© Copyright 2022, Terrasmart, Inc. All rights reserved. | 000512-001| Tracker Interface Foundation Manual | Page 3 of 9 Proprietary and confidential. The information contained in this
document is the sole property of Terrasmart. Any reproduction in part or as a whole without written permission of Terrasmart is prohibited.
1.1
SystemRequirements/DocumentNotes
Terrasmart, Inc. (Terrasmart) model Tracker Interface Foundation solar ground mounting system is
listed by CSA to UL 2703 for Bonding and Grounding.
In accordance with UL 2703, the Terrasmart Tracker Interface Foundation is intended for use with
photovoltaic module systems with a maximum system voltage of 1500 V.
Pre-Assembled Sub-Assemblies:
The mounting system may ship as individual components or subassemblies from the factory and is field
assembled. Factory sub-assemblies must be checked for component alignment and connection
requirements must be verified. Some bolted sub assemblies may also ship with additional optional
welded connections for added mechanical or structural strength.
Corrasion Protection:
All components on the Terrasmart Tracker Interface are G90 galvanized minimum or hot dip galvanized
in accordance with UL 2703.
Bonding and Grounding:
The components within the Terrasmart Tracker Interface Foundation system are bonded to each other in
accordance with UL 2703. The Terrasmart Tracker Interface Foundation system must be bonded to the
tracker system in accordance with the
National Electrical Code (NEC).
After Installation:
Periodic inspections of the mountingsystem should be performed. Continued maintenance by qualified
persons shall include the following: Any loose components or fasteners shall be re-tightened in
accordance with these instructions.Any
components showing signs of damage that compromise safety shall be replaced.
