Thermann G16NG50 Manual de usuario

OWNER'S

GUIDE

Gas Continuous Flow Water Heaters

Owner's Information

Warranty

Models

6NG50/G

6LP50

6NG60/G

6LP60

G20NG50/G20LP50

G20NG60/G20LP60

G26

NG50/G26

LP50

G26

NG60/G26

LP60

Thermann Owner’s Guide

Gas Continuous Flow Water Heaters

Important Safety Instructions 4-7

Electrical Connection 7

Remote Controller 8-10

Fault Monitor 11-12

Warranty 13-14

CONTENTS

Thermann Owner’s Guide

Gas Continuous Flow Water Heaters

1. Do not hang washing or other

materials adjacent to the unit.

2. Do not use or store ﬂammable

materials within 2 metres of the unit.

3. Do not spray aerosols in the vicinity of

this appliance while it is in operation.

4. Do not touch the ﬂue outlet of the unit

during or immediately after operation.

5. If any gas smell comes from the unit, do not use naked ﬂames to test for gas leaks.

Turn o the gas supply and power and contact your plumber or Reece Customer

Care on 1800 080 055.

6. If a power failure occurs, any connected remote controllers will not function and the

unit will not supply hot water until power is restored.

7. Do not use this appliance as a space heater.

No Fire Prohibited

IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS

555

IMPORTANT SAFETY INSTRUCTIONS

DO NOT INSTALL INDOORS

This unit is designed for outdoor installation. Never install indoors. It

will be extremely dangerous because it will cause oxygen deﬁciency

and incomplete combustion.

If the unit has been installed indoors turn o the gas supply and

contact your plumber immediately.

MEASURES TO BE TAKEN DURING ELECTRICAL STORMS

Power surges caused by lightning can cause damage to the electrical components

of the unit. Turn o the main power during electrical storms.

SECURE SERVICE SPACE

Make sure there is enough space around the unit for checking, service and maintenance.

Check

Caution

Pull

No wet hand

CloseClose

Danger

Thermann Owner’s Guide

Gas Continuous Flow Water Heaters

CAUTION TO PREVENT SCALDING

Check the water temperature by hand ﬁrst before using shower.

This appliance is not intended for use by persons (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

WATER INLET PRESSURE

Maximum working water pressure is 1300kPa

DO NOT DISASSEMBLE, REPAIR OR MODIFY

Do not disassemble or modify the units as this may cause ﬁre,

electric shock and other accidents.

Always use a licensed plumber for installation, relocation,

repair or connection to solar units.

FREEZE PREVENTION

This unit comes equipped with internal electric heaters that prevent the water inside the

unit from freezing.

To enable this freeze prevention system to operate there must be an electrical power

supply connected to the unit.

The freeze prevention devices will not operate if the electrical power source is not connected.

The electric defrost heaters are installed inside the water heater only. All External Hot and Cold

water supply pipes and ﬁttings connected to the water heater should be properly insulated.

FLAMMABLE ITEMS

Do not place any ﬂammable items on, near, or around the unit,

as this can cause ﬁre or an explosion to occur.

Caution

Pull

No wet hand

CloseClose

Caution

Pull

No wet hand

CloseClose

Warning

Caution

Pull

No wet hand

CloseClose

IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS

777

IMPORTANT SAFETY INSTRUCTIONS

ELECTRICAL CONNECTION

MEASURES TO BE TAKEN IN CASE OF EMERGENCY

The procedure to follow in an emergency such as

earthquake, ﬂood or ﬁre is:

1. Close all hot water taps in the house.

2. Close the gas valve and the main water valve.

3. Turn o the main power.*

Caution

Pull

No wet hand

CloseClose

*In case of gas leakage, ﬁrst close the gas valve, wait for the

leaked gas to disperse then turn o the main power supply

Caution

Pull

No wet hand

Prohibited

Warning

Check

DO NOT REPLACE POWER CORD

If the power supply cord is damaged, it should be replaced by a cord available from your

local Reece branch. The power cord must be replaced by an authorised tradesperson.

DO NOT USE POWER CORD BUNDLED

Never use power cord in a bundled condition.

It can cause heat generation and ﬁre.

DO NOT PULL POWER CORD

Do not remove the power plug by pulling the cord

as it may generate heat by wire breakage and cause

ﬁre. Hold the plug when removing the power cord.

INSERT POWER PLUG FULLY INTO POWERPOINT

Check that the power plug is clean and undamaged,

then fully insert into the power point.

DANGER OF WET HANDS

Do not touch power plug with wet hands.

It can cause electric shock. Caution

Thermann Owner’s Guide

Gas Continuous Flow Water Heaters

REMOTE CONTROLLER

Up to three remote controllers are able to be installed with your Thermann unit for

complete control of your hot water.

Please note, units without remote controller will be set at either 50°C or 60°C (the

exception is if the unit is installed as a solar booster. Your plumber will have set the unit to

70°C).

YST-2807

(Universal Controller)

This remote controller is intended to be used in the kitchen, laundry room, bathroom

and ensuite.

The unit will deliver the selected temperature as follows:

Kitchen Controller:

37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48, 49

, 50

, 55*, 60*, 65*, 70* and 75°C*

Bathroom Controller:

37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48°C

*Only for 60°C model

**Delivery Temperature Adjustment for 50°C preset model

ON Indicator

Indicates power is on

to the system.

UP/DOWN Button

Increase or decrease the

desired water temperature.

ON/OFF Button

Power switch to operate

this remote controller.

In Use Indicator

Indicates that a hot

water tap is open.

High Temp. Indicator

Indicates the setting

temperature is higher

than 50゜

Digital Monitor

Indicates the selected water temperature.

Error messages ﬂash in the event of failure.

PRIORITY Indicator

Indicates this controller

has priority control over

the other controllers.

PRIORITY Button

PRIORITY Button to set the

water temperature on this

remote controller.

***

999

REMOTE CONTROLLER

Operation of Remote Controller

Please read these instructions carefully before using this appliance.

1. Turn on the ON/OFF button.

2. The temperature display will read 40°C.

3. The priority indicator will illuminate.

4. Select hot water temperature by pushing or button on the remote controller.

5. Turn on the hot water tap or shower. The ``In Use´´ indicator will illuminate

after a short delay.

This indicator will remain illuminated until the hot water tap or shower

is turned o.

6. The hot water temperature can be altered at any time during the operation by

pushing or button located on the remote controller.

Remote Controller

Energy-saving Mode

If no data is adjusted within a period of approximately 5 minutes the display becomes

dim. This is energy-saving mode and not a failure.

Thermann Owner’s Guide

Gas Continuous Flow Water Heaters

Priority Control (Change)

The temperature can only be controlled by the remote controller which has the

priority indication.

When the priority button is turned ON, that controller takes priority control over the

temperature settings. While hot water is being supplied, other remote controllers cannot

be turned o.

Whilst hot water outlets are open, transfer of ``priority´´ to other remote controllers

is not possible. This is safety feature.

HINTS FOR USING REMOTE CONTROLLERS FOR SAFETY AND ENERGY SAVINGS

1. Set the remote controller to a maximum of 42°C for normal bathroom use and to

prevent small children from scalding.

2. For kitchen and laundry use set the main remote controller to 60°C or the desired

temperature.

3. For showering, use settings between 37°C - 39°C and no cold water will be needed

to be mixed, and if other hot or cold water taps are used the temperature will be

maintained.

4. When bathroom remote controller is turned ON the temperature can be adjusted

between 37°C - 48°C.

Up to 50°C the temperature will increase by 1°C with each press of the UP/DOWN

buttons. The temperature can be adjusted continuously by keeping the button pressed.

Between 50°C and 75°C, the temperature is controlled by 5°C increments. The

temperature setting cannot be increased above 42°C while the hot water tap is open.

PLEASE NOTE: FOR TEMPERATURES ABOVE 50°C SCALDING CAN OCCUR

WITHIN SECONDS.

REMOTE CONTROLLER

Warning

Do not turn o the remote controller or change the water temperature while someone

is bathing or washing. That may result in scalds or burns.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Calentador de agua de Thermann

Thermann

Thermann 80THMB136 Guía del usuario

Thermann

Thermann TH26ENG5N Manual de usuario

Thermann

Thermann 26NG50C Manual de usuario

Thermann

Thermann 16NG50 Manual de usuario

Thermann

Thermann 16NG50-6 Manual de usuario

Thermann

Thermann TH32END5N Manual de usuario

Thermann

Thermann 80THM136 Manual de usuario

Thermann

Thermann TH250GLE Guía del usuario

Thermann

Thermann 80THM136 Manual de programación

Thermann

Thermann 25THMS124P Manual de usuario

Thermann

Thermann 250L Guía de solución de problemas

Thermann

Thermann TH50ECS Series Manual de usuario

Thermann

Thermann 26NG50C Guía del usuario

Thermann

Thermann 16NG50-6 Manual de usuario

Thermann

Thermann 135THM4N Manual de programación

Thermann

Thermann 26NG50C Manual de usuario

Thermann

Thermann TH50ECR6N Guía del usuario

Thermann

Thermann TIHP300 Manual de usuario

Thermann

Thermann 80THMB136 Manual de usuario

Thermann

Thermann 25THMS124P Guía del usuario

Thermann

Thermann 25W124 Guía de solución de problemas

Thermann

Thermann TH32END5L Guía del usuario

Thermann

Thermann 16NG50-6 Manual de usuario

Thermann

Thermann X Hybrid 220 Guía del usuario

Manuales populares de Calentador de agua de otras marcas

Kenmore

Kenmore 153.582400 Manual de usuario

Applimo

Applimo Edel AIR Manual de usuario

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manual de usuario

clage

clage E-Mini Series Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-180 Manual de usuario

Bradford White

Bradford White EF Series Manual de usuario

Eccotemp

Eccotemp 40-H Manual de usuario

Dimplex

Dimplex ECSd125-580 Guía

Dux

Dux 32FCR6N Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guía de solución de problemas

Noritz

Noritz N-132M Manual de instrucciones

TESY

TESY GCV7/4S 10047 Hoja de especificaciones

A.O. Smith

A.O. Smith Gphe 50 Manual de usuario

Koryo

Koryo KWHZF15Y Manual de usuario

Pentair

Pentair PSC-14-4-02 Manual de usuario

GE 40M06AAG Instrucciones de montaje

Thermor

Thermor AEROMAX SPLIT 2 Manual de usuario

American Hometec

American Hometec AHQ-B03X Manual de usuario