TP-Link TL-WR703N Manual de usuario

Quick Installation Guide for TL-WR703N

Wireless Nano AP Router Pre-Installed with DD-WRT

Firmware

Table of Contents:

1. Basic Information

1.1 Basic Product Log In information

1.2 Important Notice

2. Quick Installation

2.1 Hardware Installation

2.2 Setup you Computer

2.3 Connect your Computer to TL-WR703N

2.4 Configuration on TL-WR703N

2.4.1 Log In to TL-WR703N

2.4.2 Select Your Language

2.4.3 Dial Up

2.5 Visit Internet (Connect your PC to TL-WR703N Again)

2.6 Wireless Encryption

3. Advanced Configuration

Quick Installation Guide for TL-WR703N

1. Basic Information

1.1 Basic Product Log In information

1.1.1 Log in Information

You can log into the interface of this Nano WIFI router with the

following information:

IPAddress: 192.168.1.1

User Name: admin

Pass Word: admin

1.2 Important Notice

1.2.1 We are responsible for the quality warranty if this product

comes at DOA (Death On Arrival) Status.

1.2.2 This product is pre-installed with current version of DD-WRT

firmware, you are able to setup WIFI wireless broadband network

with this device based on the current firmware. If you have any

questions for using this router, please feel free to contact us.

1.2.3 DD-WRT is an open sourced, editable, continual upgradable

third party firmware. We are not responsible for the quality problem

caused by upgrading this router with other version of DD-WRT

firmware by the buyer/end-users himself/herself.

2. Quick Installation

2.1 Hardware Installation

2.1.1 Basic requirement for installation:

WIFI Wireless Adapter

IE Internet Explorer

Ethernet Cable

Power Supply

2.1.2 Connect the Cables and Power Supply

Step 1: Connect one end of the provided USB cable to micro USB

port of TL-WR703N.

Step 2: Connect the other end of the provided USB cable to the

power adapter or the USB Port of your PC.

Step 3: Plug in standard electrical wall socket directly to power the

Router.

Step 4: For AP Mode and Router Mode, connect the LAN/WAN port

of TL-WR703N to Internet with an Ethernet cable.

2.1.3 Interface Introduction

Below is a photo of the interface of your wireless router

LAN/WAN: This port works as WAN in AP Router mode.

Power: This port is used to connect the provided power adapter.

Reset：It is used to reset the TL-WR703N to its factory defaults.

How to reset this wireless router?

Please use a small pin to press this reset button and hold it for 5~7

seconds. After this, your router is reset.

Notice: Please note that after reset, all your information stored in

the router will be removed and you need to configure your router

again.

2.1.4 LED Indications

The LED blinks for 1~2 times when you give power supply to the

Router.

After this, the LED is not on. This is Normal because the router is

installed with DD-WRT firmware.

For checking if this router is workable or not, please disconnect the

power supply to the router and give power supply to it again. If the

LED blinks 1~2 times when you plug on the power supply to it, it

means the router is workable.

2.2 Setup you Computer

Note: Here we take Windows 7 as example.

2.2.1 On your PC, Go to Start > Control Panel > View network

status and tasks > Change adapter settings. Right click

"Wireless Network Connection", and select "Properties".

2.2.2 Double click Internet Protocol Version 4 (TCP/IPv4) in the

item list.

2.2.3 Select “Obtain an IP address automatically” and select

“Obtain DNS server address automatically” and then click “OK”

2.3 Connect your Computer to TL-WR703N

Below we will tell you how to connect your PC to your wireless

router wirelessly, please make sure that your PC has wireless

adapter.

2.3.1 Please note that the default SSID of your wireless router is

“dd-wrt”, this wireless router is default as no wireless

encryption.

2.3.2 Click the wireless icon at the bottom of your

desktop. Click refresh button, and then select the default

SSID of " dd-wrt" and then Click “Connect”

2.3.3 If you can see Connected as shown in the screen below,

you’ve successfully connected to the wireless network.

2.4 Configuration on TL-WR703N

2.4.1 Log In to TL-WR703N

Step 1:

Please open your Internet Explorer, in the place of address bar

please input “192.168.1.1” and then click “Enter”.

Step 2:

At the screen below, enter the default User Name and Password:

admin, both in lower case letters. Then Click OK.

Step 3:

You would see the screen below:

2.4.2

Here it is in English interface, you can select other languages.

Please click “Administration” as below.

Please select your language as below:

At the bottom of the interface, please click “Save”, and then click

“Apply Settings”.

Tabla de contenidos

Otros manuales de Enrutador de red de TP-Link

TP-Link

TP-Link Archer C2600 Manual de usuario

TP-Link

TP-Link TD-8811 Manual de usuario

TP-Link

TP-Link TD-8816B Manual de usuario

TP-Link

TP-Link TL-R470T+ Manual de usuario

TP-Link

TP-Link AC600 Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

TP-Link

TP-Link Archer C3200 Manual de usuario

TP-Link

TP-Link TL-ER604W Manual de usuario

TP-Link

TP-Link tl-wr845n Manual de usuario

TP-Link

TP-Link Deco BE16000 Manual de usuario

TP-Link

TP-Link TL-WR940N Manual de usuario

TP-Link

TP-Link Archer C59 Manual de usuario

TP-Link

TP-Link Archer VR2600 Manual de usuario

TP-Link

TP-Link Archer CR700 Manual de usuario

TP-Link

TP-Link Archer-C80 Manual de usuario

TP-Link

TP-Link Archer C2300 Manual de usuario

TP-Link

TP-Link AC1900 Manual de usuario

TP-Link

TP-Link TL-WA820RE Manual de usuario

TP-Link

TP-Link TD-W8961ND Manual de usuario

TP-Link

TP-Link Archer D2 Manual de usuario

TP-Link

TP-Link Archer AX50 Manual de usuario

TP-Link

TP-Link DECO X68 Manual de usuario

TP-Link

TP-Link TL-WR842ND Manual de usuario

TP-Link

TP-Link Archer AXE200 Omni V1 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario