Toshiba MK8016GSG Guía de inicio rápido

MK**16GSG Hard Disk Drive Installation Notes P/N 480097-A0 P/N 480097-A0 MK**16GSG Hard Disk Drive Installation Notes

04/08 04/08

TOSHIBA STORAGE DEVICE DIVISION

MK**16GSG Series

HDD INSTALLATION NOTES

Contents subject to change without prior notice.

GENERAL DESCRIPTION

Toshiba’s MK1216GSG (HDD1F01) and MK8016GSG (HDD1F02) hard disk drive’s

integrate the Serial ATA interface and 5400 RPM rotational speed into a compact, 1.8-

inch footprint, furthering the evolution of mobile PCs into smaller and performance-

enhanced, ultra-portable systems.

SPECIFICATIONS MK1216GSG MK8016GSG

HDD1F01 HDD1F02

FORMATTED CAPACITY 120GB 80GB

HEIGHT 8mm 8mm

WEIGHT 62g 62g

NO. OF DISKS (PLATTERS) 2 2

NO. OF DATA HEADS 4 4

FUNCTIONAL SPECIFICATION

LOGICAL DRIVE MK1216GSG/MK8016GSG

PARAMETERS HDD1F01/HDD1F02

NO. OF CYLINDERS (user) 79,488

BYTES PER SECTOR 512

BUFFER SIZE 8MB

ROTATION SPEED (±0.1%) 5,400rpm

TRANSFER RATE INTERNAL 227 - 489Mbits/sec (typical)

NO. OF CYLINDERS (logical) 16,383

NO. OF HEADS (logical) 1 6

NO. OF SECTORS/TRACK 6 3

HOST TRANSFER RATE 1.5Gbits/sec

SEEK TIME

AVERAGE 15ms

TRACK-TO-TRACK 3ms

MAXIMUM 26ms

TEMPERATURE

OPERATING 41°F - 131°F (5°C - 55°C)

NON-OPERATING -4°F - 149°F (-20°C - 65°C)

HUMIDITY

OPERATING/NON-OPERATING 8 - 90% R.H. (No condensation)

SHIPPING 5 - 90% R.H. (No condensation)

WET BULB 29°C(operating)/40°C(non-operating)

CONNECTOR CABLING INFORMATION

The following table describes all of the pins on the Serial ATA connector:

Signal Segment Key

S1 GND 2nd mate

S2 A+ Differential Pair A from PHY

Signal S3 A-

Segment S4 GND

S5 B- Differential Pair B from PHY

S6 B+

S7 GND 2nd mate

Signal Segment “L”

Central Connector Polarizer

Power Segment “L”

P1 V33 3.3V Power

P2 V33 3.3V power pre-charge

P3 GND

Power P4 GND

Segment P5 V5 5V Power pre-charge 2nd mate

P6 V5 5V power

P7 Reserved*

P8 Optional

P9 Optional

Power Segment Key

* The corresponding pin to be mated with pin P7 in the power Internal Micro receptacle.

Connector shall always be grounded.

Notice: this drive uses 3.3V power only. 5V power is not used.

MK**16GSG Hard Disk Drive Installation Notes P/N 480097-A0 P/N 480097-A0 MK**16GSG Hard Disk Drive Installation Notes

04/08 04/08

UNPACKING PROCEDURE

Visually inspect the shipping container prior to unpacking for any signs of damage to

the container or its contents (the carrier is responsible for any damage incurred during

shipment). Prior to opening the anti-static bag, it is recommended that the user ground

himself with a ground strap or by touching the PC chassis or other metal object. Re-

move the drive from the anti-static bag and check it for damage. Save the shipping

container and packing material for possible use later.

HANDLING AND MOUNTING CONSIDERATIONS

•Installation and mounting of these drives is specific to the application environment.

•Handle drive only by the edges. When handling or mounting, take care not to apply

any pressure to the top cover.

•Avoid subjecting the drive to excessive shock. Do not drop the drive, even a

small distance onto a tabletop or other hard surface can damage drive. When

mounting the drive, do so in such a fashion that the drive will be isolated from

excessive shock.

•Do not mount in an environment where the temperature of the drive’s top cover will

exceed 65°C. (During operation, the temperature of the top cover can rise 15°C

above ambient).

•Do not disassemble, modify or repair drive.

•A rattle heard when the drive is moved is normal and not a sign of failure.

INTERFACE CONNECTOR

When connecting the drive and host system with Serial ATA cable, use of a Serial ATA

2.6 specification compliant cable is recommended.

Drive Side Connector DDK: SAT-PF16-S1A-FG

Recommended host side FPC Right Angle Type:

DDK SAT-RH16-S1B-FA or equivalent

FIGURE 1 – INTERFACE CONNECTOR

TECHNICAL SUPPORT

Should you require technical support, contact your computer distributor. If your dis-

tributor is unable to answer your questions, have them call Toshiba Storage Device

Division Technical Support, on your behalf.

TOSHIBA - STORAGE DEVICE DIVISON TECHNICAL SUPPORT

PHONE: 510/651-6798 FAX: 510/623-9893

EMAIL: [email protected]

You can also visit Toshiba’s web site at: http://www.toshibastorage.com

DEVELOPER SUPPORT

Toshiba Storage Device Division (SDD) the industry pioneer in small form factor

storage supports developers who are looking for small form factor HDD’s that deliver

the unbeatable combination of high-performance and high-capacity storage. Toshiba

HDD’s can be found “under the hood” of some of today’s hottest portable products. If

you are interested in discussing your product application with us please contact us.

E-mail: [email protected]

Phone: (949) 462-7502

Fax: (949) 588-7845

Web: http://developer.toshiba.com

MK**16GSG Hard Disk Drive Installation Notes P/N 480097-A0 P/N 480097-A0 MK**16GSG Hard Disk Drive Installation Notes

04/08 04/08

UNPACKING PROCEDURE

Visually inspect the shipping container prior to unpacking for any signs of damage to

the container or its contents (the carrier is responsible for any damage incurred during

shipment). Prior to opening the anti-static bag, it is recommended that the user ground

himself with a ground strap or by touching the PC chassis or other metal object. Re-

move the drive from the anti-static bag and check it for damage. Save the shipping

container and packing material for possible use later.

HANDLING AND MOUNTING CONSIDERATIONS

•Installation and mounting of these drives is specific to the application environment.

•Handle drive only by the edges. When handling or mounting, take care not to apply

any pressure to the top cover.

•Avoid subjecting the drive to excessive shock. Do not drop the drive, even a

small distance onto a tabletop or other hard surface can damage drive. When

mounting the drive, do so in such a fashion that the drive will be isolated from

excessive shock.

•Do not mount in an environment where the temperature of the drive’s top cover will

exceed 65°C. (During operation, the temperature of the top cover can rise 15°C

above ambient).

•Do not disassemble, modify or repair drive.

•A rattle heard when the drive is moved is normal and not a sign of failure.

INTERFACE CONNECTOR

When connecting the drive and host system with Serial ATA cable, use of a Serial ATA

2.6 specification compliant cable is recommended.

Drive Side Connector DDK: SAT-PF16-S1A-FG

Recommended host side FPC Right Angle Type:

DDK SAT-RH16-S1B-FA or equivalent

FIGURE 1 – INTERFACE CONNECTOR

TECHNICAL SUPPORT

Should you require technical support, contact your computer distributor. If your dis-

tributor is unable to answer your questions, have them call Toshiba Storage Device

Division Technical Support, on your behalf.

TOSHIBA - STORAGE DEVICE DIVISON TECHNICAL SUPPORT

PHONE: 510/651-6798 FAX: 510/623-9893

EMAIL: [email protected]

You can also visit Toshiba’s web site at: http://www.toshibastorage.com

DEVELOPER SUPPORT

Toshiba Storage Device Division (SDD) the industry pioneer in small form factor

storage supports developers who are looking for small form factor HDD’s that deliver

the unbeatable combination of high-performance and high-capacity storage. Toshiba

HDD’s can be found “under the hood” of some of today’s hottest portable products. If

you are interested in discussing your product application with us please contact us.

E-mail: [email protected]

Phone: (949) 462-7502

Fax: (949) 588-7845

Web: http://developer.toshiba.com

MK**16GSG Hard Disk Drive Installation Notes P/N 480097-A0 P/N 480097-A0 MK**16GSG Hard Disk Drive Installation Notes

04/08 04/08

TOSHIBA STORAGE DEVICE DIVISION

MK**16GSG Series

HDD INSTALLATION NOTES

Contents subject to change without prior notice.

GENERAL DESCRIPTION

Toshiba’s MK1216GSG (HDD1F01) and MK8016GSG (HDD1F02) hard disk drive’s

integrate the Serial ATA interface and 5400 RPM rotational speed into a compact, 1.8-

inch footprint, furthering the evolution of mobile PCs into smaller and performance-

enhanced, ultra-portable systems.

SPECIFICATIONS MK1216GSG MK8016GSG

HDD1F01 HDD1F02

FORMATTED CAPACITY 120GB 80GB

HEIGHT 8mm 8mm

WEIGHT 62g 62g

NO. OF DISKS (PLATTERS) 2 2

NO. OF DATA HEADS 4 4

FUNCTIONAL SPECIFICATION

LOGICAL DRIVE MK1216GSG/MK8016GSG

PARAMETERS HDD1F01/HDD1F02

NO. OF CYLINDERS (user) 79,488

BYTES PER SECTOR 512

BUFFER SIZE 8MB

ROTATION SPEED (±0.1%) 5,400rpm

TRANSFER RATE INTERNAL 227 - 489Mbits/sec (typical)

NO. OF CYLINDERS (logical) 16,383

NO. OF HEADS (logical) 1 6

NO. OF SECTORS/TRACK 6 3

HOST TRANSFER RATE 1.5Gbits/sec

SEEK TIME

AVERAGE 15ms

TRACK-TO-TRACK 3ms

MAXIMUM 26ms

TEMPERATURE

OPERATING 41°F - 131°F (5°C - 55°C)

NON-OPERATING -4°F - 149°F (-20°C - 65°C)

HUMIDITY

OPERATING/NON-OPERATING 8 - 90% R.H. (No condensation)

SHIPPING 5 - 90% R.H. (No condensation)

WET BULB 29°C(operating)/40°C(non-operating)

CONNECTOR CABLING INFORMATION

The following table describes all of the pins on the Serial ATA connector:

Signal Segment Key

S1 GND 2nd mate

S2 A+ Differential Pair A from PHY

Signal S3 A-

Segment S4 GND

S5 B- Differential Pair B from PHY

S6 B+

S7 GND 2nd mate

Signal Segment “L”

Central Connector Polarizer

Power Segment “L”

P1 V33 3.3V Power

P2 V33 3.3V power pre-charge

P3 GND

Power P4 GND

Segment P5 V5 5V Power pre-charge 2nd mate

P6 V5 5V power

P7 Reserved*

P8 Optional

P9 Optional

Power Segment Key

* The corresponding pin to be mated with pin P7 in the power Internal Micro receptacle.

Connector shall always be grounded.

Notice: this drive uses 3.3V power only. 5V power is not used.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Almacenamiento de Toshiba

Toshiba

Toshiba (HDD2188) Manual de usuario

Toshiba

Toshiba MK3006GAL Manual de usuario

Toshiba

Toshiba MK-150FA series Manual de usuario

Toshiba

Toshiba microSDHC Manual de usuario

Toshiba

Toshiba CanvioDTQ112 Manual de usuario

Toshiba

Toshiba FlashAir III Manual de usuario

Toshiba

Toshiba MK4025GAS Manual de usuario

Toshiba

Toshiba Q300 Series Manual de usuario

Toshiba

Toshiba MK8009GAH Guía de inicio rápido

Toshiba

Toshiba MK6014MAP Manual de usuario

Toshiba

Toshiba Canvio AeroCast Manual de usuario

Toshiba

Toshiba STOR.E BASICS 2.5" Manual de usuario

Toshiba

Toshiba HDTC910EK3AA Manual de usuario

Toshiba

Toshiba Canvio AeroCast Manual de usuario

Toshiba

Toshiba CANVIO AEROMOBILE Manual de instrucciones

Toshiba

Toshiba MK4050GAC Manual de usuario

Toshiba

Toshiba CANVIO BASICS Manual de usuario

Toshiba

Toshiba DIGITAL Series Guía de inicio rápido

Toshiba

Toshiba MK4007GAL Guía de inicio rápido

Toshiba

Toshiba MK4018GAS Manual de usuario

Toshiba

Toshiba TransferJet J301 Manual de usuario

Toshiba

Toshiba MK2018GAP Manual de usuario

Toshiba

Toshiba CANVIO ADVANCE Manual de usuario

Toshiba

Toshiba HDDR160E03X Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario