Televic Confidea Manual de instrucciones

confidea

Installation & User manual

Attention:

This manual for Wireless Confidea System 3.0 is

valid only for all

WCAP+ firmware version ≥1.06

WCAP fpga version ≥1.06

WDU+ firmware version ≥1.06

WCAP+ 71.98.0033

Cocon ≥3.02

General information

1Copyright Statement 4

2Trademarks 5

1Copyright Statement

No part of this publication or documentation accompanying this product may be reproduced

in any form or by any means or used to make any derivative such as translation, transformation,

or adaptation without the prior written permission of the publisher, except in case of brief

quotations embodied in critical articles or reviews. Contents are subject to change without prior

notice.

The authors of this manual have made every effort in the preparation of this book to ensure

the accuracy of the information. However, the information in this manual is supplied without

warranty, either express or implied. Neither the authors, Televic Conference NV, nor its dealers

or distributors will be held liable for any damages caused or alleged to be caused either directly

or indirectly by this book.

2Trademarks

All terms mentioned in this manual that are known to be trademarks or service marks have

been appropriately capitalized. Televic NV cannot attest to the accuracy of this information. Use

of a term in this book should not be regarded as affecting the validity of any trademark or service

mark.

3Contents

1Copyright Statement 4

2Trademarks 5

4How to connect 9

4.1 Power up 9

4.2 Accessing the web-browser 9

4.3 Login wizard 9

4.4 Introduction 9

First time access 9

4.5 Return to factory settings 12

5Web server 13

5.1 Compatibility 14

The webserver is compatible with various types of mobile and desktop devices 14

5.2 Navigating through the webserver 15

5.3 Changing IP address 16

5.4 Initialization 18

5.4.1 Controlled Access 18

5.5 Unit Manager 19

5.5.1 Define groups 20

5.5.2 Define delegate names and assign to group 20

5.5.3 Remove delegate 21

5.5.4 Visualize delegate names or numbers in unit manager 21

5.6 Unit monitoring 22

5.7 Activating microphones 22

5.7.1 Disconnected units 23

5.8 Conference options 23

5.8.1 Max active microphones 23

5.8.2 Microphone modes 23

5.8.3 Last microphone remains on 25

5.8.4 Microphone preset 25

5.8.5 Loudpseaker volume 26

5.9 AUX Control 26

2Trademarks

5.9.1 AUX In/out 26

5.9.2 General Aux settings - Audio routing 26

5.10 Regional settings 28

5.11 Security 28

5.12 Check firmware versions of delegate units 29

5.13 Check firmware versions of WCAP 30

5.14 Update 30

5.14.1 WCAP update 31

5.14.2 Update delegate units 33

6Frequency selection 34

6.1 Check already used frequencies by other Confidea G3 systems 34

6.2 Selecting own frequencies 34

6.3 The current used frequency 35

6.4 Frequencies used by other Confidea G3 systems 35

6.5 Other indications 35

6.5.1 Signal quality 35

6.5.2 Sorting frequencies 35

7Message screen 36

8Guidelines on optimal WCAP setup and configuration 37

8.1 Positioning the Confidea Wireless Access Point 37

8.2 Optimizing the position the antennas 38

8.3 Max range of WCAP 39

9Frequency Planning 39

9.1 Use with WiFi base stations nearby 39

9.2 Avoiding interference b.m.o. wifi collection points 40

10 Adding Cocon license to the WCAP 40

10.1 Introduction 40

10.2 Get the MAC address of your central equipment 40

10.3 Upload your license file 41

11 Appendix 42

11.1 Use of camera control feature 42

11.1.1 Overview 42

11.1.2 Connectivity 43

11.1.3 Commands for Confidea Gen III camera protocol 43

11.2 Floor and interpretation channels audio coupling between WCAP G3 and Plixus

Engine 44

11.2.1 General description 44

11.2.2 Connectivity 45

11.2.3 Restrictions : 45

4How to connect

4.1 Power up

After applying the 24V adapter to the power supply socket and switching the device on, the

first LED blinks white. This means the system is booting.

Note: If the LED does not switch to green after some minutes or it turns red, please contact

your support team.

4.2 Accessing the web-browser

To access the web-browser connect the LAN connector directly to your computer or to the

LAN network which includes your computer.

The default IP address is 192.168.1.110. Please make sure that your PC has an IP address

and subnet mask that can access that IP address.

4.3 Login wizard

When you enter the web-browser for the first time you will be guided through a small wizard

for initial setup of the system.

4.4 Introduction

The WCAP has a built-in web server that allows you to set/monitor certain parameters

characterizing the wireless conference system.

The following is a step-by-step guide to give you a general idea of how to access your WCAP.

First time access

STEP 1 –PC IP setup

In order to access the built-in web server for the first time, the TCP IP settings from the PC

or MAC must be modified. A fixed IP address has to be set. Therefore follow the instructions

below.

Note:

The WCAP has a default fixed IP address and subnet mask:

IP: 192.168.1.110

Subnet mask: 255.255.255.0

-Go to the ‘ Control Panel’

-Click on Network and sharing center

-Click on Change adapter settings

-Right-click on Local Area Connection

-Double on Properties

-Click on Internet Protocol (TCP/IP)

-Click Properties

Static IP address WINDOWS 7

-Input your IP Address and subnet mask the IP addresses

on the network must be within the same range.

-The default IP address from the WCAP is 192.168.1.110

so the computer should have an IP Address that is within

the same subnet, like 192.168.1.11 and 192.168.1.20. The

subnet mask must be the same for all equipment on the

network: 255.255.255.0)

-Click OK

Otros manuales para Confidea

Tabla de contenidos

Otros manuales de Sistema de conferencias de Televic

Televic

Televic D-CERNO Manual de usuario

Televic

Televic LINGUA IR Guía de solución de problemas

Televic

Televic Confidea Manual de usuario

Televic

Televic D-CERNO Manual de usuario

Televic

Televic Confidea Manual de usuario

Televic

Televic Plixus MME Manual de usuario

Televic

Televic Confidea G3 Guía de solución de problemas

Televic

Televic Confidea DD G3 Guía del usuario

Televic

Televic CONFIDEA FLEX G4 Guía de solución de problemas

Televic

Televic D-CERNO Manual de instrucciones

Televic

Televic D-CERNO Manual de usuario

Televic

Televic Confidea Manual de usuario

Televic

Televic Confidea G3 Manual de usuario

Televic

Televic TCS5500 Manual de usuario

Televic

Televic Confidea G3 Manual de usuario

Televic

Televic Plixus Series Manual de usuario

Manuales populares de Sistema de conferencias de otras marcas

Kramer

Kramer VIA GO Manual de usuario

AVT

AVT MAGIC AC1 Go Manual de usuario

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Manual de usuario

Sony

Sony PCS-I150 Manual de usuario

Middle Atlantic Products

Middle Atlantic Products VTC Series Manual de usuario

Prentke Romich Company

Prentke Romich Company Vanguard Plus Guía

Speakerbus

Speakerbus iD 712 Manual de usuario

Trelleborg

Trelleborg SafePilot CAT PRO Manual de usuario

Sennheiser

Sennheiser ADN Manual de usuario

ADTRAN

ADTRAN NetVanta 7100 Manual de usuario

AINA

AINA PTT Voice Responder Manual de usuario

Yamaha

Yamaha ProjectPhone PJP-100H Manual de usuario

vissonic

vissonic VLI Series Manual de usuario

Panasonic

Panasonic KX-VC500 Manual de usuario

Poly

Poly Trio 8300 Manual de usuario

Crestron

Crestron Mercury CCS-UCA-SMK Dibujo dimensional

Inmarsat

Inmarsat mini M Manual de usuario

Tenveo

Tenveo ALL-IN-ONE Manual de usuario