1. 警告 1. Warnings
●
Make sure there is no oil or grease on the grip.
A slip of the hand while tighteninig, may cause
an accident or injury.
●
Do not set the torque driver beyond the maximum
torque capacity.This will cause damage or injury.
●
Check for cracks, scratches and rust. These will
cause damage to the driver and may result in
an injury. If such conditions exist, have a func-
tional test performed and repair if necessary.
●
Do not drop the torque driver or apply a strong
shock or jolt. This will cause damage or defor-
mation as well as decrease the accuracy and du-
rability, which may cause an accident or injury.
●
Do not use the torque driver in the rain, high
temperature or high humidity, this may result
in malfunction due to the rust.
●
Do not use the torque driver where there are
high levels of dirt or dust.
2. 取扱上の注意 2.
Precautions when Handling
1.
Make sure a torque driver is set correctly
before using. Set torque is its minimum
when delivered.
2. Don’t use without its scale lange.
3.
Don’t set torque below minimum scale torque.
4. Conrm torque is set according to the
correct unit of measure before using.
(kgf.cm, kgf.m, N.m, cN.m etc)
5. Select a proper bit to adapt to the slit of
the screw head. If not correct, the screw
head may be damaged by the bit.
6. Don’t use in water. The inside mecha-
nism will be in malfunction and cause
an accident or injury. If you drop in
water, Repairing is required.
7. Even with rotary slip clutch, extra clicks
will result in clutch engagement wear-
ing and may shorten durability.
8. When storing, keep from dirt, mud, oil
and water, etc.
