Touch Revolution K17A Series Manual de usuario
K17A Series
Touch Screen LCD Monitors
USER’s GUIDE
Rev.A
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be reproduced,translated to another language
or stored in a retrieval system, or transmitted by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission. Windows is a registered
trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective
holders.
The test results show that this device meets the FCC rules. Those limits are set to protect
residential areas from the devices with harmful emission. This device will produce, use and
radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use
this device might produce harmful interference with radio communication. Not withstanding
the foregoing, it does not guarantee that this type of harmful interference does not occur in
some special installations. The interference caused by this device to the reception of radio
or television signals may be verified by turning it on and off. Any changes or modifications to
this TFT LCD would void the user’s authority to operate this device.
Important Recycle Instruction:
LCD lamps inside this product may contain mercury. This product may contain
other electronic waste that can be hazardous if not disposed of properly. Recycle or
dispose in accordance with local, state, or federal Laws. For more information, contact
the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp specific disposal information
check WWW.LAMPRECYCLE.ORG.
Table of Contents
Usage Notice
Precautions............................................................................................................................. 1
Introduction
About K17A Series ................................................................................................................. 2
Touch Screen for K17A Series ............................................................................................... 2
Package Overview ................................................................................................................. 3
Installation
Product Overview ........................................................................................................ 4
Front View ............................................................................................................... 4
Bottom View ........................................................................................................... 4
Attaching the L-Brackets.............................................................................................. 5
Side Mount for Your Monitor ........................................................................................ 6
Customer panel material.......................................................................................... 7
Connecting the Display (Figure 9.1)............................................................................. 8
(Figure 9.1) ............................................................................................................. 9
User Controls
Back Panel Controls ...................................................................................................10
How to Use the OSD Menus .......................................................................................11
On-Screen Display Menus ..........................................................................................12
Appendix
Troubleshooting..........................................................................................................13
Warning Signal ...........................................................................................................14
No Signal.................................................................................................................14
Going to Sleep........................................................................................................14
Out of Range ..........................................................................................................14
Product Dimensions ...................................................................................................15
Compatibility Modes ...................................................................................................16
Touch Screen Driver Install.........................................................................................17
K17A Series Calibration Instructions........................................................................17
Usage Notice
Precautions
Follow all warnings, precautions and maintenance as recommended in this user’s manual to
maximize the life of your unit.
Do:
• Turn off the product before cleaning.
• Touch screen surface may be cleaned using a soft clean cloth moistened with mild window
glass commercial cleaners or 50/50 mixture of water and isopropyl alcohol.
• Use a soft cloth moistened with mild detergent to clean the display housing.
Don’t:
• Do not touch the LCD Display screen surface with sharp or hard objects.
• Do not use abrasive cleaners.
• Do not operate the product under the following conditions:
- Extremely hot, cold or humid environment.
- Areas susceptible to excessive dust and dirt.
- Near any appliance generating a strong magnetic field.
- In direct sunlight.
! Warning -
To prevent the risk of fire or shock hazards, do not expose
this product to rain or moisture.
!
W
arn
i
n
g
-
Pl
ease
d
o not open or
di
sassem
bl
e t
h
e pro
d
uct as t
hi
s ma
y
cause
e
l
ec
tri
c
s
h
oc
k.
1
Introduction
About K17A Series
The K17A Series is a 17" flat panel screen with an active matrix, thin-film transistor (TFT)
liquid crystal display (LCD).
Features include:
• Direct Analog signal input
• Active matrix TFT LCD technology
• 1280x1024 SXGA resolution
• 17” viewable display area
• 31.47 ~ 80 kHz horizontal scan
• 56 ~ 75 Hz high refresh rate
• 0.264mm x 0.264mm Pixel pitch
• Auto adjustment function
• Multilingual OSD user controls
• 75 mm / 100 mm VESA mount
• Bracket mount
• K17A Series - Projected Capactive touch screen with USB controller
Touch Screen for K17A Series
• Projected Capactive touch screen for finger input only
• Surface: Clear glass
• Interface: USB controller
• HID Multi-Touch: Windows 7
• HID Single Touch: Windows Vista, XP, 2000, ME, 98
• Driver Support: Vista and XP (TUIO), Linux – Certain Platforms, Mac OS 10.5.8 above
2
Package Overview
3
LCD Display Power Cord VGA Signal Cable
DC Power Supply
USB Cable ( A to B )
Quick Start Guide
Brackets
Screws
Remote Key
(sold separately)
4
Installation
Product Overview
• Front View
• Bottom View
VGA
RJ-11
USB DC IN
5
Attaching the L-Brackets
Depending on your mounting scheme, alternately, you may use the L-brackets to mount your
displays onto your wall or device.
Find a suitable location for attaching L-brackets.
A. The left and right sides
B. The Top and bottom sides
Bracket Bracket
or
Note:
You will need a screwdriver to attach the L-brackets.
Your kiosk touch monitor included two L-brackets (and four screws, M4x6).
This equipment is intended to be mounted in accordance with the proper hardware and the
installation instructions supplied with the product. Use of mounting brackets or screws other
than those specified in the installation instructions may cause a hazard.
Bracket
Bracket
Side Mount for Your Monitor
This monitor can be mounted to the wooden or concrete wall with 4 screws and a pair
brackets on the opposites.
174.0 mm
186.0 mm
4.5 mm
31.5 mm
10.0 mm
11.0 mm
5.0 mm
6
Customer panel material:
1. Wooden wall: Ø4.5mm thru holes for M4 screws w/nuts, or no thru holes, screws
for wood 4mm.
2. Sheet metal: concealed head threaded studs M4 w/nuts.
RECOMMENDED CUSTOMER PANEL CUT-OUT
403.0 mm
174.0 mm
87.0 mm
169.0 mm
87.8 mm
174.0 mm
339.0 mm
312.8 mm
+1
-0
380.8 mm
+1
- 0
4-R4 mm
0
-1
A A
A
A
*A: The distance between the shielding surface and the bottom of the screw
hole is 8 mm.
IMPORTANT!
The wall mounting instructions are for the qualified wall mounting person only!
! Warning!
Please select the proper screws!
Please use four M4 screws diameter with proper length to mount your monitor.
Please note: the mounting stand must be able to support at least 13.2 lbs (6Kg).
7
Tabla de contenidos
Otros manuales de Pantalla táctil de Touch Revolution
Manuales populares de Pantalla táctil de otras marcas
Elecro Engineering
Elecro Engineering Poolsmart Plus Instrucciones de instalación
Johnson Controls
Johnson Controls IQ4 HUB Manual de usuario
Elo TouchSystems
Elo TouchSystems ET2270L Manual de usuario
Elo TouchSystems
Elo TouchSystems ET1002L Manual de usuario
Elo TouchSystems
Elo TouchSystems 3201L Manual de usuario
Duratec
Duratec S15 Manual de usuario
