nm multimode fiber-optic cable.

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE

PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in

damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten

verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur

Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen

einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

Minneapolis, MN 55344 USA

10BASE-T/10BASE-FL Media Converters

J/E-CF-01

USER’S GUIDE

LINK

ACTIVITY

10BASE-T 10BASE-FL

J/E-CF-01

J/E-CF-01 in the Network . . . . . .2

Installation . . . . . . . . . . . . . . . . .3

Operation . . . . . . . . . . . . . . . . . .4

Fault Isolation and Correction . .5

Cable Specifications . . . . . . . . . .6

Technical Specifications . . . . . . .7

Compliance Information . . . . . . .8

J/E-CF-01 IN THE NETWORK

Use the J/E-CF-01 media converter (or two J/E-CF-01 media converters in pairs)

to connect a workstation to a remote hub or to connect two hubs.

TECHNICAL SPECIFICATIONS

Standards IEEE 802.3

Case Dimensions 3.8" x 2.4" x 1.0" (97mm x 61mm x 25mm)

Environment Temperature: 0-50°C (32°to 122°F )

Humidity 5-95%, non condensing

Altitude 0-10,000 feet

Warranty Lifetime

Power Supply Requirements Replace power supply with only the equivalent

input rating (see below) and output rating (regulated 12VDC at 500 mA).

TN PN Requirement Location

25010 240 volts, 50 hertz United Kingdom

25009 230 volts, 50 hertz Europe

25007 120 volts, 60 hertz USA/Canada/Mexico

25020 100 volts, 50-60 hertz Japan

25023 240 volts, 50 hertz Australia

DECLARATION OF CONFORMITY

Name of Mfg: Transition Networks

6475 City West Parkway, Minneapolis MN 55344 USA

Model: 10BASE-T/10BASE-FL Media Converter

Part Number: J/E-CF-01

Regulation: EMC Directive 89/336/EEC

Purpose: To declare that the J/E-CF-01 to which this declaration refers is in

conformity with the following standards.

EMC-CISPR 22: 1985 Class A; EN 55022: 1988 Class A; EN 50082-1:1992;

EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the

above Directive(s) and Standard(s).

_June 7, 1999_____

Stephen Anderson, Vice-President of Engineering Date

2 kilometers - 850 nM multimode

100 meters

20 kilometers - 1300 nM singlemode

5 kilometers - 1300 nM multimode

CABLE SPECIFICATIONS

The physical characteristics of the media cable must meet or exceed IEEE 802.3

specifications.

Fiber Cable

MULTIMODE

Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber

Attentuation: 3.7 dBm/ 1 kilometer @ 850 nm

Maximum Number of Nodes: 2 nodes

Maximum Cable Distance: 2 kilometers (6562 feet) / full-duplex

Media Standards: IEC 793-2, Type A1b, category 3.5 dB/km

Copper Cable and Connector

Category 3 or better twisted-pair copper wire is required. Either shielded

twisted-pair (STP) or unshielded twisted-pair (UTP) can be used. DO

NOT USE FLAT OR SILVER SATIN WIRE.

CATEGORY 3:

Gauge 24 to 22 AWG

Attenuation £11.5 dB/100m @ 5-10 MHz

Maximum Number of Nodes 2 nodes

Maximum Cable Distance 100 meters (200 meters with better cable

RJ-45 Pin-outs Pin 1=TD+, Pin 2=TD-,

Pin 3=RTD+, Pin 6=RD-

Twisted pair connection requires two active pairs configured as straight

through or crossover. The two active pairs in an Ethernet™network are

pins 1 & 2 and pins 3 & 6. Use only dedicated wire pairs (such as

blue/white & white/blue, orange/white & white/orange) for the active pairs.

INSTALLATION

Install Cable

NOTE: See page 6 for cable specifications and configurations.

COPPER

NOTE: KEEP TWISTED PAIR RUNS AS SHORT AS POSSIBLE.

CABLE CONNECTIONS BETWEEN A HUB AND THE MEDIA

CONVERTER MUST BE CONFIGURED AS CROSSOVER . CABLE

CONNECTIONS BETWEEN THE MEDIA CONVERTER AND A

TERMINAL, TRANSCEIVER OR NIC MUST BE CONFIGURED AS

STRAIGHT THROUGH.

•Locate or build 10BASE-T compliant cables with straight-through

or crossover configuration and with male RJ-45 plug connectors.

•Connect male RJ-45 plug connector at one end of cable to Media

Converter RJ-45 jack connector.

•Connect male RJ-45 plug connector at other end of cable to

10BASE-T terminal device RJ-45 jack connector (using straight-

through cable configuration) or to 10BASE-T hub RJ-45 jack

connector (using crossover cable configuration).

FIBER

•Locate or build 10BASE-FL compliant fiber cable with male two-

stranded TX to RX connectors at both ends.

•Connect male TX and RX cable connectors at one end of cable to

TX and RX female connectors, respectively, on Media Converter.

•Connect male TX and RX cable connectors at other end of cable

to RX and TX connectors of 802.3 compliant fiber device.

Connect to Power

•Install Power Adapter cord at back of Media Converter.

•Connect Power Adapter plug to AC power.

•Verify that Media Converter is powered by observing illuminated

LED(s).

Twisted

Pair #1

Twisted

Pair #2

Crossover Cable

Connectors for like devices

Twisted

Pair #1

Twisted

Pair #2

Straight Through Cable

Connectors for unlike devices

OPERATION

After installation, the media converter should function without operator

intervention.

Status LEDs

Use the status LEDs to monitor media converter operation in the network.

LINK (10BASE-T) Dark LED indicates lack of power.

Steady green LED indicates normal

operation.

One (1) blink indicates Link Down.

Five (5) blinks indicates Polarity Reversal.

ACTIVITY (10BASE-T) Flashing amber LED indicates 10BASE-T

activity.

LINK (10BASE-FL) Dark LED indicates lack of power.

Steady green LED indicates normal

operation.

One (1) blink indicates Link Down.

ACTIVITY (10BASE-FL) Flashing amber LED indicates 10BASE-FL

activity.

FAULT ISOLATION and CORRECTION

If the media converter fails, isolate and correct the fault by determining the

answers to the following questions and then taking the indicated action:

1. Are ANY LEDs on the media converter illuminated?

•Is the power adapter the proper voltage and frequency for AC

outlet? NOTE: Refer to “Power Supply Requirements”on page 7.

•Is the power adapter properly installed in the media converter and

in the outlet?

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

YES

•Proceed to step 2.

2. Does the green10BASE-T LINK LED blink once* and go off?

YES

•Check twisted pair cables for proper connection.

•Check straight-through/crossover cable configuration.

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

•Proceed to step 3.

3. Does the green10BASE-FL LINK LED blink once and go off?

YES

•Check fiber cables for proper connection.

•Verify that TX and RX cables on media converter are connected to

RX and TX ports, respectively, on other device.

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

•Proceed to step 4.

4. Is the amber 10BASE-T ACTIVITY LED illuminated?

•Restart the workstation to restart the initialization process.

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

YES

•Proceed to step 5.

5. Is the amber 10BASE-FL ACTIVITY LED illuminated?

•Restart the workstation to restart the initialization process.

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

YES

•Contact Technical Support: (800) 260-1312/(800) LAN-WANS.

*If 10BASE-T Status LED blinks 5 times, media converter is detecting and

automatically correcting polarity reversal in 10BASE-T cable. No action is

necessary.

LINK

ACTIVITY

10BASE-T 10BASE-FL

Tabla de contenidos

Otros manuales de Convertidor de medios de Transition Networks

Transition Networks

Transition Networks SISTF10xx-111-LR(T) Manual de usuario

Transition Networks

Transition Networks SPOEB1011-100 Manual de usuario

Transition Networks

Transition Networks SBFTF1011-140 Manual de usuario

Transition Networks

Transition Networks SGFEB1013-100 Manual de usuario

Transition Networks

Transition Networks E-TBT-FRL-05(L) Manual de usuario

Transition Networks

Transition Networks METTF1011-120 Manual de usuario

Transition Networks

Transition Networks ARCNET C/AR-CF-01(SC) Manual de usuario

Transition Networks

Transition Networks C/E-100BTX-SX-01(SC) Manual de usuario

Transition Networks

Transition Networks CAPTF3311-100 Manual de usuario

Transition Networks

Transition Networks E-TBT-FRL-N-02 Manual de usuario

Transition Networks

Transition Networks E-100BTX-FX-N-01 Manual de usuario

Transition Networks

Transition Networks M/GE-PSW-SX-01 Manual de usuario

Transition Networks

Transition Networks C/E-TBT-FRL-04(L) Manual de usuario

Transition Networks

Transition Networks CDFTF 10 Series Manual de usuario

Transition Networks

Transition Networks E-R-TX-FX-01(SC) Manual de usuario

Transition Networks

Transition Networks J/E-PSW-FX-02(SC) Manual de usuario

Transition Networks

Transition Networks M/GE-PSW-SFP-01 Manual de usuario

Transition Networks

Transition Networks E-TEL-1200 Manual de usuario

Transition Networks

Transition Networks SISTF1011-110-LR Manual de usuario

Transition Networks

Transition Networks SCSCF3011-100 Manual de usuario

Transition Networks

Transition Networks CBFTF10xx-1xx Manual de usuario

Transition Networks

Transition Networks C/E-R-TX-FX-01 Manual de usuario

Transition Networks

Transition Networks SSETF1011-205 Manual de usuario

Transition Networks

Transition Networks SGPOE1013-100 Manual de usuario

Manuales populares de Convertidor de medios de otras marcas

SoundTraxx

SoundTraxx Blunami BLU-2200 Manual de usuario

SPROLINK

SPROLINK VA1 Manual de usuario

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manual de usuario

Nikon

Nikon AF-S TC-20E III Manual de usuario

Axis

Axis AXIS Q7406 Manual de usuario

Omega

Omega TAC80B-J Manual de usuario

Zoom

Zoom Thunderbolt TAC-2R Manual de usuario

OST

OST iConverter 10/100M Manual de usuario

Vertiv

Vertiv Netsure Manual de usuario

birddog

birddog MINI Manual de usuario

Roland

Roland GI-10 Manual de usuario

Wallenstein

Wallenstein WX310 Manual de usuario

Pace

Pace MSS 200-1 Manual de usuario

Solar Converters

Solar Converters EQ 12/24-50 Manual de usuario

CYP

CYP EL-7400V Manual de usuario

TIE

TIE MIDI 1i1o Manual de usuario

DCS

DCS Vivaldi Upsampler Manual de usuario

Westermo

Westermo MCW-211 SERIES Manual de usuario