TP-Link T3700G-28TQ Manual de usuario

Installation Guide

Stackable L3 Managed Switch

T3700G-28TQ

Business Networking Solution



Specifications are subject to change without notice. is a registered trademark of TP-LINK

TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative such

as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright

http://www.tp-link.com



This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.1)

This device must accept any interference received, including interference that may cause undesired operation.2)

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.



This is a class A product. In a domestic environment, this product may cause radio interference, in which case the

user may be required to take adequate measures.

Related Document



The User Guide and CLI Reference Guide of the product are provided on the resource

CD.

To obtain the latest product information, please visit the Official Website:

http://www.tp-link.com



This Installation Guide describes the hardware characteristics, installation methods and

the points that should be attended to during installation.

This Installation Guide is structured as follows:

Chapter 1 Introduction. This chapter describes the External Components of the

switch.

Chapter 2 Preparing For Installation. This chapter illustrates the safety precautions

before installing the switch.

Chapter 3 Installation. This chapter illustrates how to install the switch.

Chapter 4 Lightning Protection. This chapter illustrates how to prevent lightning

damage.

Chapter 5 Connection. This chapter illustrates how to do the physical connection of

the switch.

Chapter 6 Configuration. This chapter instructs you to configure the switch via Web

Interface and CLI commands.

Appendix A Troubleshooting.

Appendix B Hardware Specifications.

Appendix C Technical Support.

III

Audience



This Installation Guide is for:

Network Engineer

Network Administrator



This guide uses the specific formats to highlight special messages. The following table

lists the notice icons that are used throughout this guide.

Remind to be careful. A caution indicates a potential which may

result in device damage.

Remind to take notice. The note contains the helpful

information for a better use of the product.

Contents



Chapter 1 Introduction ———————————— 01

1.1 Product Overview.........................................01

1.2 Appearance .................................................01

Chapter 2 Preparing For Installation —————— 05

2.1 Package Contents.........................................05

2.2 Safety Precautions........................................05

2.3 Installation Tools..........................................07

2.4 Installation & Connection Flow ......................07

Chapter 3 Installation ————————————— 09

3.1

Installing the Switch on a Desktop

....................09

3.2

Installing the Switch Into a 19-inch Rack

...........09

3.3

Installing & Removing the Power Supply Module

...10

3.4

Installing & Removing the Interface Card

........11

3.5

Stacking Using Interface Card on Rear Panel

....12

Chapter 4 Lightning Protection ———————— 14

4.1 Cabling Reasonably ......................................14

4.2 Connect to Ground .......................................16

4.3 Equipotential Bonding...................................17

4.4 Use Lightning Arrester ..................................18

Chapter 5 Connection ————————————— 19

5.1 Ethernet Port ...............................................19

5.2 SFP Port ......................................................19

5.3 Console Port ................................................19

5.4 Verify Installation .........................................20

5.5 Power on via Power Supply Module .............20

5.6 Power on via Redundant Power Supply .........21

5.7 Initialization.................................................22

Chapter 6 Conguration———————————— 23

6.1 Congure the Switch via GUI ........................23

6.2 Congure the Switch Using CLI .....................24

Contents

Appendix A Troubleshooting—————————— 29

Appendix B Hardware Specications —————— 30

Appendix C Technical Support ————————— 31

Stackable L3 Managed Switch





T3700G-28TQ is TP-LINK’s JetStream Stackable L3 Managed Switch, supporting up to

4 SFP+ slots. T3700G-28TQ is ideal for large businesses, campuses or SMB networks

requiring an outstanding, reliable and affordable 10 Gigabit solution.

T3700G-28TQ supports stacking of up to 8 units, thus providing flexible scalability

and protective redundancy for your networks. Moreover, aiming to better protect your

network, T3700G-28TQ’s main power is removable. With the help of TP-LINK’s RPS,

administrators can easily change its main power if it encounters some problems without

shutting down the switch, thus enabling your network to really enjoy the benefit of

uninterrupted operation.



Front Panel

■

The front panel of T3700G-28TQ is shown as the following figure.

Console Port

LEDs

SFP Port

10/100/1000Mbps RJ45 Port

SFP+ Port

Unit ID LED

Front Panel of T3700G-28TQFigure 1-1

Console Port

Designed to connect with the serial port of a computer or terminal for monitoring

and configuring the switch.

LEDs

LED Status Indication

Power

On The switch is powered on

Off The switch is powered off or power supply is abnormal

Flashing Power supply is abnormal

System Flashing The switch works properly

On/Off The switch works improperly

RPS

Green Both the built-in power supply and the redundant

power supply work properly

Yellow

The built-in power supply works improperly, but the

redundant power supply works properly

Off The switch is not connected to any redundant power

supply

Introduction

Stackable L3 Managed Switch

LED Status Indication

FAN Green All the fans work properly

Yellow Not all the fans work properly

Master On The switch works as master in the stack system, or

does not join any stack system

Off The switch works as slave in the stack system

Module

On(green) An Interface Card is connected to the switch and works

properly

Flashing(yellow) An Interface Card is connected to the switch, but

works improperly

Off No Interface Card is connected to the switch

Link/Act

(Port 1-24)

Green On A 1000Mbps device is connected to the corresponding

port, but no activity

Flashing Data is being transmitted or received

Yellow On

A 10/100Mbps device is connected to the corresponding

port, but no activity

Flashing Data is being transmitted or received

Off No device is connected to the corresponding port

21F-24F

On An SFP transceiver is connected to the corresponding

port, and it is connected to a device, but no activity

Flashing A 1000Mbps device is connected to the corresponding

port and transmitting data

Off

An SFP transceiver is connected to the corresponding

port, but it is not connected to a device, or no SFP

transceiver is connected

25, 26

An SFP+ transceive r/cable is connected to the

corresponding port, and it is connected to a 10Gbps

device, but no activity

Flashing A 10Gbps device is connected to the corresponding

port and transmitting data

Off

An SFP+ transceive r/cable is connected to the

corresponding port, but it is not connected to a device,

or no SFP+ transceiver/cable is connected

M1,M2

An SFP+ transceive r/cable is connected to the

corresponding port of the Interface Card, and it is

connected to a 10Gbps device, but no activity

Flashing A 10Gbps device is connected to the corresponding

port of the Interface Card

and transmitting data

Off

An SFP+ transceive r/cable is connected to the

corresponding port of the Interface Card, but it is not

connected to a device, or no SFP+ transceiver/cable is

connected to the Interface Card, or no Interface Card

is connected

Introduction

Stackable L3 Managed Switch

Port Feature

Model 10/100/1000Mbps

RJ45 Port

Console

Port

1000Mbps

SFP Port

10Gbps SFP+

Port

T3700G-28TQ 24 1 4(Combo) 4 (2 fixed + 2

optional)

10/100/1000Mbps Port

Port 1-24, designed to connect to the device with a bandwidth of 10Mbps, 100Mbps

or 1000Mbps. Each has a corresponding 10/100/1000Mbps LED.

SFP Port

Port 21F-24F, designed to install the SFP transceiver. These four SFP transceiver slots

are shared with the associated RJ45 ports. The associated two ports are referred as

a “Combo”port, which means they cannot be used simultaneously, otherwise only

SFP port works.

SFP+ Port

Port 25-26, designed to install the 10Gbps SFP+ transceiver or SFP+ cables.

T3700G-28TQ also provides an interface card slot on the rear panel to install the

expansion card (TX432 of TP-LINK for example). If TX432 is installed, you get

another two 10Gbps SFP+ ports.

Unit ID LED

Designed to display the stack unit ID of the switch. For the switch that does

not join any stack system, it displays its default unit ID. To modify the default

unit number, please logon to the GUI of the switch and go to Stack→Stack

Management→Switch Renumber page.

Rear Panel

■

The rear panel of T3700G-28TQ is shown as the following figure.

Power

PS OK

Fault

PSM150-AC

100-240V~ 50/60Hz 2.5A

Grounding Terminal

RPS Input Connector

Interface Card Slot

Power Supply Module

Rear Panel of T3700G-28TQ (1)Figure 1-2

Note: The Interface Card Slot, RPS Input Connector and AC Power Supply Module Slot

are shipped with protective covers.

Interface Card Slot

Designed to extend the interfaces. You can select an Interface Card (TX432 of TP-

LINK for example) for your switch if needed. For how to install an Interface Card,

please refer to 3.4 Installing & Removing the Interface Card.

Introduction

Otros manuales para T3700G-28TQ

Tabla de contenidos

Otros manuales de Cambiar de TP-Link

TP-Link

TP-Link JetStream L2 Lite TL-SG3210 Manual de usuario

TP-Link

TP-Link JetStream T1600G-28TS Manual de usuario

TP-Link

TP-Link HS200 Manual de usuario

TP-Link

TP-Link TL-SG105 Manual de usuario

TP-Link

TP-Link Kasa KS200M Manual de usuario

TP-Link

TP-Link Omada DS105G-M2 Manual de usuario

TP-Link

TP-Link JetStream T3700G-52TQ Manual de instrucciones

TP-Link

TP-Link TL-SF1008D - 10/100M FAST ETHERNET SWITCH Manual de usuario

TP-Link

TP-Link HS200 Manual de usuario

TP-Link

TP-Link UH700 Manual de usuario

TP-Link

TP-Link TL-SG105 Manual de instrucciones de instalación

TP-Link

TP-Link TL-SF1005D Manual de usuario

TP-Link

TP-Link TL-SL5428 Manual de usuario

TP-Link

TP-Link TL-SG105E Manual de usuario

TP-Link

TP-Link TL-SF1008D - 10/100M FAST ETHERNET SWITCH Manual de usuario

TP-Link

TP-Link TL-SG2216 Manual de usuario

TP-Link

TP-Link JetStream TL-SG2210P Manual de usuario

TP-Link

TP-Link JetStream TL-SG2210P Manual de usuario

TP-Link

TP-Link JetStream TL-SL3452 Manual de usuario

TP-Link

TP-Link HS220 Manual de usuario

TP-Link

TP-Link TL-SG1005D Manual de usuario

TP-Link

TP-Link TL-SF1005D Manual de usuario

TP-Link

TP-Link UH400 Manual de usuario

TP-Link

TP-Link TL.SFI OOSD Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario