i) To learn wireless signals from LA5597 IR transmitter to LA5592 Home Automation
Controller
1.Signal A : Press the LEARN button 3 times, the LED
becomes Red and flashing indicating learn mode for
signal A.
2. Signal B. Press the LEARN button 4 times, the LED
becomes Green and flashing indicating learn mode
for signal B.
Note:
1. To complete the whole learning process of a signal once a time..
2. If no operation on the button within 15 seconds system will exit learn mode automatically.
ii. Trigger control panel of home automation system, flashing LED light off indicate
control panel A signal had been learnt and exit to normal mode.
Operating Home Automation Controller as follow:
·Pressing [SET] key Controller will transmit learn data to output device
·To enable the output device of controller after learn data successfully.
Then press [SET] go into Enable Work function.
·Display current Enable status
·Rotate [SET] to select ON and press [SET] key to accept,
it will enable Output Device 1 work
Note: Set Enable Work to be OFF, Controller will not action the
output device.
·System generate an have OK tone, it will exit and go
into next Output Device setting.
Enable Work
