TP-Link JetStream T1600G-28TS Manual de usuario

Installation Guide

JetStream Gigabit Smart Switch

T1600G-28TS (TL-SG2424)

T1600G-52TS (TL-SG2452)

Business Networking Solution

Specifications are subject to change without notice. is a registered trademark

of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of their

respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make

any derivative such as translation, transformation, or adaptation without permission from TP-LINK

http://www.tp-link.com

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

CE Mark Warning

This is a Class A product. In a domestic environment, this product may cause radio interference, in

which case the user may be required to take adequate measures.

Related Document

III Contents

Contents

Chapter 1 Introduction ———————————— 01

1.1 Product Overview.....................................01

1.2 Appearance................................................... 01

Chapter 2 Installation ———————————— 05

2.1 Package Contents.....................................05

2.2 Safety Precautions....................................05

2.3 Installation Tools......................................07

2.4 Product Installation ..................................08

Chapter 3 Lightning Protection ———————— 10

3.1 Cabling Reasonably ..................................10

3.2 Connect to Ground ...................................12

3.3 Equipotential Bonding...............................13

3.4 Use Lightning Arrester ..............................14

Chapter 4 Connection ———————————— 16

4.1 Ethernet Port ...........................................16

4.2 SFP Port ..................................................16

4.3 Verify Installation .....................................16

4.4 Power On ................................................17

4.5 Initialization.............................................17

Chapter 5 Conguration ——————————— 18

5.1 Congure the Switch via GUI ....................18

5.2 Congure the Switch Using CLI .................19

Appendix A Troubleshooting—————————— 21

Appendix B Hardware Specications —————— 22

JetStream Gigabit Smart Switch

Introduction

Chapter 1 Introduction

1.1 Product Overview

TP-LINK Gigabit Smart Switch, designed for workgroups and departments, provides

wire-speed performance and abundant L2 and L2+ management features. It provides a

variety of service features and multiple powerful functions with high security.

The EIA-standardized framework and smart configuration capacity can provide flexible

solutions for a variable scale of networks. QoS and IGMP snooping/filtering optimize

voice and video application. Link aggregation increases aggregated bandwidth,

optimizing the transport of business critical data. SNMP, RMON, WEB/Telnet Log-in

bring abundant management policies. TP-LINK Gigabit Smart Switch integrates multiple

functions with excellent performance, and is friendly to manage, which can fully meet

the need of the users demanding higher networking performance.

1.2 Appearance

■Front Panel

The front panel of T1600G-28TS is shown as the following figure.

LEDs

10/100/1000Mbps RJ45 Port

SFP Port

Reset

Figure 1-1 Front Panel of T1600G-28TS

LEDs

LED Status Indication

PWR On The switch is powered on.

Off The switch is powered off or power supply is abnormal.

SYS Flashing The switch is working normally.

On/Off The switch is working abnormally.

Link/Act

On There is a device linked to the corresponding port but no

activity.

Flashing The corresponding port is transmitting or receiving data.

Off There is no device linked to the corresponding port.

JetStream Gigabit Smart Switch

LED Status Indication

1000Mbps

On A 1000Mbps device is connected to the corresponding port.

Off A 10/100Mbps device or no device is connected to the

corresponding port.

Reset

Press this button for 5 seconds or above to reset the software setting back to

factory default settings.

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or

1000Mbps. Each has a corresponding Link/Act LED and a 1000Mbps LED.

SFP Port

Designed to install the SFP module. T1600G-28TS features 4 individual SFP ports

and supports 1000M SFP module connection only.

The front panel of T1600G-52TS is shown as the following figure.

10/100/1000Mbps RJ45 Port

SFP Port

LEDs

RESET

Figure 1-2 Front Panel of T1600G-52TS

Reset

Press this button for 5 seconds or above to reset the software setting back to

factory default settings.

LEDs

LED Status Indication

PWR

On The switch is powered on.

Off The switch is powered off or power supply is

abnormal.

Flashing Power supply is abnormal.

SYS Flashing The switch works properly.

On/Off The switch works improperly.

Introduction

JetStream Gigabit Smart Switch

Introduction

LED Status Indication

10/100/

1000Mbps

(port 1-48)

Green On A 1000Mbps device is connected to the corresponding

port, but no activity.

Flashing Data is being transmitted or received.

Yellow On A 10/100Mbps device is connected to the

corresponding port, but no activity.

Flashing Data is being transmitted or received.

Off No device is connected to the corresponding port.

Link/Act

(port 49-52)

On There is a device linked to the corresponding SFP port

but no activity.

Flashing The corresponding SFP port is transmitting or

receiving data.

Off There is no device linked to the corresponding SFP

port.

10/100/1000Mbps RJ45 Port

Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or

1000Mbps. Each has a corresponding 1000Mbps LED.

SFP Port

Designed to install the SFP module. T1600G-52TS features 4 individual SFP ports

and supports 1000M SFP module connection only.

Port Feature

Model 10/100/1000Mbps RJ45 Port SFP Port

T1600G-28TS 24 4

T1600G-52TS 48 4

■Rear Panel

The rear panel of T1600G-28TS/T1600G-52TS features a Kensington security slot, a

grounding terminal and a power socket. Here we take T1600G-28TS for example.

Grounding Terminal

Power Socket

Kensington Security Slot

Figure 1-3 Rear Panel

Kensington Security Slot

Secure the lock (not provided) into the security slot to prevent the device from being

stolen.

JetStream Gigabit Smart Switch

Introduction

Grounding Terminal

The switch already comes with lightning protection mechanism. You can also ground

the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable.

For detailed information, please refer to Chapter 3 Lightning Protection.

Power Socket

Connect the female connector of the power cord here, and the male connector to

the AC (Alternating Current) power outlet. Please make sure the voltage of the

power supply meets the requirement of the input voltage.

Caution: Please use the provided power cord.

JetStream Gigabit Smart Switch

Chapter 2 Installation

2.1 Package Contents

Make sure that the package contains the following items. If any of the listed items is

damaged or missing, please contact your distributor.

One Resource CD

One Switch One Power Cord This Installation Guide

Two Mounting Brackets and the

Fittings

2.2 Safety Precautions

To avoid any device damage and bodily injury caused by improper use, please observe

the following rules.

■Safety Precautions

■Keep the power off during the installation.

■Wear an ESD-preventive wrist strap, and make sure that the wrist strap has a good

skin contact and is well grounded.

■Use only the power cord provided with the switch.

■Make sure that the supply voltage matches the specifications indicated on the rear

panel of the switch.

■Ensure the vent hole is well ventilated and unblocked.

■Do not open or remove the cover of the switch.

■Before cleaning the device, cut off the power supply. Do not clean it by the waterish

cloth, and never use any other liquid cleaning method.

Installation

JetStream Gigabit Smart Switch

■Site Requirements

Temperature/Humidity



ȭ

Please keep a proper temperature and humidity in the equipment room. Too high/low

humidity may lead to bad insulation, electricity leakage, mechanical property changes

and corrosions. Too high temperature may accelerate aging of the insulation materials

and can thus significantly shorten the service life of the device. For normal temperature

and humidity of the device, please check the following table.

Environment Temperature Humidity

Operating 0℃~ 40℃10% ~ 90%RH Non-condensing

Storage -40℃~ 70℃5% ~ 90%RH Non-condensing

Clearness

The dust accumulated on the switch can be absorbed by static electricity and result

in poor contact of metal contact points. Some measures have been taken for the

device to prevent static electricity, but too strong static electricity can cause deadly

damage to the electronic elements on the internal circuit board. To avoid the effect of

static electricity on the operation of the switch, please attach much importance to the

following items:

■Dust the device regularly, and keep the indoor air clean.

■Keep the device well grounded and ensure static electricity has been transferred.

Electromagnetic Interference

Electronic elements including capacitance and inductance on the device can be affected

by external interferences, such as conducted emission by capacitance coupling,

inductance coupling, and impedance coupling. To decrease the interferences, please

make sure to take the following measures:

■Use the power supply that can effectively filter interference from the power grid.

■Keep the device far from high-frequency, strong-current devices, such as radio

transmitting station.

■Use electromagnetic shielding when necessary.

Installation

Otros manuales para JetStream T1600G-28TS

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de TP-Link

TP-Link

TP-Link TL-SG2452 Manual de usuario

TP-Link

TP-Link JetStream L2 Lite TL-SG3210 Manual de instrucciones

TP-Link

TP-Link LiteWave LS105G Manual de usuario

TP-Link

TP-Link TL-SG105S Manual de usuario

TP-Link

TP-Link JetStream TL-SL5428E Manual de instrucciones

TP-Link

TP-Link TL-SL2218 Manual de usuario

TP-Link

TP-Link TL-SG1008PE Manual de usuario

TP-Link

TP-Link TL-SG1428PE Manual de usuario

TP-Link

TP-Link TL-SG1016PE Manual de usuario

TP-Link

TP-Link HS200 Manual de usuario

TP-Link

TP-Link TL-SG1016DE Manual de usuario

TP-Link

TP-Link Tapo H100 Manual de usuario

TP-Link

TP-Link Tapo S500 Manual de usuario

TP-Link

TP-Link TL-SG1218MPE Manual de usuario

TP-Link

TP-Link T1700G-28TQ Manual de usuario

TP-Link

TP-Link KS205 Manual de usuario

TP-Link

TP-Link TL-SG108PE Manual de usuario

TP-Link

TP-Link TL-SG108 Manual de usuario

TP-Link

TP-Link JetStream T1500G-10MPS Manual de usuario

TP-Link

TP-Link Jetstream L2 TL-SG5412F Manual de usuario

TP-Link

TP-Link JetStream TL-SG5412F Manual de usuario

TP-Link

TP-Link Tapo S210 Manual de usuario

TP-Link

TP-Link TL-SF1008P Manual de usuario

TP-Link

TP-Link JetStream TL-SG3424 Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario