Thunderbird T40-2000 Manual de usuario

Contents

Power + Charging……………………………………………………..………………………………….…...……Page 3

Understanding your indicator…………………………………………………………...……….………..…Page 4

Seng up your indicator for the rst me………………………………………….…………….….…Page 5

Installaon………………………………………………………………………………………….………...……….Page 6

Thunderbird Data Management…………………………………………………….……………..………..Page 8

Starng a weigh session……………………………………………………..…………………….…………….Page 9

Compleng a weigh session………………………………………………………………….….….…………Page 12

Care and Maintenance……………………………………………………………………….…………..………Page 13

Warranty & Contact……………………………………………………………………….……….……………..Page 14

Whats In this box

T40 Indicator + 2000KG Load bars (pair)

Moung Bracket

240V Charging adapter

Specicaons

Operang Tempreture - -20oC to +70oC

Baery charge temperature - -0oC to +50oC

Environmental Protecon Rang – IPX4

Weight - Indicator: 0.9kg / System weight: 20.1kg

Esmated baery operang me – 30 Hours

Power + Charging

To ensure opmum performance, it is recommended that the internal baery is charged for a minimum of

10 hours before rst me use.

1. Connect the power adapter at the base of the unit and plug the T40into a power outlet. The

charging icon will display on the screen.

2. When the charge shows 100%, the T40is ready to use with or without the power adapter.

Important Information

•Charging of the T40 should be in a cool (+10oC to +30oC) place.

•If the T40 is to be stored for an extended period, this should be in a cool dry place (–

20oC to 25oC, humidity 45% to 85%) with a fully charged battery. The T40 should be

charged until full every 6 months.

•Always charge the baery indoors.

Note

•When the T40 is in use, the baery icon will display and show remaining charge.

•When using the scale and the charge level falls below 5% the baery icon will ash. You will

have about 60 minutes to complete the weighing session before the T40 must be charged.

•Charging outside the recommended temperature range will reduce charging performance.

When charging above 40oC, the charging me is increased.

•If charging temperatures have been exceeded, charging will stop unl the unit cools down. The

charge indicaon will stop in this condion.

•If a baery error occurs the baery indicator will ash all the segments. Return the Weigh

Scale to a Thunderbird Authorised Service Centre for baery replacement.

Battery Charge Status

When the baery level drops to 0%, three beeps will sound and shut down.

Understanding your indicator

Weigh Screen

Weigh mode

Weigh buon

Records animal weight

Tare / zero buon

Baery charge

indicator

Weigh unit

Power buon

Turn T40 on/o.

Mode buon

Changes

weighing modes.

Load bar connectors

Power input

External power

connecon

Seng up the T40 for the rst me

Set the weight unit.

Turn on the T40 indicator. To change the weight unit, press and hold down the MODE buon for 3

seconds. A beep will sound when the weight unit changes between kgs and lbs.

Selecng the weighing mode

Press the Mode button to select a weighing mode.

Weighing Modes

AUTO

(Automatic)

In Automatic mode the T40 will automatically start weighing the animal. When the scale has

determined an accurate weight, it will lock on to the measurement and display it on the

screen.

This mode is recommended for yards that are well set up and allow the animals to flow

smoothly.

The T40 defaults to AUTO mode when switched on.

MANUAL

Manual mode allows the operator to decide when the measurement is made by pressing the

Weigh button to lock the weight.

Manual mode is recommended for yards that do not allow the animals to flow smoothly or

where the animals are disruptive. The operator has greater control over the weighing session.

Press the Mode button once to enable Manual mode.

FINE

Fine mode is recommended for weighing small static loads such as fleeces or produce. In Fine

mode, the Weigh Scale uses finer weight increments and zero tracking is automatically

switched off.

In Fine mode, the weight is displayed when placed on the platform and displays zero when the

load is removed.

Press the Mode button twice until FINE briefly appears on the screen, then 0.0kg/lb displays.

