Thule Omnistor 6300 Manual de usuario
Bring your life
thule.com
Instructions
Prod no.: 302096 / 302097 / 302098
Doc. no.: 6CA902-00 / 3380049500
Date: 29/11/2018
Thule Omnistor 6300
Motor Kit 12V
+
More information https://www.caravansplus.com.au
More information https://www.caravansplus.com.au
36CA902-00
1
2
DISASSEMBLY
In case of engine replacement
21
2
1
2
2
2
2
23
2
3
TX20
TX20
More information https://www.caravansplus.com.au
46CA902-00
1
2
ASSEMBLY
21
2
2
23
2122
TX20
More information https://www.caravansplus.com.au
56CA902-00
3
4
21
21
2
2
23
TX20
More information https://www.caravansplus.com.au
66CA902-00
Operation only by switch
with momentary contact
i
i
21
21
2
2
2
2
ELECTRICAL INSTALLATION
More information https://www.caravansplus.com.au
76CA902-00
Cable usage
≤ 10 m cable length
Max. 10 m
≥ 10 m cable length
+ 10 m
AWG 13 - 2.5 mm2
(Max. 10 m)
AWG 13 - 2.5 mm2
(Max. 4 m)
AWG 11 - 4.0 mm2
(Max. 12 m)
+
i
More information https://www.caravansplus.com.au
86CA902-00
Control box
2.5 mm22.5 mm2
1.5 mm2
? mm2P4
i
More information https://www.caravansplus.com.au
96CA902-00
Read these instructions carefully. Warranty voided for incorrect connection.
INSTALLATION OF THE ELECTRONIC CONTROL BOX
1. Install the control box inside the vehicle with screws.
2. Extend the motor wires (+ red & - black) to the control unit.
Also the connection to motor & controlbox should be made with Ø
2,5mm2cables, tough to avoid loss of voltage due to the wires own
resistence. The installer might have to use up to Ø 4mm2wire in order to
bridge the distance between PCB & awning, while retaining a minimum of
9V at peak usage of 20A.
3. Connect the awning motor wires to the clamps 4 & 5 (See figure p. 7-8).
Connection wires: open the entrance by pushing gently with a screwdriver
in the rectangle beneath the correct connection. Then place the stripped
wire.
INSTALLATION OF THE SWITCH “AUTO / OPEN”
With this switch, the awning opens with one touch.
Note: the awning should only be opened when the key-contact of the
vehicle is turned off.
4. Install the switch (Ø40) on the desired location.
The switch should be monostable: (ON)-OFF-(ON) / (NC)-NO-(NC)
5. Connect the switch with entrance 1, 2 & 3 of the control box with 3 wires
of Ø 1,5mm2.
CONNECTION OF THE BATTERY
It is recommended that the awning is connected to the secondary
battery of the vehicle, not the batter of the vehicle, in order to avoid all
disturbances from other appliances.
6. Place an electric cable 2 x Ø 2,5mm2from the control unit to the battery.
Place a 20A fuse in the + conduction. In order to avoid short-circuit:
do not insert the fuse until the electrical connection is completed.
7. Connect the battery to entrances 6 & 7 of the control box.
Technical information
EN
More information https://www.caravansplus.com.au
10 6CA902-00
ATTENTION: The control unit will not operate if wrongly connected.
Also the connection to motor & controlbox should be made with Ø
2,5mm2cables, tough to avoid loss of voltage due to the wires own
resistence. The installer might have to use upto Ø 4mm2wire in order to
bridge the distance between PCB & awning. While retaining a minimum of
9V at peak usage of 20A.
CONNECTION TO THE KEY CONTACT OF THE VEHICLE
Connect the battery to the PCB in such way that the awning cannot be
operated when the car-key is turned on.
8. Connect the chosen clamp with entrance 7 of the control box. Make sure
that the key contact is switched off before connecting.
FUNCTIONAL CHECK
Switch in OPEN-position:
Check whether the awning does not open when the key contact and/or
motor from the vehicle is turned on.
SAFETY
When starting the vehicle, the awning should be closed.
Technische informatie
NL
Lees deze voorschriften aandachtig. Bij verkeerde aansluiting vervalt elke
aanspraak op garantie.
AANSLUITING VAN DE SCHAKELKAST
1. Monteer de schakelkast binnen in het voertuig met schroeven.
2. Voer de draden van de TO luifel motor (+ rood en - zwart) naar de
schakelkast.
3. Sluit de draden van de motor aan op ingang 4 & 5 (Zie figuur p. 7-8).
Verbinding van de bedrading: open de toegang door met een
schroevendraaier licht te duwen in het vierkant onder de juiste ingang.
Plaats daarna de gestripte electrische kabel.
More information https://www.caravansplus.com.au
Tabla de contenidos
Idiomas:
Otros manuales de Accesorios para automóviles de Thule
Thule
Thule 815 Manual de usuario
Thule
Thule Set-to-Go Saddle 878 Manual de usuario
Thule
Thule 177 Manual de usuario
Thule
Thule 1396 Manual de usuario
Thule
Thule Evo Clamp 710501 Manual de usuario
Thule
Thule 1745 Manual de usuario
Thule
Thule Tahoe Bag 867 Manual de usuario
Thule
Thule Rapid System Kit 1764 Manual de usuario
Thule
Thule 76 Guía
Thule
Thule 973-23 Manual de usuario
Thule
Thule Rapid System 1843 Manual de usuario
Thule
Thule 911700 Manual de usuario
Thule
Thule 2160 Manual de usuario
Thule
Thule 1457 Manual de usuario
Thule
Thule XADAPT1 Manual de usuario
Thule
Thule 1499 Manual de usuario
Thule
Thule Rapid 1271 Manual de usuario
Thule
Thule 755 Manual de usuario
Thule
Thule 712163 Manual de usuario
Thule
Thule 1822 Manual de usuario
