
MediaGateway User Manual
3.7.6.3 Structure of Payload from the UDP or RAW ethernet frame.............74
4Configuration Examples..........................................................................................76
4.1 Logging communication between two DUTs ..................................................76
4.2 Get access by third communication partner ...................................................79
5PTP AND 802.1AS in the MediaGateway ...............................................................81
5.1 Protocol .............................................................................................................81
5.2 Transport of time-synchronization information ..............................................81
5.3 Propagation delay measurement.....................................................................83
5.4 802.1AS in the MediaGateway .........................................................................84
5.5 Limitations in MediaGateway using 802.1AS..................................................84
6Diagnostic Frames ..................................................................................................85
6.1 Board Configuration Frame (0x8001) ..............................................................85
6.2 Port Information Frame (0x8002) ....................................................................89
7MediaGateway Remote Control..............................................................................91
7.1 Reset Device......................................................................................................92
7.2 Import Configuration.........................................................................................92
7.3 Export Configuration.........................................................................................93
7.4 Dynamic Configuration .....................................................................................93
7.5 Check Status .....................................................................................................94
7.6 Set WakeUp Line Status ...................................................................................94
7.7 Get WakeUp Line Status ...................................................................................95
7.8 Set Port Enabled/Disabled (only 100BASE-T1-Ports) .....................................95
7.9 Set Port to Master/Slave (only 100BASE-T1-Ports)........................................96
7.10 Reset to default .............................................................................................97
7.11 Get System Information ................................................................................97
8APPLICATION AND FIRMWARE UPDATE ..............................................................99
8.1 Preconditions and important information .......................................................99
8.2 Update .............................................................................................................100
9TROUBLESHOOTING AND FAQ ............................................................................101
9.1 All 100BASE-T1 LEDs are lit permanently......................................................101
9.2 Four 100BASE-T1 LEDs of one Switch are lit permanently...........................101