Thermann Owner’s Guide
Gas Continuous Flow Water Heaters
6
Do not use a broken or modified power cord.
Do not bind, bend or stretch power cords.
Do not scratch, modify, or subject them
to impact or force. If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Do not cover the Water Heater, store trash or
debris near it, or in any way block the flow of
fresh air to the appliance.
Do not touch the exhaust vent during or
immediately after operation of the Water
Heater.
Do not drink water that has been inside the
appliance for an extended period of time. Do
not drink the first use of hot water from the
appliance in the morning.
Clean the filter on the water inlet as
frequently as required. The quality of
your local water will affect the frequency
required.
Treat hard, acidic or otherwise impure supply
water with approved methods to ensure full
warranty coverage.
Problems resulting from scale formation are
not covered by the warranty.
Do not run water through the appliance
when appliance is not on.
When discharging hot water, make sure the
appliance is ON. If water is run through the
appliance with the appliance OFF, water may
condense inside the appliance and cause
incomplete combustion or damage to the
internal electrical components.
Contact Reece before using with a solar
heater.
NOTICE Keep the area around the appliance clean.
If boxes, weeds, cobwebs, cockroaches etc. are
in the vicinity of the appliance, damage or fire
can result.
Do not install the appliance where the
exhaust will blow on walls or windows.
Do not disassemble the Remote Controller.
Do not use chlorine-based, acidic, alkaline
detergents, organic solvents such as benzine
and thinner, or Melamine Sponge to clean
the Remote Controller.
This may cause discolouration, deformation,
scratches or cracks.
Do not get the Remote Controller wet.
ECB1T and ECB2T are water resistant, too
much water can cause damage. ECM1T and
RC-9018C is not water resistant.
Do not splash water on the Remote
Controller.
Do not expose the Remote Controller to
steam.
Although it is water resistant, too much water
can cause damage.
Do not locate the Remote Controller near
stoves or ovens.
This may cause damage or failure.
Be sure to electrically earth the appliance.
Keep power cord free of dust.
Do not use the Water Heater for other than
hot water supply, shower and bath.
Do not exchange a remote controller cord
without notice.
Do not turn off the Water Heater while
someone is bathing.
CAUTION
