Page 6
Connect via wireless (Wi-Fi)
1. Using the Menu joystick, navigate to the
Network Setup menu, then select WiFi.
2. Press the Menu joystick to enter the WiFi mode
menu, then select a mode:
a. Access Point (AP) Mode - AP Mode is
automatically enabled by default. Connect
your computer to Cube’s AP network:
Teranet-XXXXX (serial number of the device).
b. Infrastructure Mode - Select Infrastructure
Mode, then Scan for Networks. Select a
Wi-Fi network (Fig. 2-5), then enter your
credentials.
3. To obtain the IP address, select [Status], or
press ▼ on the menu joystick from the main
screen.
Cube allows you to connect to a network using Wi-Fi, an Ethernet connection, or a USB modem. Use the
front panel interface or the web user interface (web UI) to connect Cube to a network.
CONNECT TO A NETWORK
Fig. 2-5
Connect to an Ethernet network (Wired)
1. Plug an Ethernet cable into Cube’s Ethernet
port (Fig. 2-7) and connect it to an Ethernet
switch or router.
2. Once Cube is connected to the network,
the front panel interface will indicate that
it’s “Ready” (Fig. 2-8).
3. To obtain the IP address, press ▼ on the menu
joystick, or navigate to the Wired menu, where
it will be displayed.
Fig. 2-6
Fig. 2-7 Fig. 2-8
Access the web UI
The web UI can be accessed by using any available network
interface. Simply open a web browser and enter the network’s IP
address in the navigation bar (Fig. 2-6). If using a USB modem,
connect your computer to Cube’s AP network first, then enter the
IP address in the navigation bar.
