TKH Security Proposal | RFP Name | RFP Number
TKH Security | Siqura UP Series | Installation manual v3.0 4
Important Safety Instructions
Prior to installation and operation, carefully read all instructions the in this
manual and heed all warnings.
Unpack this equipment and handle it carefully. If the package appears to be
damaged, notify the shipper immediately.
Use the original packaging to transport the unit. Disconnect power supply
before moving it. In case of returning the equipment, the original packaging
must be used.
Make sure that the installation surface can support at least four times the
weight of the unit in normal operating conditions. In case of excessive
external stress (e.g. vibration, strong winds or impact), the equipment may
need additional means of protection.
Proper hardware should be carefully chosen to fasten the unit to the
surfaces.
Use caution when lifting and assembling the unit. It is recommended that
non-slip protective gloves be worn during installation. The unit could bear
sharp edges.
Trying to manually force the wiper will result in damaging the device and will
void the warranty.
To maintain the IP rating of the unit, adequate cable glands must be used.
The unit must be tightly closed when operating.
For security reasons, do not install the unit in the proximity of water
containers and never push objects or pour liquids into the unit. The unit can
be safely used in damp environments or outdoors, as long as the connectors
and lids are properly sealed.
Video and data cables should not share the same conduit with supply voltage
cables. Whenever EMC is an issue, adequately shielded cables must be
used.
Open only the covers pointed out in this installation manual. Other covers
should be open only by the manufacturer.
This equipment has been designed to operate in harsh environments
requiring little or no maintenance. Suggested inspection interval is 6 months,
but extremely harsh environments may require more frequent inspection and
maintenance checks. On each inspection check the O-ring seals and the
eventual window wiper blade integrity. Replace them if necessary.
Check cables, electrical connections and mounting hardware for integrity and
tightness. Replace or tighten any damaged/loose part.
Before performing any operation, turn off the power. The installation of the
unit can be performed only by qualified personnel in accordance with the
regulations in force. Do not connect the unit to a supply circuit unless the
installation is completed.
Power the unit with 24 Vac / 3 A (75 W) power supply. Incorrect Power
Supply Voltage may damage the unit. Do not overload the terminal
connection, as it may cause a fire or electrical shock hazard.
