so that the former
rotates. In order to apply the ratchet function, hold the socket of the
ratchet wrench and move the handle forward and backward.
Once there is resistance, replace the left hand on the guide pin as shown
in the picture below.
※Do not touch the moving part during operation .
4. Check the angle by the check window and when it reaches the target angle,
stop the operation and shift the selector bar of the ratchet wrench. Then,
move the ratchet handle forward and backward so that the former rotates in
the opposite direction.
※Bending angle is only a guide. Depending on the copper tube, the spring
back (the force to go backwards) will occur.
※Note to take care of the rebound of the copper tube.
5. After the copper tube is released from the fixing, remove the guide pin
from the guide and remove the copper tube from the former.
SOCKET
