RD000519Rev A AC-211N
To select aspecificprovider, enter his access name in the AC name field.
6) Click Save PPPoESettings.
7) After entering and saving all configurations, you must reset the Gateway. In the
verticalmenu bar of the current page, select Reset.The Reset page appears.
8) Select Power on reset and click the Reset button. The Gateway power cycles and
the application homepage openswith thenewconfiguration settings.
For more information see section “Enabling Point-to-Point Protocol over Ethernet
(PPPoE)” in the Access 211N VoIPGateway(AC-211N) User Guide.
9b. If you are using a cable modem, note that some cable modems need to be power cycled
after being connected to the Gateway. For such modems you can also power cycle the
Access 211N Gateway forfaster connection.
10. Wait for therespective Phone (Voice) LED (Phone1for PH1 port/Phone2 forPH2 port)
on the front ifthe gateway to glow, indicating you are connectedto your VoIP service
providers. It may takeaminute ortwo for these connectionsto be established.
11 Verify that youhave Internet access.
12. Pick up the phone on each line to verify that you can hearthe dial tone.
Oncethe installation is complete, you can use your Access 211N Gateway for telephone calls and
for the Internet, assuming that you have a connection supplied by your VoIP provider.
Toinstall your Access 211NVoIP Gatewaywitha home network:
1. Unpack the Access 211N Gateway unit.
Placethe Gateway on a desktop or other levelsurface, or mount it on a wall. Choose a
location that is near the devicesto be connected and close to an electricaloutlet.
2. Connect the WAN port on the Gateway’s rear panel to the Ethernet socket on your
broadband modem with the Ethernet 10/100BaseTX (RJ-45) cable that was provided
with your modem.
3. Connect the LAN port on the Gateway’s rear panel to an open Ethernet WAN port on
your router/switch with a supplied Ethernet 10/100BaseTX (RJ-45) cable, in accordance
