Thermo Scientific 48i Manual de usuario

Model 48i

Instruction Manual

Gas Filter Correlation CO Analyzer

Part Number 101891-00

10Aug2017

Specifications, terms and pricing are subject to change. Not all products are available in all countries. Please

consult your local sales representative for details.

Thermo Fisher Scientific

Air Quality Instruments

27 Forge Parkway

Franklin, MA 02038

1-508-520-0430

www.thermo.com/aqi

Thermo Fisher Scientific WEEE Compliance

WEEE Compliance

This product is required to comply with the European Union’s Waste

Electrical & Electronic Equipment (WEEE) Directive 2002/96/EC. It is

marked with the following symbol:

Thermo Fisher Scientific has contracted with one or more

recycling/disposal companies in each EU Member State, and this product

should be disposed of or recycled through them. Further information on

Thermo Fisher Scientific’s compliance with these Directives, the recyclers

in your country, and information on Thermo Fisher Scientific products

which may assist the detection of substances subject to the RoHS Directive

are available at: www.thermo.com/WEEERoHS.

Thermo Fisher Scientific WEEE Compliance

Reference Method Designation

The Thermo Scientific Model 48iis designated by the United States

Environmental Protection Agency (USEPA) as a Reference Method for CO

as set forth in the U.S. Environmental Protection Agency regulations at

Title 40, Part 53 of the U.S. Code of Fereral Regulations.

Designated Reference Method Number: RFCA-0981-054

EPA Designation Date: September 23, 1981 (amended for Model 48i)

The Model 48iCO Analyzer meets EPA reference designation

requirements when operated with the following:

Range 0-1 to 100 ppm

Averaging Time 10 to 300 seconds

Temperature Range 20 to 35 °C

Line Voltage 90 to 110 Vac @50/60 Hertz

105 to 125 Vac @50/60 Hertz

210 to 250 Vac @50/60 Hertz

Pressure Compensation ON or OFF

Temperature Compensation ON or OFF

Flow Rate 0.5 to 2 L/min

RS-232/RS-485 Interface

With or without the following options:

Teflon Particulate Filter

Internal Zero/Span and Sample Valves

Internal Zero Air Scrubber

Rack Mounts

I/O Expansion Board

Thermo Fisher Scientific Model 48iInstruction Manual i

About This Manual

This manual provides information about installing, operating, maintaining,

and servicing the Model 48iCO gas analyzer. It also contains important

alerts to ensure safe operation and prevent equipment damage. The manual

is organized into the following chapters and appendices to provide direct

access to specific operation and service information.

●Chapter 1 “Introduction” provides an overview of product features,

describes the principles of operation, and lists the specifications.

●Chapter 2 “Installation” describes how to unpack, setup, and startup

the analyzer.

●Chapter 3 “Operation” describes the front panel display, the front

panel pushbuttons, and the menu-driven firmware.

●Chapter 4 “Calibration” provides the procedures for calibrating the

analyzer and describes the required equipment.

●Chapter 5 “Preventive Maintenance” provides maintenance procedures

to ensure reliable and consistent instrument operation.

●Chapter 6 “Troubleshooting” presents guidelines for diagnosing

analyzer failures, isolating faults, and includes recommended actions for

restoring proper operation.

●Chapter 7 “Servicing” presents safety alerts for technicians working on

the analyzer, step-by-step instructions for repairing and replacing

components, and a replacement parts list. It also includes contact

information for product support and technical information.

●Chapter 8 “System Description” describes the function and location of

the system components, provides an overview of the firmware structure,

and includes a description of the system electronics and input/output

connections.

●Chapter 9 “Optional Equipment” describes the optional equipment

that can be used with this analyzer.

●Appendix A “Warranty” is a copy of the warranty statement.

●Appendix B “C-Link Protocol Commands” provides a description of

the C-Link protocol commands that can be used to remotely control an

analyzer using a host device such as a PC or datalogger.

About This Manual

Safety

ii Model 48iInstruction Manual Thermo Fisher Scientific

●Appendix C “MODBUS Protocol” provides a description of the

MODBUS Protocol Interface and is supported both over RS-232/485

(RTU protocol) as well as TCP/IP over Ethernet.

●Appendix D “Gesytec (Bayern-Hessen) Protocol” provides a

description of the Gesytec (Bayern-Hessen or BH) Protocol Interface

and is supported both over RS-232/485 as well as TCP/IP over

Ethernet.

Review the following safety information carefully before using the analyzer.

This manual provides specific information on how to operate the analyzer,

however, if the analyzer is used in a manner not specified by the

manufacturer, the protection provided by the equipment may be impaired.

This manual contains important information to alert you to potential safety

hazards and risks of equipment damage. Refer to the following types of

alerts you may see in this manual.

