TBS CROSSFIRE Nano RX Manual de usuario
Quick-Start Guide - TBS CROSSFIRE Nano RX Revision 2018-02-16
The CROSSFIRE Nano RX has much of the same feature set as the TBS CROSSFIRE Micro RX but on a
smaller form factor and without connectors.
The small size allows you to save space and weight, while still retaining the key features that make the
CROSSFIRE system flexible and reliable.
Key features:
●Same feature set like regular CROSSFIRE Micro receiver (SBUS, PPM, PWM, CRSF, SmartAudio,
MAVLInk, Serial Bridge)
●Telemetry support
●Full range receiver
●5V voltage input
●2.54mm pitch front connector and 2mm pitch side connector
●Compact, only 11 x 18 mm
Note:
*** Firmware 2.24 or newer required! ***
1
Wiring receiver
The receiver does not come with any connectors on-board, this is with intention to allow for flexible and
more varied setups, i.e. it is easier to add a connector than to remove a pre-soldered one.
Use normal servo-wires to either connect directly to the soldering pads/vias or use pin header to mount it
to a motherboard. The antenna uses a U.FL connector. Use heat-shrink tubing to protect the receiver.
Binding
Binding the transmitter and receiver is super simple.
1. Just power up the TBS CROSSFIRE transmitter
2. On the standard transmitter, enter the configuration menu by pressing and holding the joystick for
3 seconds, select “General” and “Binding” - a message “Binding” will start blinking, waiting for the
receiver. On the micro transmitter, a short press on the button will initiate binding mode.
3. Now, power up the receiver (without pressing the Bind button!), if your receiver has not been
previously bound, it will automatically bind. Otherwise, press and release the “BIND” button on the
receiver to initiate binding. On the receiver is a timeout of one minute for after power up to enter
bind mode. If the status LED will start blinking slowly the receiver has switched successfully to bind
mode.
4. Within a few seconds the process will finish with a “Binding complete” message on the standard
transmitter, or a solid green LED on the micro transmitter. The receiver has now stored the unique
serial number of that particular CROSSFIRE transmitter. If it doesn’t bind, please verify that your
firmware is to the newest version on both the receiver and the transmitter.
2
BST
The TBS CROSSFIRE Micro RX come with a fully featured BST port. To connect it to other devices like TBS
CORE PRO, FPVision layer, GPS or other TBS peripherals a custom cable needs to be made. BST connector
usually have 5 pin. Out of the 5 pins only SDA, SCL and GND has to be connected. Best practise is to use a
BST cable, cut the connector on one and and cut the unused wires on the other connector. Then solder the
required wires accordingly.
BST cable pinout:
Manual written and designed by ivc.no in cooperation with TBS.
3
Tabla de contenidos
Otros manuales de Receptor de TBS CROSSFIRE
