NOTES
•Read instructions fully before commencing fitment.
•Estimated Fitting Time: 4.5hrs (5hrs for winch provisions)
•The fitment of TJM products does not nullify the OE manufacturer's
operating guidelines and/or warnings. Ensure you are familiar with
and adhere to the usage instructions specified by the manufacturer in
the owner's manual or other official documentation.
•Left-hand and Right-hand components are determined as seated in
the vehicle.
•Be aware that several government / fleet departments require that the
tow points be painted red.
•Check for (and remove) any build up in all threads fitted to the
product.
•Ensure that the “Rated Recovery Point Label” is affixed alongside the
compliance label, in the driver’s side doorjamb.
•When fitting accessories to TJM products (ie. driving lights and
aerials), ensure suitable washer plates are used under the mounting
surface that allow the accessory to be secured in a way that prevents
it from damaging the product.
•When removing protective coatings, ensure all new edges are
deburred, clean any swarf from the area and apply rust preventative
to exposed surfaces.
It is recommended that if fitting large spotlights that the top hoop be removed
and to mount the spotlights to the top surface of the bullbar.