Safety and Equipment Damage Alert Descriptions

Alert Description

DANGER A hazard is present that could result in death or serious

personal injury if the warning is ignored. ▲

WARNING A hazard or unsafe practice could result in serious

personal injury if the warning is ignored. ▲

CAUTION A hazard or unsafe practice could result in minor to

moderate personal injury if the warning is ignored. ▲

Equipment Damage A hazard or unsafe practice could result in property

damage if the warning is ignored. ▲

Safety and Equipment Damage Alerts in this Manual

Alert Description

WARNING The Model 48iis supplied with a three-wire grounded

power cord. Under no circumstances should this

grounding system be defeated. ▲

If the equipment is operated in a manner not specified by

the manufacturer, the protection provided by the

equipment may be impaired. ▲

The service procedures in this manual are restricted to

qualified service personnel only. ▲

Safety

Safety and Equipment

Damage Alerts

About This Manual

FCC Compliance

Thermo Fisher Scientific Model 48iInstruction Manual iii

Alert Description

CAUTION If the LCD panel breaks, do not let the liquid crystal

contact your skin or clothes. If the liquid crystal contacts

your skin or clothes, wash it off immediately using soap

and water. ▲

Equipment Damage Do not attempt to lift the analyzer by the cover or other

external fittings. ▲

Disconnect the serial cable before changing RS-232 and

RS-485 selection to prevent damage to any equipment

currently connected to the analyzer. ▲

Some internal components can be damaged by small

amounts of static electricity. A properly grounded

antistatic wrist strap must be worn while handling any

internal component. ▲

Do not use solvents or other cleaning products to clean

the outside case. ▲

Do not remove the LCD panel or frame from the LCD

module. ▲

The LCD polarizing plate is very fragile, handle it

carefully. ▲

Do not wipe the LCD polarizing plate with a dry cloth, as

it may easily scratch the plate. ▲

Do not use alcohol, acetone, MEK or other ketone based

or aromatic solvent to clean the LCD module, but rather

use a soft cloth moistened with a naphtha cleaning

solvent. ▲

Do not place the LCD module near organic solvents or

corrosive gases. ▲

Do not shake or jolt the LCD module. ▲

Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

Note This equipment has been tested and found to comply within the

limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in

FCC Compliance

About This Manual

WEEE Symbol

iv Model 48iInstruction Manual Thermo Fisher Scientific

which case the user will be required to correct the interference at his or her

own expense. ▲

The following symbol and description identify the WEEE marking used on

the instrument and in the associated documentation.

Symbol Description

Marking of electrical and electronic equipment which applies to waste

electrical and electronic equipment falling under the Directive 2002/96/EC

(WEEE) and the equipment that has been put on the market after 13 August

2005. ▲

Service is available from exclusive distributors worldwide. Contact one of

the phone numbers below for product support and technical information

or visit us on the web at www.thermo.com/aqi.

1-866-282-0430 Toll Free

1-508-520-0430 International

EEE Symbol

here to Get Help

Otros manuales para 48i

Tabla de contenidos

Otros manuales de Instrumento de medición de Thermo Scientific

Thermo Scientific

Thermo Scientific Orion Star A211 Manual de usuario

Thermo Scientific

Thermo Scientific Orion 2230XP Manual de usuario

Thermo Scientific

Thermo Scientific Thermo Scientific AquaSensors RDO Pro-X Manual de usuario

Thermo Scientific

Thermo Scientific 20 GENESYS Manual de usuario

Thermo Scientific

Thermo Scientific RadEye G-10 Manual de usuario

Thermo Scientific

Thermo Scientific MIRAN 205B Series Manual de usuario

Thermo Scientific

Thermo Scientific Orion Star A212 Manual de usuario

Thermo Scientific

Thermo Scientific Orion Versa Star Manual de usuario

Thermo Scientific

Thermo Scientific Orion Star A112 Manual de usuario

Thermo Scientific

Thermo Scientific Multiskan FC Manual de usuario

Thermo Scientific

Thermo Scientific Orion Star Manual de usuario

Thermo Scientific

Thermo Scientific DensityPRO-T Series Manual de usuario

Thermo Scientific

Thermo Scientific 1064Defender Manual de usuario

Thermo Scientific

Thermo Scientific Orion Lab Star DO113 Manual de usuario

Thermo Scientific

Thermo Scientific Nicolet Summit OA Manual de usuario

Thermo Scientific

Thermo Scientific Orion Star Manual de usuario

Thermo Scientific

Thermo Scientific Star A221 Manual de usuario

Thermo Scientific

Thermo Scientific Nicolet FT-IR Manual de instalación y funcionamiento

Thermo Scientific

Thermo Scientific Nicolet iS5 LS Manual de usuario

Thermo Scientific

Thermo Scientific NanoDrop 1000 V3.7 Manual de usuario

Thermo Scientific

Thermo Scientific Orion 8010cX Manual de usuario

Thermo Scientific

Thermo Scientific Eutech Expert CTS Manual de usuario

Thermo Scientific

Thermo Scientific NanoDrop Lite Manual de instrucciones

Thermo Scientific

Thermo Scientific 42iQ Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario