Toyota TUNDRA 2008 Manual de usuario
CIIT0590
Customization
Installation Instructions
August 29, 200
8
Title:
NAVIGATION INSTALLATION MANUAL
With Bluetooth Instructions (Tundra)
Models:
2008 Toyota Tundra
&1,07113(Q
TABLE OF CONTENTS
63 ~ 6413. TROUBLESHOOTING HINTS
61 ~ 6212. RE-INITIALIZING
166. CAR-NAVI PARTS DESCRIPTION
65 ~ 6914. DIAGNOSTIC CHART
6011. RE-INSTALLATION
155. INSTALLATION OUTLINE
17 ~ 29
7. DISASSEMBLY
BASIC
BLUETOOTH/VOICE RECOGNITION
REAR CAMERA
30 ~ 47
8. INSTALLATION
BASIC
BLUETOOTH/VOICE RECOGNITION
REAR CAMERA
48 ~ 509. GPS ANTENNA INSTALLATION
51 ~ 59
10. OPERATION CHECK
DISPLAY CHECK MODE
NAVIGATION CHECK MODE
BLUETOOTH CHECK
VOICE RECOGNITION CHECK
AUX PORT
REAR CAMERA
144. RECOMMENDED TOOLS
8 ~ 13
3. INSTALLATION PREPARATION
–CHART: FM1, FM2 AND AM PRE-SET STATIONS
4 ~ 72. PRECAUTIONS FOR INSTALLATION
31. DEFINITION OF TERMS
Page No.
3
&1,07113(Q
1. DEFINITION OF TERMS
WARNING: Describes precautions that should be
observed, in order to prevent injury or
death to the user during installation.
CAUTION: Describes precautions that should be
observed, in order to prevent damage
to the vehicle or its components,
which may occur during installation if
insufficient care is taken.
NOTE: Provides additional information that
facilitates installation work.
FRONT, REAR, LEFT, RIGHT: Provides additional information
that facilitates installation work.
TOOLS: Specifies the tools and equipment
recommended for this process.
ESD: Contains parts and assemblies
susceptible to damage by
Electrostatic Discharge (ESD).
To prevent unnecessary
troubleshooting, after an installation
procedure.
4
&1,07113(Q
1. Contents given in the WARNING and CAUTION in this manual must be
carefully followed during the installation. If they are ignored, functions
of the CAR-NAVI system are hindered, as well as personal injury or
damage to the vehicle may result. Always carry out the installation in
accordance with the WARNING and CAUTION as noted.
2. When the vehicle parts are removed, keep the tapping screws, bolts and
nuts organized so that the re-assembly will proceed correctly.
3. Do NOT remove vehicle parts except for those that are specified in this
manual.
4. Not all digital photographs depicted in this Installation Manual, will
reflect the current model and model year vehicle.
2. PRECAUTIONS FOR INSTALLATION
Failure to carry out these
procedures, will result in a possible
deployment of airbag(s), personal
injuries, or unnecessary repairs to
the Supplemental Restraint System
(SRS).
Turn the key switch to the LOCK
position. Next, remove the key from
the ignition switch.
WARNING
Do NOT work on the vehicle
while the battery’s NEGATIVE
terminal is connected. Working
on the vehicle with the battery
connected, may result in a short
circuit during the CAR-NAVI KIT
installation.
CAUTION
BATTERY
BATTERY
NEGATIVE
NEGATIVE
TERMINAL
TERMINAL
FRONT
Tools: 10mm Wrench
LOCK &
LOCK &
REMOVE!
REMOVE!
5
&1,07113(Q
Take care NOT to scratch any part of
the vehicle. Bind the tips of tools (i.e.:
clip remover, slot screwdriver, etc.)
with a piece of vinyl tape to prevent
damage to parts of the vehicle.
Cut away the excess part of all cable
ties, after fastening it.
NOTE
VINYL
VINYL
TAPE
TAPE
GOOD!
GOOD!
NOTE
Never use a voltmeter to
troubleshoot any of the harnesses
or connectors to the SRS.
Accidentally probing the
connectors to the SRS can lead to
deployment of the airbag.
SRS wire harness loom or cover is in
bright yellow colour.
WARNING
2. PRECAUTIONS FOR INSTALLATION
6
&1,07113(Q
Ensure that the run-wire is properly in
place of the RUN-WIRE SECTION, as
shown on the photo on the left. Always
fold the BASE over to meet the RUN-
WIRE SECTION, shown with the
yellow arrow. Use ordinary pliers to
squeeze the base and run-wire
section, until the latch locks.
NOTE
Carefully handle all connectors. Firmly
attach the connectors during
installation. The connector should click
shut.
Detach locking connectors by first
releasing the lock and pulling only on
the connector itself.
NOTE
CONNECTOR
CONNECTOR
2. PRECAUTIONS FOR INSTALLATION
RUN
RUN-
-WIRE
WIRE
SECTION
SECTION RUN
RUN-
-
WIRE
WIRE
BASE
BASE
FENDER
FENDER
COVER
COVER
Use protective covers to avoid damage
and scratches to the vehicle
components.
•Seat cover
•Fender cover (photo)
•Floor cover
NOTE
7
&1,07113(Q
All connector views in this installation
manual, are viewed from the front side.
NOTE
CONNECTOR VIEWS
CONNECTOR VIEWS
2. PRECAUTIONS FOR INSTALLATION
K1
K1
(Front View)
K2
K2
K3
K3
8
&1,07113(Q
Before proceeding with the CAR-
NAVI kit installation, please remove
any audio CD(s) from the factory
radio assembly. Also, please
ensure that the pre-set radio
stations (FM1, FM2 and AM) are
written down to pre-set the AVN-S
display unit. Please use chart
below.
NOTE
CHART: FM1, FM2 AND AM PRE-SET STATIONS
AM
FM2
FM1
654321
3. INSTALLATION PREPARATION
• Prior to installing the CAR-NAVI System kit, check the following for damage or
malfunction:
• Internal and external trim and body work.
• Following vehicle functions:
• Radio (FM1, FM2, AM)
• Automatic Climate Control System (i.e.: AUTO, A/C, TEMP, FAN
SPEED CONTROL, ALL VENT MODES, REAR DEFROST,
SECURITY, HAZARD LIGHTS, etc.).
• CAR-NAVI system parts preparation:
• When unpacking the CAR-NAVI system kit, lay out all components in the
order of installation and check for missing or damaged parts.
9
&1,07113(Q
Please order the appropriate Stereo
Component Amplifier from the Toyota
Parts Department. This part is NOT
included in the Car Navigation Kit.
NOTE
Please order the Audio Upgrade W/H
from the Toyota Parts Department.
This part is NOT included in the Car
Navigation Kit.
NOTE
AUDIO UPGRADE WIRE
AUDIO UPGRADE WIRE
HARNESS
HARNESS
STEREO COMPONENT
STEREO COMPONENT
AMPLIFIER
AMPLIFIER
Please order the Bracket kit from the
Toyota Parts Department. This part is
NOT included in the Car Navigation
Kit.
NOTE
BRACKET
BRACKET
KIT
KIT
3. INSTALLATION PREPARATION: Basic Installation
10
&1,07113(Q
Please order the AUX & Steering SW
Wire Harness, from the Toyota Parts
Department. This part is NOT included
in the Car Navigation Kit.
NOTE
AUX &
AUX &
STEERING
STEERING
SW W/H
SW W/H
Please order the most recent version
of Map DVD, from the Toyota Parts
Department. This part is NOT included
in the Car Navigation Kit.
NOTE
MAP DVD
MAP DVD
Please order the Shielded Wire
Harness, from the Toyota Parts
Department. This part is NOT included
in the Car Navigation Kit.
NOTE
SHIELDED WIRE
SHIELDED WIRE
HARNESS
HARNESS
3. INSTALLATION PREPARATION: Basic Installation
Otros manuales para TUNDRA 2008
4
Tabla de contenidos
Otros manuales de Sistema de navegación para automóviles de Toyota
Toyota
Toyota IS300h Manual de usuario
Toyota
Toyota TNS 300 Manual de usuario
Toyota
Toyota AVALON - 2011 Manual de usuario
Toyota
Toyota TNS 200 Manual de usuario
Toyota
Toyota DRG Manual de usuario
Toyota
Toyota VENZA 2010 Manual de usuario
Toyota
Toyota Avensis VersoTNS300 Manual de usuario
Toyota
Toyota Verso TNS510 Manual de usuario
Toyota
Toyota TNS400 Manual de usuario
Toyota
Toyota VENZA NAVI Manual de usuario
Toyota
Toyota 2009 4Runner Manual de usuario
Toyota
Toyota TNS350 Guía de inicio rápido
Toyota
Toyota TNS 700 Manual de usuario
Toyota
Toyota TNS600 Manual de usuario
Toyota
Toyota TNS 200 Manual de usuario
Toyota
Toyota Prius HSD 2006 Manual de usuario
Toyota
Toyota 4RUNNER 2010 Manual de usuario
Toyota
Toyota RAV4 2011 Manual de usuario
Toyota
Toyota GR YARIS Manual de usuario
Toyota
Toyota COROLLA MATRIX 2009 Manual de usuario