Installaon

Installing the T40 Indicator

The T40is supplied with a mounng bracket kit, for mounng on steel or wood.

Mounng kit contains:

-Moulded bracket

-2 x U-bolts

-4 x Tech screws – 65mm

-4 x M10 nuts

-4 x M10 Bolts – 20mm for load bar

Installing on a steel surface

To mount the bracket on either a vercal

or horizontal pipe, use the U-bolts, bolts

and nuts supplied.

Installing on a wood surface

The bracket can be mounted to a at

or round wood surface. Same as Gal

(4 screws)

Installing the Load bars

1. Select a locaon that provides a solid, level and well drained surface.

2. Ensure the load bars and plaorm are well secured and clear of any obstrucons.

3. Ensure the plaorm does not rock or move and ll with spacers if required.

4. Either bolt the load bars to the concreate pad or locate them on studs set into the concrete.

It is important that the load bars and plaorm sit at without any rocking or twisng.

5. Connect the load bar cables to the T40indicator.

A beep will sound indicang a successful connecon of the load bars.

WARNING – DO NOT WELD THE LOADBARS OR ANY STRUCTURE THAT THEY ARE ATTACHED TO.

Load bars contain sensive electronic devices which will be damaged by welding.

Damaged caused from welding, will not be warranted.

Weighing

There are 2 ways to use the T40 scale. It can be used on its own, or in conjuncon with the Thunderbird

Data Management mobile applicaon. Use the applicaon if you wish to record your session when

weighing animals.

Before Weighing

1. Check the load bars are connected to the T40 Indicator

2. Turn on the T40 Indicator using the Power Buon.

3. Check the weight displayed is ZERO. If not, press the TARE buon.

Thunderbird Data Management

•The Thunderbird Data Management app is used to record live sessions and control the T40 indicator

•Use your mobile device to control your weighing sessions.

•Aer weighing your animals, you have the capability to sync your data and transfer the session

direct to NLIS or send informaon to a CSV le. Where you can manage transfers, as well as

monitoring your animals’ weights and weight gains

•Download the app from Google Play or App Store.

Open the app and follow the prompts to sign up and create an account.

Start a weighing session -

Thunderbird Data Management Application

Note

If you have previously connected to the T40with your mobile device and come within range of

the T-40, it will automacally connect.

Open App on your

mobile device. From the

home screen, tap new

session, type the new

session name and tap

Done

The app will begin to

search for available

devices within range.

Select the T-40 and tap

connect.

The weigh screen will

open. Ready for the

session to commence.

Refer to page 12 (how

to commence weighing)

Understanding the weighing screen

Live screen

EID Record

Animal VID

Live weight

Average daily gain

if available

Lightest animal

record

Bluetooth

connecon opon

Session summary

Weight distribuon

Average weight for

session

Heaviest animal

record

Acons

Delete record.

Send to NLIS

Forward CSV le. Opons include Email, Text or save to

device le

Minimize menu.

Tabla de contenidos

Manuales populares de Escala de otras marcas

AWS

AWS ZEO-50 Manual de usuario

Gima

Gima Glass Body Fat Analyzer Manual de lista de piezas

Seca

Seca 374 Manual de usuario

TEC

TEC TEC SL59 SERIES Manual de usuario

Axis

Axis B/E Series Manual de usuario

Alecto

Alecto ACW-40 Manual de usuario

Rice Lake

Rice Lake MSI-4260 IS Manual de usuario

IKA

IKA RCT basic safety control Manual de usuario

ADE

ADE M20011 Manual de usuario

Duronic

Duronic KS3000 Manual de usuario

Digi

Digi SM-720 Manual de usuario

Cardinal

Cardinal CS Series Manual de usuario

Korona

Korona Kastella Manual de usuario

A&D

A&D FC-50Ki Manual de usuario

BDA

BDA CAMARGUE Manual de usuario

Tanita

Tanita HD-357 Manual de usuario

Leifheit

Leifheit 03173 Manual de usuario

Lumme

Lumme LU-1340 Manual de usuario