THOMSON RT304 Manual de usuario

Main Connections (For UK only)

CAUTION:

For UK Only

CONNECT THE MAIN LEAD INTO AC MAINS

POWER SOCKET

POWER SUPPLY 230V.

Note: The mains lead of the set is fitted with a

moulded plug. If the mains socket are not

compatible or if for any reason the plug is

removed please follow the directions below. The

moulded plug cannot be rewired and if removed

must be disposed of safely.

DO NOT under any circumstances plug the severed

plug into any mains socket as this could result in

electric shock.

Important: If the plug is removed, rewire the

new plug as follow:

The wires in the mains plug are coloured in

accordance to the following code:

BLUE = NEUTRAL & BROWN = LIVE

BLUE BROWN

If the colours of the wires in the mains lead of

this apparatus may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows:

BLUE wire to the terminal coded N (Neutral) or

coloured black.

BROWN wire to the terminal coded L (Live) or

coloured red.

DO NOT make any connection to

the terminal in the plug which is

marked by the letter E or by the

earth symbol or coloured green

or green and yellow.

A fused plug must be fitted

with a 3A fuse approved by

ASTA or BS1362 and fuse

covers must be always be

securely replaced. If your set

does not work, the fuse may

be blown.

MAINS CONNECTIONS:

(For UK, see inside front cover)

MAINS OUTLET POWER SUPPLY: 230V ~50Hz

Note:

Power is fed to the unit even when it is not functioning. To cut the

power supply off, the power cable must be unplugged.

RT304/464 EN 2/11/03, 3:51 PM1

Safety Information

Do not place the system near wet areas such as

bathrooms and pool side.

Do not expose this appliance to rain or moisture

Avoid storing the system at humid places or near

abnormally heated areas.

Power is continuously supplied to the system. To

disconnect power completely, unplug the power

cord from the power outlet.

Do not expose this appliance to dripping and

splashing.

WARNING: 



TO PREVENTFIRE

OR ELECTRICAL



SHOCKHAZARD,

DO NOTEXPOSETHIS PRODUCT



TO RAIN OR MOISTURE.

SEE MARKING ON BOTTOM / BACK OF PRODUCT

CAUTION

RISKOFELECTRICSHOCK

DONOTOPEN

THE EXCLAMATION

POINT WITHIN THE

TRIANGLE IS A

WARNING SIGN

ALERTING YOU OF

IMPORTANT

INSTRUCTIONS

ACCOMPANYING

THE PRODUCT.

THE LIGHTNING

FLASH AND ARROW-

HEAD WITHIN THE

TRIANGLE IS A

WARNING SIGN

ALERTING YOU OF

"DANGEROUS

VOLTAGE" INSIDE

THE PRODUCT.

CAUTION: TO REDUCE THE

RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER

(OR BACK). NO USER-

SERVICEABLE PARTS IN-

SIDE. REFER SERVICING

TO QUALIFIED SERVICE

PERSONNEL.

TECHNICAL SPECIFICATIONS:

Power supply

AC 230V ~50Hz

6V 4 X LR14 / R14 / “C” size

Power consumption: 7W

Please respect the environment. Before

throwing any batteries away, consult your

distributor who may be able to take them

back for specific recycling.

RT304/464 EN 2/11/03, 3:51 PM2

Operating the Radio

3 BAND PORTABLERADIO

RT304

Tuning the Stations

1. Slide RADIO button (located on the top

of the radio) to ON position to turn on

the radio.

2. Slide the RADIO BAND button to

switch to the desired broadcast band.

(FM/MW/LW for RT304, FM/SW/MW/LW

for RT464.)

3. Turn TUNING knob to select a station.

4. Adjust the volume level by the VOL-

UME knob.

5. You may lengthen the antenna located

at the top of the unit for better recep-

tion of FM/SW stations; for MW/LW sta-

tions, you may try rotating the antenna

to get better reception.

6. Slide RADIO button to OFF position to

turn off the radio.

RT464

Adjusting the tone level

1. Slide TONE CONTROL (located on the

top of the radio) to turn on / off the

tone.

Connecting the phones

You can use headphones to listen to radio

by inserting the headphone into the

PHONES plug located at the back of the

unit.

RADIO

4 BAND PORTABLERADIO

RT304/464 EN 2/11/03, 3:51 PM3

Power Supply

Installing batteries

1. Remove battery compartment door

by applying thumb pressure to area

indicated on battery door and then

lift the door out and off the cabinet.

2. Before inserting the batteries,

observe the polarities (That is, + and

-) of the battery, then relate the

polarities to the engraved diagram

inside the battery compartment.

Connect 4 LR14 / R14 / “C” size

battery to the connector plug.

3. Replace the compartment door.

Connecting power cord

1. Remove battery compartment door.

2. Plug the power cord into 230V-50Hz AC

outlet.

3. Replace the compartment door.

RT304/464 EN 2/11/03, 3:51 PM4

Este manual sirve para los siguientes modelos

Otros manuales de Radio reloj de THOMSON

Manuales populares de Radio reloj de otras marcas

Denver

Denver CRQ-105 Manual de usuario

Audiovox

Audiovox CE90 Manual de usuario

Sony

Sony Dream Machine ICF-C763L Manual de usuario

Sanyo

Sanyo DMP-P6 Manual de usuario

RCA

RCA RPC100 Manual de usuario

Yamaha

Yamaha ISX-80 Manual de usuario

Pyle

Pyle PLMR20W Manual de usuario

Blaupunkt

Blaupunkt CR7BK Manual de usuario

Philips

Philips AJ3180 Manual de usuario

HoMedics

HoMedics SS-5500-2EU Manual de usuario

RCA

RCA RC66i Manual de usuario

Versaudio

Versaudio Vers Manual de usuario

SOUNDMASTER

SOUNDMASTER UR8100 Manual de usuario

Audiovox

Audiovox CE90 Manual de usuario

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio Manual de usuario

Roberts

Roberts ChronoDAB Manual de usuario

AEG

AEG MRC 4132 BT Manual de usuario

Tokai

Tokai TC-155 Manual de usuario