Introduction
The Tone Commander 2260d is an ISDN attendant console compatible with Lucent, Nortel, and Siemens
National ISDN, and Lucent Custom ISDN services. It is designed to access a maximum of 22 call
appearances via a single attendant loop. The integral BLF/DSS feature simplifies call transfer for up to 60
stations.
Standard features of the 2260d include single button call answering, hold, transfer, conferencing, automatic
callback, direct station selection (DSS), name database, autodialing, line privacy, delayed ringing, 4 line (40
characters per line) alphanumeric display, and digital clock. Configuration parameters may be programmed
by the installer to accommodate a variety of operating environments.
The 2260d console uses standard Electronic Key Telephone Service (EKTS) ISDN configurations and
connects directly to the Central Office ISDN “U” interface. No external NT1 is required.
Using This Manual
Tone Commander consoles are easy to install and configure. The step by step instructions in this manual
guide the installer through the installation, preliminary testing, programming, and operational testing of the
2260d.
Installation of a 2260d consists of the following steps:
1. Order the equipment. (page 6)
2. Fill out the appropriate Translation Order Guides as required by the telco and order the ISDN lines.
(page 6)
3. Fill out the Configuration Sheets. (page 38)
4. Attach the handset, cradle, and tie bracket to the console. (page 29)
5. Connect the power supply to the consoles and ISDN lines. (page 30)
6. Enter the console SPIDs and PDN. (page 38)
7. Set up console key mapping, ringing call queues, recall timers, and call appearance loop usage as
required for this installation. Factory default settings may be adequate for many installations.
(page 41)
8. Enter the names and telephone numbers for DSS keys and caller identification. (page 56)
9. Test the operation of the console.
Available features and ordering requirements vary somewhat among the ISDN service types offered by the
telcos. Features and installation steps that are specific to an ISDN service type or C.O. switch are noted in
this manual as follows:
– Lucent, Nortel, or Siemens National ISDN – Nortel National ISDN-1 only
– Lucent National ISDN only – Nortel National ISDN-2 only
– Lucent Custom ISDN only – Siemens National ISDN only
Page 4 13-102735 Rev. F
Tone Commander 2260d Installation Instructions
Nortel
National ISDN-1
National ISDN
Nortel
National ISDN-2
Lucent
National ISDN
Lucent
Custom ISDN
Siemens
National ISDN
Call Tone Commander Customer Service at (800) 524-0024 if you have any questions about features,
installation, or operation of the 2260d.
