5
Antenna Direction Switch (SW1)
Sets the direction of travel for the antenna. Most
installations will operate with the NORMAL setting. If the
antenna does not move in the proper direction, change the
switch to the REVERSED setting.
Antenna Stall Current Switches (SW2, SW3, SW4)
Used to set maximum stall current. This is used to determine
when the screwdriver antenna reaches the end of travel. If
set too low, the antenna may reverse before reaching the end
of travel. If set too high, the antenna motor may “stall” at the
end of travel and not reverse, possibly causing damage to the
motor. Use the following settings for some commonly used
antennas:
High Sierra w/ Black Hawk motor
SWR Threshold Switch (SW5)
Most installations will operate in the NORMAL position.
However, if the TurboTuner-2 fails to tune on a certain band
(that is, SWR is never goes below 1.5:1), try the ALTERNATE
setting. In this mode, the TurboTuner-2 will complete the
tuning process when the lowest SWR is found.
Radio Mode (SW5)
Set to match the radio model you are using.
