The Singing Machine ISM2040 Manual de usuario
TM
ISM2040
INSTRUCTION MANUAL/
MANUAL DE INSTRUCCIONES/
MODE D’EMPLOI
www.singingmachine.com
The Singing Machine® is a registered trademark of The Singing Machine Co., Inc.
The Singing Machine® es marca registrada de The Singing Machine Co., Inc.
The Singing Machine® est une marque déposée de The Singing Machine Co., Inc.
— E1 —
Important Safety Information
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all Instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in
accordance with the Manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. When the provided plug does not fit into your
outlet, consult an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with a cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is
used, use caution when moving the cart/
apparatus combination to avoid injury
from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped.
15. WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. Do not place objects
filled with water, such as a vase, on the apparatus.
16. The AC mains plug is used as the power disconnect device
and it should remain readily accessible and operable during
intended use. In order to completely disconnect the apparatus
from power, the mains plug should be completely removed
from the AC outlet socket.
17. CAUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other
heat sources.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE: The lightning flash with arrowhead
symbol within an equilateral triangle is intended to alert the
user to the presence of uninsulated dangerous voltage within
the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION: The exclamation point within an equilateral
triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions
in the literature accompanying this product.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Warnings
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
DRIPPING WARNING: This product shall not be exposed to dripping or
splashing, and no objects filled with liquids, such as vases, shall be placed
on the product.
VENTILATION WARNING: The normal ventilation of the product shall not
be impeded for intended use.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT AND FULLY INSERT.
FCC WARNING: This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The rating information is located at the bottom of the unit.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
— E2 —
Included
Please make sure that the following items are included.
Wireless Microphone
Base
Main Unit
Cradle with mic holders
(Detachable)
Extendable Mic stand
AC Adapter Manual
Mic 1
Mic 2
— E3 —
Assembly
Not for use with other microphone stands. Only lift unit from bottom base. Use caution
when placing larger-sized devices in holder.
v
x
w
1 Insert and rotate clockwise to
tighten the Main unit onto the
Base.
2 Lift the rubber cover on the top of
the Main unit. Insert the Mic stand
into the Main unit and tighten it.
3 Insert and rotate to tighten the
Cradle with Mic holders on the Mic
stand.
4
Untighten the mic stand locker(s)
to adjust to a suitable height.
Retighten the locks to hold in
position.
All-in-one assembly
— E4 —
Assembly
u
w
v
Split type assembly
1 Insert the Mic stand into the Base
and tighten it.
2
Insert and rotate to tighten the
Cradle with Mic holders on the Mic
stand.
3
Untighten the mic stand locker(s)
to adjust to a suitable height.
Retighten the locks to hold in
position.
4 Leave the main unit within 30
feet/10 meters distance as a
speaker.
NOTE: Always remember to put the rubber
cover back in place.
— E5 —
Location of Controls
1. Cradle
2. Mic Holders
3. MIC stand locks
4. Speaker
5. Mic Volume/VOCAL OFF
Control
6. / (Bluetooth/ Play/
Pause Button
7. / (LIGHTS/On/
Standby) button
8. VOCAL EFFECTS Control
9. PERFECT PITCH Button
10. MUSIC VOLUME
Control
11. RECORD Button
12. PLAYBACK Button
13. EFFECTS STRENGTH
Control
14 Display
15. DC In Jack
16. Mic 3 Jack
17. AUX In Jack
18. Handle
19. Wireless Mic battery
indicator
20. Wireless Mic ON/OFF
button
21. Bluetooth indicator
22. Battery indicator
23. Mic 1 indicator
(wireless)
24. Mic 2 indicator
(wireless)
25. Mic 3 indicator (wired)
u
v
x
w
y
U
W
V
X
at
ak
al
am
an
TOP
as bt
WIRELESS MIC
bk bm
bl
an
bo
bn
1
2
3
DISPLAY
ao ap aq
REAR
ar
— E6 —
Rechargeable Battery
This unit comes with a built-in rechargeable battery pack that will allow the unit to be used
without being connected to AC power. The rechargeable battery pack must NOT to be
replaced by the user.
To optimize the battery life, we recommend to charge the unit once a month. When the
battery indicator on the display flashes slowly, recharge the unit by following the steps below:
1
Insert the AC power cord into a
conveniently located AC outlet
having 120V, 60Hz.
2 Allow the unit to charge for
approximately 8 hours for a full
charge. When fully charged,
the battery indicator will light
solid.
3 Disconnect the AC cord and
the fully charged unit can
be used for approximately
4-10 hours depending on the
function chosen.
Attention: The sound volume will adjust automatically when the battery is not full.
Recycling and Disposal Information:
• Do not dispose of electronic devices or any of their components.
(especially batteries and LCD displays) in your municipal trash collection.
• Consult your local waste management authority or a recycling organization like Earth911.
com to find an electronics recycling facility in your area.
CAUTION: Rechargeable batteries must be recycled or disposed of properly.
Energy Saving (Auto Power System-APS)
The unit will automatically enter the Standby mode after 30 minutes in the following
situations:
1. There is no audio playback;
2. The playback of external music player had been stopped but the audio cable is still plugged
into the LINE IN jack.
The unit can be resumed to turn on by pressing the / button.
APS is for energy saving purposes.
— E7 —
NOTES:
• Make all connections prior to plugging the AC adaptor into a power outlet.
• The AC adaptor has a polarized plug that fits into the AC outlet only one way. If the plug
does not fit properly, turn it over and try again. Do not force and do not file or cut the wide
blade.
• The provided AC adapter can only support to charge the built-in rechargeable battery.
Connections
Insert the AC power cord into a
conveniently located AC outlet having
120V AC, 60Hz.
Charging the unit
Connecting the Wireless Microphone(s)
Rotate the MIC VOLUME/VOCAL OFF
control, the Mic indicator 1 and 2 will
appear in display and flash.
Slide the Wireless Mic’s ON/MUTE/OFF
u switch to the ON position. The Mic
indicator 1 or 2 will light solid.
NOTES:
• The working distance up to 30 feet/10
meters measured in open space.
• If there is no audio input for 15 minutes,
the wireless mics connection will
automaticlly turn off. Rotate the MIC
VOLUME/VOCAL OFF control to
reactivate the connection.
u
— E8 —
Changing the Wireless Microphone’s Battery
When the wireless mic battery indicator
flashes, it shows it is out of power. Change
the batteries as follows:
1
Unscrew the bottom of wireless
microphone.
2
Replace the batteries with 2 x "AA"
size/LR6 battery.
3
Replace the bottom of wireless
microphone and screw it on.
Connections
Battery Precautions
The precautions below should be followed when using batteries in
this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the
batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline
and Carbon Zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged,
they can overheat and rupture. (Follow battery manufacturer’s
directions.)
6. Rechargeable batteries are to be removed from the product
before being charged.
7. Rechargeable batteries are only to be charged under adult
supervision.
8. Exhausted batteries are to be removed from the product.
9. Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
Connecting the optional wired Microphone
Connect the wired microphone (not
included) into Mic jack u(when desired).
NOTE: Maximum of two microphones
(wired or wireless) connected to the
unit at one time. After inserting the
wired microphone (Mic 3), the wireless
microphone 1 (Mic 1) will be automatically
turned off.
u
— E9 —
Connections
Lights Mode
u
u
There are 5 built-in light mode. Repeatly press
/ button to switch between lighting
effects.
Connecting to AUX IN Jack
Cradle
Connect an external device by using an
appropriate cable (3.5mm audio cable not
included) as shown.
NOTE:
See page E13 to select and use the Aux In
function.
PULL
Tabla de contenidos
Idiomas:
Otros manuales de Micrófono de The Singing Machine
The Singing Machine
The Singing Machine SMM-107 Manual de usuario
The Singing Machine
The Singing Machine Bratz SMB-553 Manual de usuario
The Singing Machine
The Singing Machine SMM-107 Manual de usuario
The Singing Machine
The Singing Machine CPK565 Manual de usuario
The Singing Machine
The Singing Machine SMM-112 Manual de usuario
The Singing Machine
The Singing Machine SMM-112 Manual de usuario
The Singing Machine
The Singing Machine SMC4TV Manual de usuario
The Singing Machine
The Singing Machine SMM-112 Manual de usuario
The Singing Machine
The Singing Machine SMM-106 Manual de usuario
The Singing Machine
The Singing Machine SMM-112 Manual de usuario
