TowMate, LLC. : 15827 Serenity Point Ln. : Rogers, AR 72756 : Phone (800) 680-4455 : Fax (479) 925-3494
Several modes to choose from
oPass-thru power for markers/Strobe (variable speeds)/Alternating strobe
(between the two channels, also variable speed)/On-Off
Lifetime Warranty
oIf ever the unit fails to get a signal, TowMate will replace the defective
component at no cost.
Installation Instructions:
*Be sure to connect the red and white wires last to prevent any shorts from
inadvertently occurring during installation.
**Do not overload the individual channels with too many lights. (3 amps maximum
per channel/combine channels to support up to 6 amps)
***Multiple receivers (PLC-RX’s) can be used within the same 12V system without
effect on the systems functionality.
****An automotive relay can also be set up to be triggered by the PLC-RX thus
allowing non-LED lights to be powered with minimal wiring as well.
1. Determine which lights you would like to control using your PLC-RX.
2. Connect the lights to one of the outputs on the receiver (blue wires are power
and white are ground).
a. If you would like to utilize the alternating strobe function, keep in mind that
only channel #1 can be programmed to create this effect but that you must
connect some lights to both channels in order for it to actually alternate.
3. Choose a power source and connect the red wire to 12V+.
a. Connect the red wire “upstream” of the lights you are manipulating and the
blue wire from the given channel “downstream” towards the lights.
b. In the case you are using the card to control your marker lights, simply
wire the card in line of the marker lights.
i. Keep in mind the card will only be operational when it is receiving
power, so the markers would have to be on all of the time in order
to keep it active all of the time.
Configuration Instructions:
*Once you have successfully connected to the 12V system and have
communication with the Power-Link control (PLC-TX/PLC-TX6/PLC-TXSW), a
