- 7 -
! When there is only 1 minute remaining in the set time, the Backlight of the Remote Control will light up
automatically, followed by 5 beeps to alert the user.
7 Backlight
The ON/OFF Control Button of the Backlight on the Remote Control
Every time this button is pressed, it will change the condition of the Backlight of the Remote Control is the
sequence of “ON>>OFF” or “OFF>>ON”. When the Backlight is turned on, press this button again, and the
Backlight will go off after 2 minutes.
Remarks: Before the Backlight function is activated, pressing any function button can also activate the
Backlight, and the light will go off with a 30-second delay this way.
Control Buttons for the Massage Chair:
8 Pause
The Pause Button
When the chair is in massage mode and the user wants to temporarily pause it, press the Pause button and all
massage functions will stop. The “Pause” icon will be blinking on the Liquid Crystal Display and the set time
countdown will be paused as well. The chair is now in idle mode. Only the “Pause, Backlight, Recline, Sit
Up, Lift Leg, Recline Leg” can be used Press the Pause button again to immediately cease the “Pause”
function and resume the original massage function. The countdown continues.
9. Auto Scan
The Back Massage Auto Scan Button
The chair is equipped with an Auto Scan function that can be adjusted according to the user’s height for a more
effective massage; this is because the position of the user’s neck, shoulder, back and waist all differs with
each individual. At the same time, the Upward./Downward manual control button helps to provide more
precise massage at the exact point for a more effective and in-depth massage.
Every time this button is pressed, the Auto Scan will scan the body and detect the best massage strength. When
the best massage strength is detected, the Massage Rollers will stop at that position, and the machine beeps
once, the Auto Scan is then completed 5 seconds later.
10/11 The Back Massage Up/Down Level Adjustment Button
For a more comprehensive and comfortable massage, the user can further adjust the height of massage by
pressing the Button within 5 seconds after the beeps. The Massage Rollers will go upwards or downwards
according to your request until you reach your most suitable position .The massage request is set when you let
go of the button and the manual adjustment is achieved.
!
i. It is suggested that the Backrest has to be adjusted to the best angle in order to achieve the most accurate
body scan.
ii. Please sit upright and relax during the process of scanning for the most accurate scanning result.
iii. All four Auto Programs – Healthcare, Relax, Therapy, and Smart are equipped with Auto Scan function,
for please refer to the “Auto Program” section.
1. When the Auto Program for the entire body or localized massage is operating, the strength of the air
pressure can be adjusted by pressing the Back & Seat Intensity Control Button.
2. After activating the Auto Program, both the Vibration and Heat function for the back can be activated
according to individual needs.
A. Full Body Auto Program
If one of the four Auto Programs is activated before the Auto Scan of the entire body, the machine will
automatically do a height scan for the back. At the same time the user can manually adjust the massage
height to the preferred level.
The following are the Auto Programs available:
