Telematics FP310RAM-X Manual de usuario

PROPRIETARY INFORMATION

ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED, STORD IN

RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC,

MECHANICAL PHOTOCOPYING, RECORDING OR OTHERWISE WITHOUT THE PRIOR WRITTEN

PERMISSION OF TELEMATICS WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY

PURPOSE OR FOR ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.

NAME: FP310RAM-X

User Manual

DESIGNED

M.N.

March 2009

SHEET/OF

CHECKED

G.F.K

March 2009

APPROVED

A.S.

March 2009

Q.A.

A.S.

March 2009

PROD/PROJ: FP310RAM-X ASTM Mini Reader

SIZE

REV.



DESCRIPTION

E.C.N.

DATE

DRAWN

CHECKED

PROPRIETARY

Note:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may

cause undesired operation.

WARNING! Changes or modifications to this unit not expressly approved by Telematics

Wireless Ltd. could void the user's authority to operate the equipment.

The digital portion of the transceiver has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by the

following measure:

-Increase the separation between the equipment and receiver.

The antenna and therefore the unit, used for this transmitter must be installed to normally provide

minimum separation distance of at least 2 meters from all persons and must not be co-located or

operating in conjunction with any other antenna or transmitter.

Table of Contents

PROPRIETARY

FP310RAM-X

Mini Reader

User Manual

Version 1.1

Telematics Wireless Ltd.

26 Hamelacha St., POB 1911

Holon, 58117

Israel

Phone: +(972)3-5575717

Fax: +(972)3-5575713 March 2010

This document contains proprietary information, which is the sole

property of Telematics-Wireless. The document is submitted to the

recipient for his use only. By receiving this document the recipient

undertakes not to duplicate or to disclose in part of, or the whole of, any

of the information contained herein to any third party without receiving

before hand, written permission from the submitting company.

Table of Contents

PROPRIETARY

iii

Table of Contents Page

Chapter 1...................................................................................................................... 1-1-2

Introduction.................................................................................................................. 1-1-2

1-1. Scope .............................................................................................................1-1-2

1-2. General Description.......................................................................................1-1-3

1-2.1 Purpose and Use ...............................................................................1-1-3

1-2.2 Main Technical Characteristics ........................................................1-1-3

1-2.3 Host Utility .......................................................................................1-1-3

1-2.4 Additional Equipment Needed..........................................................1-1-3

1-2.5 FP310RAM-X vs. FP300RA............................................................1-1-4

1-3. Physical Description......................................................................................1-1-4

1-4. Functional Description ..................................................................................1-1-5

1-4.1 Normal Mode....................................................................................1-1-5

1-4.2 Mute Mode........................................................................................1-1-5

1-4.3 Maintenance Mode ...........................................................................1-1-5

1-4.4 Host Communication........................................................................1-1-5

Chapter 2...................................................................................................................... 2-2-1

Installation ................................................................................................................... 2-2-1

2-1. General...........................................................................................................2-2-1

2-2. Installation Requirements..............................................................................2-2-1

2-2.1 Integration in Systems ......................................................................2-2-1

2-2.2 Safety Considerations .......................................................................2-2-1

2-2.3 Mechanical Data...............................................................................2-2-2

2-3. Installation Guidelines...................................................................................2-2-2

2-3.1 Power Requirements.........................................................................2-2-2

2-3.2 Antenna.............................................................................................2-2-2

2-3.3 Communication Cables.....................................................................2-2-3

2-3.4 Grounding and Lightning Protection Requirements.........................2-2-3

2-4. Installation Procedure....................................................................................2-2-3

2-4.1 Tools and Materials ..........................................................................2-2-3

2-4.2 Preparation for Installation ...............................................................2-2-3

2-4.3 FP310RAM-X Installation Procedure ..............................................2-2-4

Chapter 3...................................................................................................................... 3-3-1

Operation ..................................................................................................................... 3-3-1

3-1. Scope .............................................................................................................3-3-1

3-2. Power-Up.......................................................................................................3-3-1

Appendix A.................................................................................................................. A-1

Connection Data .......................................................................................................... A-1

A-1. Antenna Connector..........................................................................................A-1

A-2. Power Input Connector....................................................................................A-1

A-3. Host Interface Connector.................................................................................A-1

A-4. I/O Connector ..................................................................................................A-1

Table of Contents

PROPRIETARY

List of Illustrations

Figure 1-1. FP310RAM-X, General View .......................................................................................1-1-3

Figure 1-2. FP310RAM-X, Host Side Panel....................................................................................1-1-4

Figure 1-3. FP310RAM-X, Antenna Side Panel..............................................................................1-1-4

Figure 2-1. FP-310RA Connections.................................................................................................2-2-1

Figure 2-2. FP310RAM-X Mechanical Data ...................................................................................2-2-2

List of Tables

Table 1-1. FP-310RA Connectors, Indicators and Controls.............................................................1-1-5

Table A-1. DC IN Connector, Pin Functions ......................................................................................A-1

Table A-2. HOST Connector, Pin Functions for RS-232 Interface.....................................................A-1

Table A-3. I/O Connector....................................................................................................................A-1

PROPRIETARY

1-1

Chapter 1

INTRODUCTION

Contents