Thermo Sphere Dual Control Touch Manual de usuario
DC-W DC-BINSTRUCTION GUIDE
CONTROL | TOUCH
DUAL
Excellence in heating solutions.
23
Target Temp 25
06:00 Friday
2
Contents
What's in the box? .....................................................
Before you start ..........................................................
Installing Your thermostat ............................................
Wiring diagram ...........................................................
User interface .............................................................
Settings .......................................................................
Set the time and date .................................................
Heating schedule ........................................................
Appliance controls ......................................................
Heating modes ...........................................................
Energy saving features ................................................
Advanced settings .......................................................
Compatible sensor probes ..........................................
Technical data .............................................................
4
5
6
9
11
12
14
15
21
22
24
25
28
29
3
Compatibility
ThermoSphere dual controls are compatible with
almost all electric underoor heating (UFH) systems
available.
ThermoSphere dual control can replace your existing
underoor heating thermostat as it's compatible
with many of the most popular thermostat brands’
oor sensor probes including those rated at:
• 6.8kΩ@ 25°C
• 10kΩ@ 25°C
• 12kΩ@ 25°C
• 15kΩ@ 25°C
• 33kΩ@ 25°C
Replacing an existing thermostat?
Contact the manufacturer's technical department
and ask for the rating of the oor sensor at 25°C
4
What’s in the box?
Check you’ve got everything:
• ThermoSphere Dual Control
• Floor sensor probe (2m)
• Floor sensor conduit (3m)
• Fixing screws
• Manual and warranty information
You will also need:
• Electrical screwdrivers
• Deep electrical back box
• Electric testing meter
5
Before you start
Your thermostat should be:
• Installed 1.2 - 1.5m from the oor
• On an interior wall
• In an area outside any wet zones (IP30)
• Installed on an RCD protected circuit
• Away from drafts or heat inuences
• Installed so that the oor sensor probe can be laid in a
clear, temperature representative area of the oor.
• Set to oor sensing mode wherever possible
• In an open area of the room
• Installed by a professional, in line with current IEE
regulations and local standards.
6
Installing your thermostat
1. Switch off mains power
You will be installing your thermostat as
part of a high voltage mains electrical
circuit. To ensure your safety and to
protect the thermostat, switch off
the mains power before you start the
installation.
CAUTION
High Voltage
Cables
!
Fuse Box Fused Switch
OFF
ON ON ON ON ON
OFF
7
Installing your thermostat
2. Choose a location
At this stage it its likely that an RCD protected electric
underoor heating system has been installed and a back box is
already in place.
The underoor heating cold tail should be pulled up through
the back box, and the sensor probe installed (in the conduit
provided) within the wall cavity or pre chased channel in a
solid wall.
8
3. Maximum distances
Your thermostat can be installed up to 50m away
from the underoor heating system it is controlling,
provided that the oor sensor is used to control the
temperature.
Underoor heating cold tails and oor sensor probes
can be extended up to 50m.
50m max.
Installing your thermostat
9
UFH Live
UFH Neutral
Appliance Neutral
230V AC Supply Neutral
230V AC Supply Live
Appliance Live
Common Earth (Ground)
Sensor connections
4. Wiring diagram
Connect to the underoor heating (UFH) cold
tail, additional appliance, power supply and
oor temperature sensor.
The oor temperature sensor is not polarity sensitive.
987654321
Installing your thermostat
10
5. Fix to the wall
Use a small at screwdriver in the groove
on the underside to lever the face plate
away from the back plate.
Carefully disconnect the ribbon cable and
align your thermostat with the mounting
positions on the pre installed back box.
Fix in place with the screws provided. Now
connect the ribbon cable and clip the face
plate back into position.
Installing your thermostat
Otros manuales para Dual Control Touch
1
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Termostato de Thermo Sphere
Manuales populares de Termostato de otras marcas
EWELLY
EWELLY EW-181 Manual de usuario
Prolon
Prolon T1100 Instrucciones de instalación
Computherm
Computherm Q20 Manual de usuario
Heatmiser
Heatmiser neoStat Manual de usuario
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario
