Immediately after the ON/OFF button is released, information about a current setting of the
photocell is shown on a LED display for 5 seconds.
4.4.1.2 Photocell’s settings
•The setting of the photocell represents the photocell’s function:
0= start
1 - 8 = split times
9 = finish
•To see the current setting of the photocell, press the ON/OFF button (short press only). The
setting will be displayed for 3s.
4.4.1.3 Setup menu
Use a long press of the Setup button (button in the middle - ENTER) to activate Setup Menu of the
photocell.
Function of the buttons in the Setup Menu:
•Downwards/ Upwards arrows - to change values in the submenu
•ENTER - Short press - to browse in the menu
•ENTER - Long press - to close the setup menu and save all new settings
If you wish to save the new settings, make sure you long press ENTER button
If the setup menu is activated and no buttons were pressed for more than 30s, the setup menu will
be closed and the new settings will be lost.
If you are in the Setup Menu you have 3 options:
1. Change the setting of the photocell (start, split, finish) = GATE MODE
2. Setup the channel for communication (specific frequency) = CHANNEL MODE
3. Change country in which TSS is used (different frequency ranges used in different continents
due to different norms) = RF MODE
When you open the submenu, the LED light indicates a particular setting option.
1. GATE MODE - choose from 0 to 9 (0 = start, 1 - 8 = split times, 9 = finish)
