ThermoWorks Thermapen Mk4 Manual de usuario

This procedure describes the method of trimming the Thermapen Mk4 at a

single temperature point (32°F/0°C) by using a properly made ice bath. The

Thermapen should rarely need adjustment and should only be performed if

absolutely necessary.

Materials Required:

• Philips screwdriver to open battery compartment

• Large kitchen cup (preferably 1 quart/1 liter size)

• Crushed ice (enough to ﬁll cup)

• Water

Determining if Your Thermapen Requires Adjustment:

1. Make a proper ice bath by following these steps:

• Fill a large cup with crushed ice.

• Add just enough water into the cup to ﬁll in the gaps in ice so no ice ﬂoats off the bottom of the cup. Too much water will

cause errors. Poor off water as necessary.

• Stir gently and wait approximately 1 minute.

2. Set the Thermapen display to read in tenths (example: 32.1°F) of a degree.

If the display is set to read temperature in whole degrees, change to tenths by following these steps below.

See video here: youtube.com/watch?v=O4k8m4lkDgk

• Using a Philips screwdriver, remove the battery compartment.

• Open the probe to turn on the Thermapen.

• Locate the Set and Menu buttons.

• Press the Menu button twice until 1 is displayed.

• Press the Set button to change the display from reading 1 to 0.1.

• To save the changes, press the Menu button until End is displayed.

• Replace the battery cover making sure not to overtighten.

3. Test the Thermapen display using the ice bath following these steps:

• Turn the Thermapen on by opening the rotating probe.

• Insert the tip of the metal probe into the ice bath about 2 inches (50mm) maximum.

• Stir gently so the tip does not rest on any ice. While stirring observe the displayed reading after about 15 seconds.

• Once the display is stable and no longer changes, write down the reading. You’ll need this if the Thermapen requires

adjustment.

4. Determine if an adjustment is necessary.

• If the reading from the ice bath test is within acceptable limits: 31.3°F and 32.7°F (–0.4°C and +0.4°C); then no

adjustment is necessary.

• If the reading is outside of acceptable limits proceed to making the trim adjustment.

Thermapen®Mk4

Trim Adjust Procedure

ThermoWorks, Inc • 741 E. Utah Valley Dr., American Fork, UT 84003 • ph: 801-756-7705 • fax: 801-756-8948 • techsuppor[email protected] • www.thermoworks.com

SET MENU

Making the Thermapen Trim Adjustment:

After determining that your Thermapen requires adjustment by following the

above procedure, follow these steps to trim the Thermapen:

1. Turn the Thermapen off by folding the probe away and

locking it into the probe retaining slot.

2. Calculate the trim adjustment value by subtracting the reading

written down in Step 3 of ‘Determining if Your Thermapen Requires

Adjustment’ from 32.0°F (or 0.0°C).

Example:

• Reading from my Thermapen = 32.9°F

• Adjustment Value: 32.0°F - 32.9°F = –0.9°F

3. Using a Philips screwdriver, remove the battery compartment to access the Set and Menu buttons.

4. Open the probe to turn on the Thermapen.

5. Hold down the menu button for 5 seconds until ‘SET TRIM’ is displayed. Press the Set button until the target trim

adjustment value is displayed. Note the trim adjustment value range is from –3.6°F to +3.6°F (-2°C to +2°C).

6. Press the Menu button to save the trim setting, ‘END’ is displayed for 1 second before returning to normal operation.

7. Retest in the ice bath to conﬁrm that the new reading is within the acceptable limits: between 31.3°F and 32.7°F (–0.4°C

and +0.4°C). If the reading is still outside of the acceptable limits, redo the trim adjustment by following steps 1 through 7.

For further technical assistance, contact Technical Support @ 801-756-7705 or techsupport@thermoworks.com.

ThermoWorks, Inc • 741 E. Utah Valley Dr., American Fork, UT 84003 • ph: 801-756-7705 • fax: 801-756-8948 • techsuppor[email protected] • www.thermoworks.com

P-15-007-M-2-a

Thermapen®Mk4

Trim Adjust Procedure

(continued)

SET MENU

Tabla de contenidos

Otros manuales de Termómetro de ThermoWorks

ThermoWorks

ThermoWorks I.R.F.S. Manual de usuario

ThermoWorks

ThermoWorks Thermapen Blue Manual de usuario

ThermoWorks

ThermoWorks Signals Manual de usuario

ThermoWorks

ThermoWorks Pro-Surface Thermapen Manual de usuario

ThermoWorks

ThermoWorks WAND Blue Manual de usuario

ThermoWorks

ThermoWorks TW362B Manual de usuario

ThermoWorks

ThermoWorks Therma 20 Plus Manual de usuario

ThermoWorks

ThermoWorks TempTest Blue Manual de usuario

ThermoWorks

ThermoWorks Therma 20 Plus Manual de usuario

ThermoWorks

ThermoWorks Precision Manual de usuario

ThermoWorks

ThermoWorks Saf-T-Log Manual de usuario

ThermoWorks

ThermoWorks Therma Differential Manual de usuario

ThermoWorks

ThermoWorks IR-PRO Manual de usuario

ThermoWorks

ThermoWorks TW8060 Manual de usuario

ThermoWorks

ThermoWorks Thermapen IR Manual de usuario

ThermoWorks

ThermoWorks ThermoPop Manual de usuario

ThermoWorks

ThermoWorks WAND THD2FE Manual de usuario

ThermoWorks

ThermoWorks MTC Manual de usuario

ThermoWorks

ThermoWorks Reference Thermapen Manual de usuario

ThermoWorks

ThermoWorks Therma K Manual de usuario

ThermoWorks

ThermoWorks RayTemp Blue Manual de usuario

ThermoWorks

ThermoWorks Reference Thermapen Manual de usuario

ThermoWorks

ThermoWorks WAND Manual de usuario

ThermoWorks

ThermoWorks Smoke X4 Manual de instrucciones y seguridad

Manuales populares de Termómetro de otras marcas

Delton

Delton 981A Manual de usuario

Baker

Baker MM2P Manual de usuario

Tarmo

Tarmo 320281 Manual de usuario

Citizen

Citizen CTD 504 Manual de usuario

TFA

TFA 14.1500 Manual de usuario

Vive

Vive DMD1010 Manual de usuario

Gotemp

Gotemp THB4002 Manual de usuario

GREISINGER

GREISINGER G 1202 Manual de usuario

Amprobe

Amprobe TMD-53W Manual de usuario

Trotec

Trotec BP10 Manual de usuario

Radiance instruments

Radiance instruments RT616 Series Manual de usuario

Eurolec

Eurolec IR151 Manual de usuario

Scaneo

Scaneo TS42B Manual de usuario

Sper scientific

Sper scientific 800043 Manual de usuario

Microlife

Microlife NC 200 Manual de instrucciones

Motorola

Motorola MBP69SN Guía de configuración

The MeatStick

The MeatStick The MeatStick Manual de usuario

Hama

Hama TH35-A Manual de usuario