TP-Link TL-SG1024DE Manual de usuario

Business Networking Solution

Installation Guide

16/24-Port Gigabit Easy Smart Switch

TL-SG1016DE/TL-SG1024DE/TL-SG1016PE

IAbout this Installation Guide

About this Installation Guide

This Installation Guide describes the hardware characteristics, installation methods and the

points that should be attended to during installation. This Installation Guide is structured as

follows:

Chapter 1 Introduction.

This chapter describes the external components of the switch.

Chapter 2 Installation.

This chapter illustrates how to install the switch.

Chapter 3 Lightning Protection.

This chapter illustrates how to prevent lightning damage.

Chapter 4 Connection.

This chapter illustrates how to do the physical connection of the switch.

Chapter 5 Configuration.

This chapter instructs you to configure the switch via Web Interface.

Appendix A Troubleshooting.

Appendix B Specifications.

Audience

This Installation Guide is for:

Network Engineer

Network Administrator

Conventions

• Some models featured in this guide may be unavailable in your country or region. For local sales

information, visit http://www.tp-link.com.

• The figures in Chapter 2 to Chapter 4 are for demonstration purposes only. Your switch may differ

in appearance from that depicted.

• This Guide uses the specific formats to highlight special messages. The following table lists the

notice icons that are used throughout this guide.

Remind to be careful. A caution indicates a potential which may result in device damage.

Remind to take notice. The note contains the helpful information for a better use of the

product.

II Related Document

Related Document

This Installation Guide is also available in PDF on our website. To obtain the latest

documentation and product information, please visit the official website:

http://www.tp-link.com

III

Contents

Chapter 1 Introduction ——————————— 01

1.1 Product Overview ...........................................................01

1.2 Appearance.......................................................................01

Chapter 2 Installation ——————————— 06

2.1 Package Contents ..........................................................06

2.2 Safety Precautions .........................................................06

2.3 Installation Tools..............................................................08

2.4 Product Installation ........................................................09

Chapter 3 Lightning Protection ——————— 11

3.1 Cabling Reasonably........................................................11

3.2 Connect to Ground.........................................................13

Chapter 4 Connection ——————————— 17

4.1 Ethernet Port ....................................................................17

4.2 Verify Installation.............................................................17

4.3 Power On............................................................................17

4.4 Initialization........................................................................18

Chapter 5 Conguration —————————— 19

Appendix A Troubleshooting ———————— 21

Appendix B Specications ————————— 22

16/24-Port Gigabit Easy Smart Switch

Introduction

Chapter 1 Introduction

1.1 Product Overview

The 16/24-Port Gigabit Easy Smart Switch is an ideal upgrade from an unmanaged

switch, designed for Small and Medium Business networks that require simple network

management. Network administrators can effectively monitor traffic via Port Mirroring,

Loop Prevention and Cable Test features. To optimize traffic on your business network,

they offer both port and tag based QoS to keep latency-sensitive traffic moving

smoothly and jitter-free. Additionally, port-based, tag-based and MTU VLAN can

improve security and meet more network segmentation requirements. Moreover, with

the innovative energy-efficient technology, they are eco-friendly solution for your

business network.

TL-SG1016PE is a Power Sourcing Equipment (PSE*). The 8 Auto-Negotiation RJ45

ports support Power over Ethernet (PoE*) function, which can automatically detect and

supply power with those IEEE802.3af/IEEE802.3at-compliant powered devices (PDs*).

Note:

■*PSE is a device (switch or hub for instance) that will provide power in a PoE setup.

■*PoE is a technology that describes a system to transmit electrical power, along

with data, to remote devices over standard twisted-pair cable in an Ethernet

network.

■*PD is a device powered by a PSE and thus consumes energy. Examples include

powering IP telephones, wireless LAN access points, network cameras, network

hubs, embedded computers etc.

1.2 Appearance

■Front Panel

The front panel of TL-SG1016DE is shown as the following figure.

Figure 1-1 Front Panel of TL-SG1016DE

Reset 10/100/1000Mbps RJ45 PortLEDs

16/24-Port Gigabit Easy Smart Switch

Introduction

The front panel of TL-SG1024DE is shown as the following figure.

Figure 1-2 Front Panel of TL-SG1024DE

Reset 10/100/1000Mbps RJ45 PortLEDs

LEDs

LED Status Indication

Power On The switch is powered on.

Off The switch is powered off or power supply is abnormal.

Link/Act

On There is a device linked to the corresponding port but no

activity.

Flashing The corresponding port is transmitting or receiving data.

Off There is no device linked to the corresponding port.

1000Mbps

On A 1000Mbps device is connected to the corresponding port.

Off A 10/100Mbps device or no device is connected to the

corresponding port.

Reset

Press this button for five seconds or above to reset the software setting back to

factory default settings.

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or

1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED.

The front panel of TL-SG1016PE is shown as the following figure.

Figure 1-3 Front Panel of TL-SG1016PE

Reset 10/100/1000Mbps RJ45 PortLEDs

16/24-Port Gigabit Easy Smart Switch

Introduction

LEDs

LED Status Indication

PWR On The switch is powered on.

Off The switch is powered off or power supply is abnormal.

Speed

On Green The corresponding port is running at 1000Mbps.

Yellow The corresponding port is running at 10/100Mbps.

Flashing The corresponding port is transmitting or receiving

data.

Off There is no device linked to the corresponding port.

PoE Status

On The port is connecting and supplying power to a PD.

Flashing

The PoE power circuit may be in short, the power

current may be overloaded or non-standard PD is

connected.

Off

No PD is connected to the corresponding port, or no

power is supplied according to the power limits of the

port.

PoE Max

The power of all the connected PoE ports is between

103W and 110W. No power may be supplied if additional

PDs are connected.

Flashing The power of all the connected PoE ports is ≥110W.

Off The power of all the connected PoE ports is <103W.

FAN Green The fan works properly.

Yellow The fan doesn't work properly.

Reset

Press this button for five seconds or above to reset the software setting back to

factory default settings.

10/100/1000Mbps RJ45 Port and PoE Port

TL-SG1016PE switch is equipped with 16 10/100/1000Mbps Auto-Negotiation RJ45

ports and 8 of them support PoE function.

The 16 10/100/1000Mbps RJ45 ports are designed to connect to the device with a

bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Link/Act

LED.

8 of 10/100/1000Mbps RJ45 ports also support PoE function which integrates

power and data onto one Ethernet cable. The working status can be indicated by the

PoE MAX LED and PoE Status LEDs on the front panel.

16/24-Port Gigabit Easy Smart Switch

Introduction

■Rear Panel

The rear panel of TL-SG1016DE is shown as the following figure.

Figure 1-4 Rear Panel of TL-SG1016DE

Grounding Terminal Power Socket

The rear panel of TL-SG1024DE is shown as the following figure.

Figure 1-5 Rear Panel of TL-SG1024DE

Grounding Terminal Power Socket

The rear panel of TL-SG1016PE is shown as the following figure.

Figure 1-6 Rear Panel of TL-SG1016PE

Grounding TerminalPower SocketKensington Security Slot

Grounding Terminal

The switch already comes with lightning protection mechanism. You can also ground

the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.

For detailed information, please refer to Chapter 3 Lightning Protection.

Kensington Security Slot

Secure the lock (not provided) into the security slot to prevent the device from being

stolen.

16/24-Port Gigabit Easy Smart Switch

Introduction

Power Socket

Connect the female connector of the power cord here, and the male connector to

the AC (Alternating Current) power outlet. Please make sure the voltage of the power

supply meets the requirement of the input voltage.

Caution:

Please use the provided power cord.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de TP-Link

TP-Link

TP-Link TL-SG105E Manual de usuario

TP-Link

TP-Link TL-SG605E Manual de usuario

TP-Link

TP-Link TL-SF1008D - 10/100M FAST ETHERNET SWITCH Manual de usuario

TP-Link

TP-Link Omada DS105GP Manual de usuario

TP-Link

TP-Link TL-SG1005P Manual de usuario

TP-Link

TP-Link LS105LP Manual de usuario

TP-Link

TP-Link JetStream TL-SL5428E Manual de instrucciones

TP-Link

TP-Link TL-SG5426 - Manual de usuario

TP-Link

TP-Link TL-SF1008P Manual de usuario

TP-Link

TP-Link tapo S505 Manual de usuario

TP-Link

TP-Link HS220 Manual de usuario

TP-Link

TP-Link JetStream TL-SL3452 Manual de usuario

TP-Link

TP-Link TL-SG1016DE Manual de usuario

TP-Link

TP-Link TL-SG1016DE Manual de usuario

TP-Link

TP-Link Omada SG2218P Manual de usuario

TP-Link

TP-Link JetStream T1500G-10MPS Guía de inicio rápido

TP-Link

TP-Link TL-SG105 Manual de usuario

TP-Link

TP-Link T2500G-10MPS Manual de usuario

TP-Link

TP-Link TL-SG105-M2 V2 Manual de usuario

TP-Link

TP-Link TL-SG2452 Manual de usuario

TP-Link

TP-Link JetStream TL-SG3424P Manual de usuario

TP-Link

TP-Link JetStream TL-SG3424 Manual de usuario

TP-Link

TP-Link TL-SL3226P Manual de usuario

TP-Link

TP-Link JetStream T1600G-28TS Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario