Tech Controllers ST-19 Manual de usuario

fwybór

TABEL OF CONTENTS

Safety............................................................................................................................................................3

Description....................................................................................................................................................4

Installation....................................................................................................................................................4

How to configure parameters......................................................................................................................6

Technical data ...............................................................................................................................................6

SAFETY

Before using the device for the first time the user should read the following regulations carefully.

Not obeying the rules included in this manual may lead to personal injuries or controller damage. The user’s

manual should be stored in a safe place for further reference. In order to avoid accidents and errors it should

be ensured that every person using the device has familiarized themselves with the principle of operation as

well as security functions of the controller. If the device is to be sold or put in a different place, make sure that

the user’s manual is there with the device so that any potential user has access to essential information about

the device.

The manufacturer does not accept responsibility for any injuries or damage resulting from negligence;

therefore, users are obliged to take the necessary safety measures listed in this manual to protect their lives

and property.

WARNING

•High voltage! Make sure the regulator is disconnected from the mains before performing any

activities involving the power supply (plugging cables, installing the device etc.)

•The device should be installed by a qualified electrician.

•Before starting the controller, the user shoud measure earthing resistance of the electric

motors as well as the insulation resistance of the cables.

•The regulator should not be operated by children.

WARNING

•The device may be damaged if struck by a lightning. Make sure the plug is disconnected from

the power supply during storm.

•Any use other than specified by the manufacturer is forbidden.

•Before and during the heating season, the controller should be checked for condition of its

cables. The user should also check if the controller is properly mounted and clean it if dusty or

dirty.

Changes in the merchandise described in the manual may have been introduced subsequent to its completion

on September 25th 2016. The manufacturer retains the right to introduce changes to the structure. The

illustrations may include additional equipment. Print technology may result in differences in colors shown.

We are committed to protecting the environment. Manufacturing electronic devices

imposes an obligation of providing for environmentally safe disposal of used electronic

components and devices. Hence, we have been entered into a register kept by the

Inspection For Environmental Protection. The crossed-out bin symbol on a product

means that the product may not be disposed of to household waste containers.

Recycling of wastes helps to protect the environment. The user is obliged to transfer

their used equipment to a collection point where all electric and electronic components

will be recycled.

DESCRIPTION

ST-19 antistop is intended for controlling the central heating pump (CH). The pre-set temperature is defined

sing a potentiometer. The main task of the controller is to activate the pump when the pre-set temperature

value is reached and deactivate it when the CH boiler temperature drops by 20 C below the pre-set value. Such

characteristics prevent unnecessary pump operation, which saves electricity, extends the life of the pump and

enhances its reliability. ST-19 controller also has an additional feature –ANTI-STOP, which prevents CH pump

stagnation outside the heating season ( the pump is activated every 10 days for 1 minute).

Controller functions:

•controlling CH pump

•anti-stop

Controller equipment:

•CH temperature sensor

•potentiometer for setting the desired temperature

INSTALLATION

The controller should be installed by a qualified person.

WARNING

Risk of fatal electric shock from touching live connections. Before working on the controller switch

off the power supply and prevent it from being accidentally switched on.

CH temperature

sensor

CH pump

Power supply

The sensor should be installed on the CH boiler output with the use of a cable tie and protected from the

influence of external factors with the use of an insulating tape (it cannot be dipped in any liquid).

The pump power cord should be connected in the following way: blue and brown:230V, yellow-green

(protective) should be earthed.

The distance between the mounting holes is 110mm.

1. Potentiometer

2. Power supply switch

3. Fuse 1,6A

4. Power cord

5. CH pump output

6. Temperature sensor

7. Manual operation switch

8. Control light indicating manual operation

9. Control light indicating power supply

10. Control light indicating pump operation

ST-19 antystop is intended for controlling the central heating pump (CH). The main task of the controller is to

activate the pump when the pre-set temperature value is exceeded and deactivate it when the CH boiler

cools down (due to damping). Such characteristics prevent unnecessary pump operation, which saves

electricity (up to 60% depending on the CH boiler use), extends the life of the pump. It also enhances its

reliability and reduces the maintenance costs.

ST-19 controller offers anti-stop function which prevents CH pump stagnation. The pump is activated every

10 days for 1 minute. Additionally, every hour the time data is saved in non-volatile memory (EEPROM),

which ensures that the timing is continued even in the event of voltage failure.

HOW TO CONFIGURE PARAMETERS

Pump activation temperature is adjusted using the potentiometer within the range of 25⁰C -

85⁰C. The pump is disabled when the actual temperature drops by 2⁰C below the pre-set value

(set up using the potentiometer). It prevents periodical pump switching due to slight temperature fluctuation

as it would have a negative impact on the life of the pump.

Apart from the potentiometer, the regulator also has two switches - one for activating the device (indicated

by the power supply light) and the other for manual pump activation ( indicated by the manual operation light).

TECHNICAL DATA

Specification

Unit

Power supply

230 +/-10% /50Hz

Power consumption

Ambient temperature

0 ÷ 50

Circulating pump output load

Range of temperature settings

25 ÷ 85

Accuracy of measurement

Thermal resistance of the sensor

-25 ÷ 90

Sensor cord length

1,5

The regulator has a WT 1,6A tube fuse-link protection.

Hereby, we declare under our sole responsibility that ST-550zPID room regulator

manufactured by TECH, headquartered in Wieprz, Biała Droga 31, 34-122 Wieprz, is

compliant with:

•Directive 2014/35/EU of the European Parliament and of the Council of February

26, 2014 on the harmonisation of the laws of Member States relating to the making

available on the market of electrical equipment designed for use within certain

voltage limits (EU Journal of Laws L 96, of 29.03.2014, p. 357),

•Directive 2014/30/EU of the European Parliament and of the Council of February

26, 2014 on the harmonisation of the laws of Member States relating to

electromagnetic compatibility (EU Journal of Laws L 96 of 29.03.2014, p.79),

•Directive 2009/125/EC establishing a framework for the setting of ecodesign

requirements for energy-related products,

•the regulation by the Ministry of Economy of May 8, 2013 concerning the essential

requirements as regards the restriction of the use of certain hazardous substances

in electrical and electronic equipment, implementing provisions of RoHS directive

2011/65/EU.

For compliance assessment, harmonized standards were used:

PN-EN 60730-2-9:2011, PN-EN 60730-1:2012.

Wieprz, 14. 09. 2016

Tabla de contenidos

Otros manuales de Controladores de Tech Controllers

Tech Controllers

Tech Controllers EU-R-12s Manual de usuario

Tech Controllers

Tech Controllers EU-i-2 Manual de usuario

Tech Controllers

Tech Controllers EU-ML-12 Manual de usuario

Tech Controllers

Tech Controllers EU-880 zPlD Manual de usuario

Tech Controllers

Tech Controllers EU-391 zPID Manual de usuario

Tech Controllers

Tech Controllers EU-L-9r Manual de usuario

Tech Controllers

Tech Controllers ST-979 Manual de usuario

Tech Controllers

Tech Controllers EU-WiFi 8S p Manual de usuario

Tech Controllers

Tech Controllers EU-i-2 Plus OT Manual de usuario

Tech Controllers

Tech Controllers EU-T-3.2 Manual de usuario

Tech Controllers

Tech Controllers EU-WiFi OT Manual de usuario

Tech Controllers

Tech Controllers EU-19 Manual de usuario

Tech Controllers

Tech Controllers EU-R-10S PLUS Manual de usuario

Tech Controllers

Tech Controllers EU-294 v2 Manual de usuario

Tech Controllers

Tech Controllers EU-F-2z v2 Manual de usuario

Tech Controllers

Tech Controllers EU-294v1 Manual de usuario

Tech Controllers

Tech Controllers EU-53.3 Manual de usuario

Tech Controllers

Tech Controllers EU-i-3 Plus OT Manual de usuario

Tech Controllers

Tech Controllers EU-MW-1 Manual de usuario

Tech Controllers

Tech Controllers EU-48 Manual de usuario

Tech Controllers

Tech Controllers ST-976 Manual de usuario

Tech Controllers

Tech Controllers EU-24 SIGMA Manual de usuario

Tech Controllers

Tech Controllers L-7 Manual de usuario

Tech Controllers

Tech Controllers EU-27i Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario