Topcon FC-500 Manual de usuario

Owner’s Manual

ii FC-500 Handheld Field Controller Owner’s Manual

notice.

Topcon®and Topcon Positioning Systems®is a registered

trademark of Topcon Positioning Systems, Inc. FC-500

Handheld Field Controller™is a recognized trademark of

Topcon Positioning Systems, Inc.

ActiveSync, Excel, Hotmail, Internet Explorer, Microsoft, MSN,

Outlook, PowerPoint, Visual Studio, Windows, Windows Media,

Windows Mobile, Windows Mobile Device Center, Windows

Vista, Windows Embedded Handheld, and the Windows

logo are trademarks or registered trademarks of Microsoft

Corporation in the United States and/or other countries.

The Bluetooth®word mark is owned by the Bluetooth SIG, Inc.

and any use of such marks by Topcon Positioning Systems, Inc.

is under license.

Adobe®Acrobat®and Adobe®Reader®are registered

trademarks of Adobe Systems Incorporated in the United States

and/or other countries.

Google Earth™mapping service is a trademark of Google, Inc.

The names of other companies and products mentioned

herein may be the trademarks of their respective owners.

WARNING! This symbol indicates that failure to follow directions

could result in serious injury.

CAUTION: This symbol indicates that failure to follow directions

could result in damage to equipment or loss of information.

Part Number 24163-00 JS, 1003476-01 TC

tel: 800.443.4567 lweb: www.topconpositioning.com

7400 National Drive, Livermore, CA 94550

Topcon Positioning Systems, Inc.

Contents iii

Contents

1 Getting Started

The Anatomy of the FC-500 2

Perform Initial Tasks 3

Home Screen and Windows Start Menu 8

Navigating Around Your FC-500 9

2 Hardware Components

Keypad Features 12

Display and Touchscreen 16

Power Management 21

LED Activity Indicators 23

Flashlight 24

SD Cards 24

Connector I/O Module 25

Audio Features 25

3 Programs and Settings

Home Screen 28

Windows Start Menu 33

On-Screen Keyboard 34

Suspend, Reset, Power Off, and Restore Defaults 36

Subdued Lighting (Tactical) Mode 38

Compass and Accelerometer Calibration 39

Communicating with a Desktop Computer 41

Getting Started Application 42

4 Bluetooth Wireless Communication

Creating a Partnership 44

Bluetooth Control Panel 45

Serial Device (COM) Control Panel 47

5 Wi-Fi Wireless Networking

Connecting to a Wi-Fi Network 50

iv FC-500 Handheld Field Controller Owner’s Manual

6 GPS/GNSS

Using GPS/GNSS 54

JSNav Application 57

7 Camera

Camera Settings for Still Images 64

Take Photos and Select Photo Options 68

Videos 70

Photo and Video Library 71

8 3G Data Modem

Set up a Data Account with a Wireless Provider 74

Install the SIM Card 74

Set up the Cell Modem 76

Wireless Safety 77

Maintenance of Your Modem 78

A Storage, Maintenance and Recycling

Storing the FC-500 and Battery Pack 80

Protecting the Touchscreen 80

Cleaning the FC-500 81

Recycling the FC-500 and Batteries 82

B Warranty and Repair Information

Limited Product Warranty 84

Repairing the FC-500 86

C Warnings and Regulatory Information

Product Warnings 90

Certications and Standards 91

D Specifications

FC-500 Handheld Field Controller Specications 96

Index

Getting

Started

2FC-500 Handheld Field Controller Owner’s Manual

Getting Started

The FC-500 Handheld Field Controller™ from Topcon

Positioning Systems features Bluetooth and Wi-Fi. Standard

accessories include a lithium-ion battery pack, AC wall

charger, USB micro client sync cable, hand strap, and a

capacitive stylus and tether. A camera, GPS/GNSS, and

cellular data modem are options.

The Anatomy of the FC-500

Front and Back Features

4 6

1Bumper, Top

2Touchscreen

3Keypad

4Sensor (option)

5Led Indicators (red

charging indicator on

the right, blue function

lock or green notication

indicator on the left)

6Power Button

7Microphone

8Camera Window (option)

9Camera Flash and Flashlight

Window (option)

10 Speaker

11 Screw Holding Battery Door

in Place (1 of 4 captive screws)

12 Hand Strap with Stylus

Holder and Tether Ring

13 Door to Battery

Compartment and Card Slots

Ch 1 Getting Started 3

Battery Compartment and Card Slots

Connector Module and Connector Protector

Perform Initial Tasks

When you receive your FC-500, perform the tasks outlined in

this section before rst use.

Review Documentation

You can download the FC-500 Handheld Field Controller

operator’s manual and quick start guide from www.

TopconTotalCare.com.

1Battery Door (screws and

door removed)

2Battery Pack

3 SIM Card Slot

4 SD/SDHC Card Slot, Micro

5Battery Compartment

3 4 5

345

1 Connector Module

2USB Client, Micro

3Microphone/Speaker Jack

4USB Host, Full Size

5 9-pin Serial Port

612V DC Jack

7Connector Protector

4FC-500 Handheld Field Controller Owner’s Manual

Apply a Screen Protector (Optional)

The touchscreen is extremely scratch resistant, so a screen

protector is not included with the FC-500. If you decide to

apply one, refer to the installation instructions included with

your screen protector for specic details.

Install the Battery Pack, SD Card, and SIM Card

The FC-500 uses a rechargeable Li-Ion battery pack. Install

and charge the battery pack as follows:

1. The battery compartment is accessed from the back of

the handheld. Loosen the 4 captive screws holding the

battery compartment door in place using a #1 Phillips

screwdriver. Remove the door. You do not need to

remove the hand strap.

CAUTION: The FC-500 is not sealed against water and

dust when the battery door is not installed.

2. If you are using a micro SD card for additional memory

or a SIM card with the 3G Data Modem (optional), you

can install them now before you install the battery pack

or at another time. See more details about these cards

in Chapter 2, Hardware Components, Micro SD Cards

and Chapter 8, 3G Data Modem, Install the SIM Card.

Ch 1 Getting Started 5

3. Place the Li-Ion battery pack in the compartment.

Make sure the symbols on the battery pack label align

with the symbols inside the compartment.

4. Replace the door and tighten the screws.

5. Plug the AC wall power charger that came with the

FC-500 into a wall socket. Plug the other end into the DC

power jack on the FC-500. The red LED on the keypad

blinks when the battery pack is charging.

Line the symbols up

on the case and the

battery pack as shown

6FC-500 Handheld Field Controller Owner’s Manual

Attach the Stylus Tether

A capacitive stylus and tether are included with the

handheld.

Note: A stylus is not required to use the touchscreen. The

optimal way to make selections is by nger touch.

One end of the tether is attached to the stylus. To attach it

to the hand strap, follow these steps:

1. Pull the free tether loop through the tether ring on the

hand strap. Insert the stylus with the attached tether

through this loop and tighten the loop.

2. Place the stylus into the holder on the hand strap.

Perform Set Up and Charge the Battery

1. The handheld powers on and begins the startup

process. A splash screen is shown that includes a

progress indicator at the bottom of the screen.

2. A Microsoft®Windows Embedded Handheld screen is

shown.

3. The Clock and Alarms control panel appears. Adjust the

time zone, date and time if necessary and tap OK.

Tabla de contenidos

Otros manuales de Instrumento de medición de Topcon

Topcon

Topcon Ez METER EZ-200 Manual de usuario

Topcon

Topcon GTS-600 Series Manual de usuario

Topcon

Topcon OS Series Manual de usuario

Topcon

Topcon KR-1W Manual de usuario

Topcon

Topcon RL-HV Series Manual de usuario

Topcon

Topcon GTS-230N Manual de usuario

Topcon

Topcon RC-5 Manual de usuario

Topcon

Topcon DS-101AC Manual de usuario

Topcon

Topcon GTS-230W Series Manual de usuario

Topcon

Topcon GREEN LABEL GTS-250 Series Manual de usuario

Topcon

Topcon KR-1 Manual de usuario

Topcon

Topcon GPT-7000i Series Manual de usuario

Topcon

Topcon DIGI-STAR TMR3610 Manual de usuario

Topcon

Topcon RD-80SA Manual de usuario

Topcon

Topcon RL-VH4DR/G2 Manual de usuario

Topcon

Topcon BM-9A Manual de usuario

Topcon

Topcon IM-1000 Manual de usuario

Topcon

Topcon ES-52 Manual de usuario

Topcon

Topcon RL-H5A Manual de usuario

Topcon

Topcon GM-55 Manual de usuario

Topcon

Topcon BM-100 Series Manual de usuario

Topcon

Topcon GTS-710 Series Manual de usuario

Topcon

Topcon OS-101 Manual de usuario

Topcon

Topcon AT-G4 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario