TP-Link TL-R402M Manual

Rev. 1.3 – 01/07/2009

TP Link Router Basic Setup

Introduction

The TP-Link #TL-R402M Cable/DSL Router is a broadband router. Detailed information is on

the vendor’s web site at http://www.tp-link.com.

A router assigns Dynamic Host Configuration Protocol (DHCP). This means the router

assigns Internet Protocol (IP) addresses to all connected equipment configured to request on.

The two basic rules for DHCP:

•Only one router can be active in the same group of connected equipment.

•Each equipment item must have a unique IP address. If two devices get the same IP,

erratic behavior will result – most often the duplicate IP will fail to communicate.

By default, DHCP is on in this router.

Package Contents:

•TP-Link TL-R402M Router

•Power Adapter

•Quick Installation Guide

•Resource CD

You must own or purchase 1 network cable; the most common is a 6 foot

length. While sold under various names, make sure it is Cat5E type, with the

RJ-45 connectors.

Installation Planning

Consult the TP-Link Quick Installation Guide for an overview. The TP-Link TL-R402M unit is a

broadband router, so it must work with your cable or dsl modem. Your existing Cable or DSL

modem must also have one Ethernet port, which is probably connected to your PC.

Double-check that your internet works with the existing Cable or DSL modem before

you try to add the router. If you don’t have functioning internet before proceeding,

contact your Internet Service Provider (ISP).

Rev. 1.3 – 01/07/2009

Home Installation of the TP-Link Router

1. Power down all existing equipment (computer, cable/dsl modem, etc.).

2. Locate a suitable location for the TP-Link router.

3. On your cable or dsl modem, find the Ethernet port

and follow the (network) cable from the port of the

modem to the network card on the PC.

4. Unplug the PC end of the cable, and plug it into the WAN port on the TP-Link router.

[Note: you use the WAN port if you will leave DHCP on and use this device as a router.]

5. Now take the extra Ethernet cable (from page 1), and plug one end into the network port

on the PC (where you just removed your modem’s cable in step 4 above).

6. Plug the other end of the extra cable into any open LAN port on the TP-Link router (see

picture in step #4). Tip: It can keep you organized to use port #1, but this isn’t strictly

necessary.

7. Connect the A/C adapter to the router, and it will power on.

8. Power on the primary PC and the cable/dsl modem.

9. Recheck that your basic internet still works on the PC.

10. Proceed to the Weather Direct gateway installation, if that is your goal

(www.weatherdirect.com).

Note: If you have internet service problems at this point, the two most common errors are:

a) a mistake in the cabling, so check the connections in steps 1-9 again or

b) missing that DHCP is enabled on either the cable/dsl modem or some other routing

device. Only one device can serve DHCP, so competing devices need DHCP disabled.

If you have any additional needs, you will need to consult the TP-Link Users Guide on the CD

that came with the router or our Router Trouble-Shooting handout.

LAN

ports

Otros manuales para TL-R402M

1

Tabla de contenidos

Otros manuales de Enrutador de red de TP-Link

TP-Link

TP-Link Archer C8 Manual de usuario

TP-Link

TP-Link TL-WR940N Manual de usuario

TP-Link

TP-Link TX-6610 Manual de usuario

TP-Link

TP-Link TD-VG5612 Manual de usuario

TP-Link

TP-Link TD-8817B Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

TP-Link

TP-Link RE705X Manual de usuario

TP-Link

TP-Link TL-ER7206 Manual de usuario

TP-Link

TP-Link deco AX7800 Manual de usuario

TP-Link

TP-Link TL-WR1043N Manual de usuario

TP-Link

TP-Link TL-R470T+ Manual de usuario

TP-Link

TP-Link TD-W8951NB Manual de usuario

TP-Link

TP-Link TD-W8961ND Manual de usuario

TP-Link

TP-Link tl-wr845n Manual de usuario

TP-Link

TP-Link TL-WR820N Manual de usuario

TP-Link

TP-Link SR20 Manual de usuario

TP-Link

TP-Link SR20 Manual de usuario

TP-Link

TP-Link Archer D2 Manual de usuario

TP-Link

TP-Link JetStream T2600G-28TS Manual de usuario

TP-Link

TP-Link TL-MR6400 Manual de usuario

TP-Link

TP-Link ARCHER C3150 Manual de usuario

TP-Link

TP-Link WR850N Manual de usuario

TP-Link

TP-Link TD-W8970B Manual de usuario

TP-Link

TP-Link Touch P5 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario