TP-Link TL-WA901N Manual de usuario
Specications are subject to change without notice. is a registered trademark of TP-Link Technologies Co., Ltd.
Other brands and product names are trademarks or registered trademarks of their respective holders.
No part of the specications may be reproduced in any form or by any means or used to make any derivative such as
translation, transformation, or adaptation without permission from TP-Link Technologies Co., Ltd.
Copyright © 2019 TP-Link Technologies Co., Ltd. All rights reserved.
www.tp-link.com
7106508557 REV2.0.0
Quick Installation Guide
Guía de Instalación Rápida
Guide d'installation rapide
Guia de Instalação Rápida
Wireless Access Point
Images are for demonstration only.
For technical support, the user guide and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
CONTENTS
01 / English
06 / Español
11 / Français
16 / Português
1
English
Note: TL-WA901N is used for demonstration in this installation guide.
Before You Start
Which mode do you need? Please refer to the table to choose a proper mode.
Scenarios Operating Modes
You want to convert your wired (Ethernet) network to a wireless network. Access Point Mode (Default Mode)
You are in a Wi-Fi dead-zone or a place with weak wireless signal. You
want to have a greater eective range of the wireless signal throughout
your home or oce.
Range Extender Mode
You have a wired device with an Ethernet port and no wireless capability,
for example, a Smart TV, Media Player, or game console. You want to
connect it to the Internet wirelessly.
Client Mode
You want your devices connected to different wireless networks and
isolated by VLANs. Multi-SSID Mode
Connect the AP Device
1. Connect the AP device according to steps in the diagram.
2. Turn on the power, wait until the Power ( ) and Wireless ( ) LEDs are lit and stable, and use the
default SSID and Password printed on the product label to join the AP device’s Wi-Fi network.
Note: For a dual-band AP device, both the 2.4GHz and 5GHz Wireless ( ) LEDs should be lit and stable.
2
English
• Access Point Mode (Default)
Existing Router
Internet
TL-WA901N’s SSID
A
B
C
D
Note: You can enjoy internet surng now. For your wireless network security, it is recommended to change the default SSID (network
name) and the password of your Wi-Fi network. To do so, refer to Congure the AP Device.
• Range Extender Mode
Internet Host AP’s SSID TL-WA901N’s SSID
A
B
OR OR
TV Other
Wired
Devices
Transforms your existing wired network to a wireless one.
Extends the range of an existing Wi-Fi network.
3
English
• Client Mode
Internet Host AP’s SSID
A
B
OR OR
TV Other
Wired
Devices
• Multi-SSID Mode
SSID 1 for VLAN 1
SSID 2 for VLAN 2
SSID 3 for VLAN 3
SSID 4 for VLAN 4
VLAN 1
VLAN 2
VLAN 3
VLAN 4
Existing Router
Internet
C
D A
B
Connects your wired devices to a wireless network.
Creates multiple wireless networks to provide dierent security and VLAN groups.
4
English
Congure the AP Device
1. Launch a web browser and enter http://tplinkap.net. Create a password to log in.
2. Click Quick Setup, select your corresponding mode and click Next. Follow the step-by-step
instructions to complete the conguration.
3. Now, reconnect your devices to the AP device.
Note: In Client mode, only the wired connected devices can enjoy the internet surng.
In Multi-SSID mode, connect your wireless devices to the dierent Wi-Fi networks to be isolated by VLANs.
Power on via PoE Injector
Power the device with the included passive PoE injector when the device is located far from a power outlet.
Note: The passive PoE injector supports a cable length up to 30 meters due to the environment.
Passive PoE InjectorExisting Router
Internet
TL-WA901N’s SSID
5
English
Frequently Asked Questions (FAQ)
Q1. How do I restore the AP device to its factory default settings?
With the device powered on, use a pin to press and hold the Reset button until the Power LED starts blinking, then
release the button.
Note: Upon resetting, all previous congurations will be cleared, and the AP device will reset to the default Access Point Mode.
Q2. What can I do if the login window does not appear?
• Change the computer's static IP address to obtain an IP address automatically.
• Verify if http://tplinkap.net or http://192.168.0.254 is correctly entered in the web browser.
• Use another web browser and try again.
• Reboot your AP device and try again.
• Power o your host AP and enter http://tplinkap.net into the web browser to try again.
Q3. How do I recover the AP device’s web management password or retrieve my Wi-Fi password?
• If you forget the password required to access the AP device's web management page, you must restore the AP
device to its factory default settings.
• If you forget your Wi-Fi password, but are able to access the AP device's management interface, connect a
computer or mobile device to the AP device via wired or wireless. Log in and go to Wireless > Wireless Security
to retrieve or reset your Wi-Fi password.
Q4. What can I do if my wireless is not stable?
It may be caused by too much interference, you can try the following methods:
• Set your wireless channel to a dierent one.
• Move the AP device to a new location away from Bluetooth devices and other household electronics, such as
cordless phone, microwave, and baby monitor and more, to minimize signal interference.
6
Español
Nota: El TL-WA901N se usa para demostración en esta guía de instalación.
Antes de que comience
¿Qué modo necesita? Por favor consulte la tabla para seleccionar un modo adecuado.
Escenarios Modos de Operación
Desea convertir su red conectada por cable (Ethernet) en una red
inalámbrica.
Modo de Punto de Acceso (Modo
Predeterminado)
Si se encuentra en una zona sin recepción de Wi-Fi o un lugar con señal
inalámbrica débil. Desea tener un rango efectivo mayor de la señal
inalámbrica en toda su casa u ocina.
Modo Extensor de Rango
Tiene un dispositivo conectado por cable con un puerto Ethernet y sin
capacidad inalámbrica, por ejemplo, una Smart TV, Reproductor Multimedia,
o Consola de juegos. Desea conectarlo a Internet inalámbricamente.
Modo Cliente
Desea sus dispositivos conectados a diferentes redes inalámbricas y
aislados por VLANs. Modo Multi-SSID
Conectar el Punto de Acceso
1. Conectar el dispositivo de acuerdo a los pasos en el diagrama.
2. Encender la energía eléctrica, esperar hasta que los LEDS de Encendido ( ) e Inalámbrico ( )
están encendidos y estables, y usan el SSID y Contraseña predeterminados impresos en la etiqueta
del producto para unirse a la red Wi-Fi del Punto de Acceso.
Nota: Para un dispositivo AP de doble banda, los LED de 2.4GHz y 5GHz inalámbricos deben estar( ) encendidos y estables.
7
Español
• Modo de Punto de Acceso (Predeterminado)
Router Existente
Internet
TL-WA901N’s SSID
A
B
C
D
Nota: Ahora puede disfrutar de la navegación por Internet. Para la seguridad de su red inalámbrica, se recomienda que cambie el SSID
(nombre de la red) y la contraseña predeterminados de su red Wi-Fi. Para hacer esto, consulte la sección de Congurar el Punto de Acceso.
• Modo Extensor de Rango
Internet SSID del AP principal TL-WA901N’s SSID
A
B
O O
TV Otros
dispositivos
por cable
Transforma su red por cable en una red inalámbrica.
Extiende el rango de una red Wi-Fi existente.
8
Español
• Modo Cliente
Internet
A
B
O O
TV Otros
dispositivos
por cable
SSID del AP principal
• Modo Multi-SSID
SSID 1 para VLAN 1
SSID 2 para VLAN 2
SSID 3 para VLAN 3
SSID 4 para VLAN 4
VLAN 1
VLAN 2
VLAN 3
VLAN 4
Internet
C
D A
B
Router Existente
Conecte sus dispositivos vía cable a una red inalámbrica.
Crea múltiples redes inalámbricas para proporcionar diferentes grupos VLAN y de seguridad.
Otros manuales para TL-WA901N
3
Tabla de contenidos
Idiomas:
Otros manuales de Punto de acceso inalámbrico de TP-Link
TP-Link
TP-Link TL-WA1201 Manual de usuario
TP-Link
TP-Link Auranet EAP225 Manual de usuario
TP-Link
TP-Link Omada EAP230-Wall Manual de usuario
TP-Link
TP-Link Pharos CPE210 Manual de usuario
TP-Link
TP-Link Auranet EAP225 Manual de usuario
TP-Link
TP-Link Omada EAP225-Wall Manual de usuario
TP-Link
TP-Link Omada EAP610 Manual de usuario
TP-Link
TP-Link TL-WA701ND Manual de usuario
TP-Link
TP-Link Auranet EAP110 Manual de usuario
TP-Link
TP-Link AURANET EAP110-Outdoor Manual de usuario
TP-Link
TP-Link Auranet EAP110 Manual de usuario
TP-Link
TP-Link CPE205 Manual de usuario
TP-Link
TP-Link Deco X50-PoE Manual de usuario
TP-Link
TP-Link Omada EAP115 Manual de usuario
TP-Link
TP-Link TL-WA1201 Manual de usuario
TP-Link
TP-Link Auranet EAP110 Manual de usuario
TP-Link
TP-Link Auranet EAP110 Manual de usuario
TP-Link
TP-Link Archer AX10 Manual de usuario
TP-Link
TP-Link Omada EAP615-Wall V1 Manual de usuario
TP-Link
TP-Link Omada EAP Series Manual de usuario
