Thenow wine cellar cooling self-contained unit best suited to the
wine room and wine cabinet.The device is suitable for wine cabinets
or wine storage rooms below 5m³. The purpose of this device is to
keep the room temperature in its range 10~16 degrees Celsius, the
humidity stays at the best level of 50% to 70%,and these temperature
and humidity are good for long term wine storage. Compact and easy
to install even without any duct work or piping, which also helps to
reduce overall installation costs.
We have different models for different occasions,widely used in
household,wine cabinet,underground wine cellar,wine wall and so on.
Features:
➢Condenser and evaporator combined inside one appliance, easy and
fast to install.
➢Intelligent control panel.
➢Suitable temperature between 10~16 C and humidity maintenance
within 50~70% RH.
➢Unique appearance design, little vibration,lower noise.
➢Commercial-grade, corrosion resistant components and spray
painting frame for long-term durability.
➢ Available with a heater and humidifier option (HSN-J15-Z).
1.Refrigeration
Using cycling vapor compression refrigeration system,when the
compressor work, indraft low temperature and pressure refrigerant
gas from evaporator, compressed by compressor into high
temperature and pressure gas, and then into the condenser to
condense into liquid, meantime release heat, after throttling under
the function of the thermal expansion valve, entering into the
evaporator and absorbed heat,then evaporate into gas, finally back to
the compressor through the suction tube and complete a refrigeration
cycle ; On the other hand,through changing of refrigerant flow
direction, total or partial condensing heat generated from
refrigeration can be exhausted to outside,to achieve the purpose of
adjusting the indoor temperature.
（ ）
2.Heating Principle Optional
a.Electric heating compensation
b.Heat pump heating : Using the working principle of the compressor
, through a four-way reversing valve, the condenser and evaporator
are interchangeable ,to absorb heat from the outside and transfer it to
the inside , so as to increase the room temperature.
3.Dehumidification Principle
When the wet air flows through the evaporator surface, the air
temperature will drop, when it falls below the dew point,the steam in
the air will condense out, gathering and drainage of water pipes in the
receiving plate, the controller automatically adjusts the compressor
start-up time according to the setting humidity , so as to achieve the
purpose of adjusting humidity.
4.Humidification Principle (Optional)
Using environmental protection wet curtain, water was spurted to the
room area under large air volume to achieve the purpose of
humidifying.
Introduction
1 2
Working Principle
www.thenowair.com.au www.thenowair.com.au
